Analysis of lamination measurements for CERN's twin aperture quadrupoles

The European Organization for Nuclear Research (CERN) is constructing the Large Hadron Collider (LHC). The LHC's cleaning insertions require 48 twin aperture resistive quadrupoles. The laminations for these magnets are punched from low carbon steel sheet 1.5 mm thick. To check the quality of th...

Descripción completa

Detalles Bibliográficos
Autor principal: Clark, G S
Lenguaje:eng
Publicado: 2002
Materias:
Engineering
Acceso en línea:https://dx.doi.org/10.1109/TASC.2002.1018740
http://cds.cern.ch/record/590864
Descripción
Sumario:The European Organization for Nuclear Research (CERN) is constructing the Large Hadron Collider (LHC). The LHC's cleaning insertions require 48 twin aperture resistive quadrupoles. The laminations for these magnets are punched from low carbon steel sheet 1.5 mm thick. To check the quality of the laminations, samples are regularly collected and measured. This paper describes how these measurements are analyzed. This work is part of the Canadian contribution to the LHC. (5 refs).

Ejemplares similares