Cargando…
Studies of the optics response of Steel-plastic scintillator calorimeters for the ATLAS detector and checks of lights sources for their quality control
During 1998 a full scale prototype module equipped almost as in the final ATLAS design, has been constructed and tested. The light yield of this prototype as well as for previous prototypes built in 1996 and 1997 showed some small irregularities that were not understood. A TILECAL prototype was buil...
Autor principal: | Blanch, O |
---|---|
Lenguaje: | eng |
Publicado: |
1999
|
Materias: | |
Acceso en línea: | http://cds.cern.ch/record/683968 |
Ejemplares similares
-
Calibration and Light Yield measurements of Steel-plastic scintillator calorimeters for he ATLAS detector.
por: Bravo, S
Publicado: (1998) -
Radiation hardness of plastic scintillators for the Tile Calorimeter of the ATLAS detector
por: Jivan, H, et al.
Publicado: (2015) -
Radiation hardness of plastic scintillators for the Tile Calorimeter of the ATLAS detector
por: Jivan, H, et al.
Publicado: (2015) -
Neutron induced radiation damage of plastic scintillators for the upgrade of the Tile Calorimeter of the ATLAS detector.
por: Mdhluli, J E, et al.
Publicado: (2017) -
A comparative study of the radiation hardness of plastic scintillators for the upgrade of the Tile Calorimeter of the ATLAS detector
por: Liao, S, et al.
Publicado: (2015)