Cargando…

Design and production of the MQM and MQY cold masses

Detalles Bibliográficos
Autor principal:	Lucas, J
Lenguaje:	eng
Publicado:	2003
Materias:	Accelerators and Storage Rings
Acceso en línea:	http://cds.cern.ch/record/643912

Ejemplares similares

1% calibration errors in MQY magnets
por: Bach, T, et al.
Publicado: (2013)

Construction and Qualification of the Pre-Series MQM Superconducting Quadrupoles for the LHC Insertions
por: Ostojic, R, et al.
Publicado: (2004)

Electromagnetic design of the MQM quadrupole
por: Lucas, J
Publicado: (1999)

Proposal for the award of a contract for the supply of superconducting cables for the LHC low-current insertion (mqm) and wide-aperture insertion (mqy) quadrupoles
Publicado: (1999)

A prototype MQM quadrupole magnet for the LHC
por: Laurent Guiraud
Publicado: (2000)

The collared coil of a prototype MQM magnet for the LHC
por: Laurent Guiraud
Publicado: (2000)

Design of the CEBAF Energy Upgrade Cryomodule Cold Mass
por: Hogan, J, et al.
Publicado: (2001)

Industrialization of LHC main quadrupole cold masses up to series production
por: Burgmer, R, et al.
Publicado: (2004)

Focusing on quandrupoles: Production status and plan of MQ cold mass farbication
por: Schirm, K M
Publicado: (2003)

Cold mass geometric measurements
por: Bajko, M
Publicado: (2001)

Supporting System for the LHC Cold Mass
por: Mathieu, M, et al.
Publicado: (1997)

Metrology of the LHC Dipole Cold Masses
por: Bajkó, M, et al.
Publicado: (2002)

The Design of Cold to Warm Transitions of the LHC
por: Knaster, J R, et al.
Publicado: (2004)

The LHC Pre-series Dipole Cold Mass Geometry
por: Bajko, M, et al.
Publicado: (2004)

Status of the Cold Mass of the Short Straight Section for the LHC
por: Rifflet, J M, et al.
Publicado: (1998)

Design of the Re-entrant Cold BPM
por: Luong, M, et al.
Publicado: (2005)

Design and Cold Model Test of KOMAC CCDTL
por: Cho, Y S, et al.
Publicado: (1999)

Design of a Cold Vacuum Chamber for Diagnostics
por: Casalbuoni, S, et al.
Publicado: (2008)

Study of Short Straight Section Cold Mass Assembly Principles
por: Gagné, M, et al.
Publicado: (1996)

Cold Test Wires for ILC Spoiler Design
por: Beard, C D
Publicado: (2006)

Control of the Dipole Cold Mass Geometry at CERN to Optimize LHC Performance
por: Wildner, E, et al.
Publicado: (2006)

Hydraulic Validation of the LHC Cold Mass Heat Exchanger Tube
por: Provenaz, P
Publicado: (1998)

Design study of a cold magnet synchrotron (CMS)
por: Van Steenbergen, A
Publicado: (1970)

Optical In-Situ Measurement of Relative Deformations of the LHC Main Dipole Cold Masses
por: Aznar, S, et al.
Publicado: (2002)

Influence of geometrical parameters on the flexural rigidity of the LHC dipole cold mass assembly
por: Bajko, M, et al.
Publicado: (2002)

Fabrication of the Fermilab Pre-Series Cold Mass for the HL-LHC Accelerator Upgrade Project
por: Vouris, A, et al.
Publicado: (2023)

Proposal for the award of a contract for the supply of the MQY-type superconducting quadrupole magnets for the LHC insertions
Publicado: (2000)

An Overview of the Design and Manufacturing of the Cold Masses of the LHC Arc Quadrupoles
por: Tortschanoff, Theodor
Publicado: (2008)

Construction of the New Prototype of Main Quadrupole Cold Masses for the Arc Short Straight Sections of LHC
por: Peyrot, M, et al.
Publicado: (2000)

Cold antimatter plasmas, and aspirations for cold antihydrogen
por: Gabrielse, G, et al.
Publicado: (2002)

Adaption of the LHC cold mass cooling system to the requirements of the Future Circular Collider (FCC)
por: Kotnig, C, et al.
Publicado: (2017)

Quality Control of the LHC Main Dipole Cold Mass through Magnetic Measurements at Room Temperature
por: Todesco, Ezio, et al.
Publicado: (2003)

A Simplified Structural Model for the Analysis of Shape Deformations of the LHC Superconducting Dipole Cold Mass
por: La China, M, et al.
Publicado: (2006)

Proposal to negotiate an amendment to an existing contract for the supply of MQY-type superconducting quadrupole magnets for the LHC insertions
Publicado: (2005)

Technical specification for the supply of 1158 cold masses of the superconductig dipole magnets for the LHC collider, 1 pt.
por: CERN. Geneva. LHC Project
Publicado: (2001)

Technical specification for the supply of 1158 cold masses of the superconductig dipole magnets for the LHC collider, 2 pt.
por: CERN. Geneva. LHC Project
Publicado: (2001)

Stacking of cold antiprotons
por: Gabrielse, G, et al.
Publicado: (2002)

Progress with cold antihydrogen
por: Charlton, M, et al.
Publicado: (2006)

Status of the LHC Superconducting Cable Mass Production
por: Adam, J D, et al.
Publicado: (2002)

Cold/sticky systems
por: Baglin, V
Publicado: (2007)

Cannot write session to /tmp/vufind_sessions/sess_io1iga19jag2buga0ide4reqni