Cargando…

Wiring of tubes for full scale BIL chamber prototype

Detalles Bibliográficos
Autores principales:	Borisov, A, Borisov, E, Goryachev, V N, Fakhroutdinov, R, Kojine, A, Rybachenko, V, Startsev, V, Vovenko, A
Lenguaje:	eng
Publicado:	1997
Materias:	Detectors and Experimental Techniques
Acceso en línea:	http://cds.cern.ch/record/684015

Ejemplares similares

BIL chamber prototype assembly in Protvino. Tools, procedure and some test results
por: Borisov, A, et al.
Publicado: (1997)

Simple control system of relative combs position on drift tube chamber assembling table
por: Borisov, A, et al.
Publicado: (1998)

X-Ray Tomography. Test of New Setup and measurement of 4x8 Drift Tube Prototype
por: Borisov, A, et al.
Publicado: (1996)

Drift time and gas quality contrl in drift tubes by using secondary electron emission effect
por: Borisov, A, et al.
Publicado: (1996)

The First Full-Scale Prototype of a BIL MDT Chamber for the ATLAS Muon Spectrometer
por: Biscossa, A, et al.
Publicado: (1997)

Test of Jet-cell Drift Chamber Inside the Round Tube with 6 meters Long Wires Without Intermediate Supports
por: Bozhko, NI, et al.
Publicado: (1993)

Performance and some characteristics of MDT chambers constructed in IHEP (Protvino) for ATLAS
por: Bozhko, N, et al.
Publicado: (2004)

IHEP drift tube prototype for ATLAS
por: Antipov, Yu M, et al.
Publicado: (1996)

Development of drift tubes for the ATLAS muon spectrometer
por: Borisov, A, et al.
Publicado: (1999)

Measurement of coordinate along sense wire in jet-cell drift chamber
por: Bozhko, NI, et al.
Publicado: (1994)

X-Ray Tomography of thin wires. Part 1 Passive mode.
por: Borisov, A, et al.
Publicado: (1994)

X-Ray test of drift tubes
por: Borisov, A, et al.
Publicado: (1995)

Mechanical and thermal tests on the BIL MDT chamber prototype "Calypso"
por: Daly, C, et al.
Publicado: (1997)

BIL Chamber Tests in Roma Tre
por: Baroncelli, A, et al.
Publicado: (2003)

Construction of monitored drift tube chambers for ATLAS end-cap muon spectrometer at IHEP (Protvino)
por: Bensinger, J, et al.
Publicado: (2002)

Performance of BIL tracking chambers for the ATLAS muon spectrometer
por: Tonazzo, A, et al.
Publicado: (2006)

Measurement of proportional counter gas gain
por: Borisov, A, et al.
Publicado: (2000)

Construction of the Full-Scale Prototype of a BOS MDT Chamber
por: Bartheld, V, et al.
Publicado: (1998)

Assembly and test of the BIL tracking chambers for the ATLAS Muon spectrometer
por: Petrucci, F, et al.
Publicado: (2006)

The OPAL jet chamber full scale prototype
por: Fischer, H M, et al.
Publicado: (1986)

Test of the first BIL tracking chamber for the ATLAS muon spectrometer
por: Avolio, G, et al.
Publicado: (2004)

Results of wire vibration test for 6 meters long drift tube
por: Borisov, A, et al.
Publicado: (1995)

Preliminary Results of Lorentz Angle Measurements
por: Bozhko, NI, et al.
Publicado: (1993)

Experimental Study and Finite Element Analysis of the Heat Diffusion Problem for ATLAS MDT Chamber
por: Baliev, L, et al.
Publicado: (1996)

The first full-scale prototype of BOS MDT chamber for the ATLAS
por: Vanosov, A
Publicado: (1997)

ATLAS monitored drift tube assembly and test at IHEP (Protvino)
por: Borisov, A, et al.
Publicado: (2002)

Creep test results for 50mum diameter wires made of tungsten and tungsten + rhenium alloy
por: Borisov, A, et al.
Publicado: (1997)

Wire chambers (Iarocci tubes) for NUSEX
Publicado: (1981)

Construction and test of a full-scale prototype of an ATLAS muon spectrometer tracking chamber
por: Biscossa, A, et al.
Publicado: (1998)

Test of Wire and Wall Position for a Single Drift Tube by Means of X-Ray
por: Borisov, A, et al.
Publicado: (1996)

Charge dependent corrections to the time reponse of BIL chambers at the Roma Tre cosmic test site
por: Baroncelli, A, et al.
Publicado: (2003)

Results from the full-length prototype of the KLOE drift chamber
por: Andryakov, A D, et al.
Publicado: (1998)

Measurement of torque applied to the end plug central brass pin due to gas jumper
por: Borisov, A, et al.
Publicado: (1998)

Study of temperature and gas composition effects in rt relations of ATLAS MDT BIL Chambers
por: Baroncelli, Antonio, et al.
Publicado: (2004)

MDT chamber assembly procedure and construction of a full scale BML
por: Benvenuto, P, et al.
Publicado: (1997)

Prototype of wire chamber detector
por: CERN PhotoLab
Publicado: (1964)

EOL3 M0 X-ray Tomography Test Results
por: Avramidou, R, et al.
Publicado: (2001)

Length and Straightness of the Tubes for the BOS Prototype Chamber
por: Lagouri, T
Publicado: (1998)

Test results of long (7.4m) drift tube with four field-shaping wires
por: Borisov, A, et al.
Publicado: (1994)

P3: the full-scale prototype of the ME1/1 CSC
por: Erchov, Yu V, et al.
Publicado: (1999)

Cannot write session to /tmp/vufind_sessions/sess_bq2eml2k4hj26p2sg0f73c8jkn