Cargando…

Hydraulic Validation of the LHC Cold Mass Heat Exchanger Tube

The knowledge of the helium mass flow vs. the fraction of the tube wetted by the liquid helium II in the heat exchanger is a crucial input parameter for the heat exchange since the heat flux is direct ly proportional to the wetted surface. In the range of liquid and gas velocities inside the heat ex...

Descripción completa

Detalles Bibliográficos
Autor principal:	Provenaz, P
Lenguaje:	eng
Publicado:	1998
Materias:	Accelerators and Storage Rings
Acceso en línea:	http://cds.cern.ch/record/692085

Ejemplares similares

Thermal Characterization of the HeII LHC Heat Exchanger Tube
por: Camacho, D, et al.
Publicado: (1998)

Design and Fabrication of Superfluid Heat Exchanger Tubes for the LHC Superconducting Magnets
por: Bertinelli, F, et al.
Publicado: (2004)

Operation, Testing and Long Term Behaviour of the LHC Test String Cryogenic System
por: Casas-Cubillos, J, et al.
Publicado: (1998)

Supporting System for the LHC Cold Mass
por: Mathieu, M, et al.
Publicado: (1997)

Metrology of the LHC Dipole Cold Masses
por: Bajkó, M, et al.
Publicado: (2002)

Status of the Cold Mass of the Short Straight Section for the LHC
por: Rifflet, J M, et al.
Publicado: (1998)

A Cryogenic Test Station for Subcooling Helium Heat Exchangers for LHC
por: Roussel, P, et al.
Publicado: (2000)

Technical specification for the supply of cold bore tubes for LHC dipole magnet prototypes
por: Main Magnets and Superconductors Group (LHC-MMS)
Publicado: (1998)

The LHC Pre-series Dipole Cold Mass Geometry
por: Bajko, M, et al.
Publicado: (2004)

Thermal conductance measurements on the LHC helium II heat exchanger pipes
por: Kado, M
Publicado: (1995)

He II Heat Exchanger Test Unit for the LHC Inner Triplet
por: Blanco-Viñuela, E, et al.
Publicado: (2001)

Thermo-hydraulic Quench Propagation at the LHC Superconducting Magnet String
por: Rodríguez-Mateos, F, et al.
Publicado: (1998)

Industrialization of LHC main quadrupole cold masses up to series production
por: Burgmer, R, et al.
Publicado: (2004)

Measurement of the thermo hydraulic behaviour of LHC dipole prototypes after quench
por: Gerin, G, et al.
Publicado: (1995)

Copper Heat Exchanger for the External Auxiliary Bus-Bars Routing Line in the LHC Insertion Regions
por: Garion, C, et al.
Publicado: (2006)

Superfluid Helium cooling and compact Heat Exchanger for HL-LHC D2 Recombination Dipoles
por: Rousset, B, et al.
Publicado: (2019)

Optical In-Situ Measurement of Relative Deformations of the LHC Main Dipole Cold Masses
por: Aznar, S, et al.
Publicado: (2002)

Control of the Dipole Cold Mass Geometry at CERN to Optimize LHC Performance
por: Wildner, E, et al.
Publicado: (2006)

Non-Linear Advanced Control of the LHC Inner Triplet Heat Exchanger Test Unit
por: Blanco-Viñuela, E, et al.
Publicado: (2001)

Experimental investigations of He II heat transfer through a short section of LHC inner triplet quadrupole heat exchanger
por: Darve, C, et al.
Publicado: (2001)

Influence of geometrical parameters on the flexural rigidity of the LHC dipole cold mass assembly
por: Bajko, M, et al.
Publicado: (2002)

Study on heat transfer between the High-Luminosity LHC beam screens and the He II-cooled beam tube
por: Borges de Sousa, P, et al.
Publicado: (2019)

Cryogenic performances of a heat exchanger prototype suitable for the superconducting HL-LHC recombination dipole D2
por: Rousset, B, et al.
Publicado: (2022)

Construction of the New Prototype of Main Quadrupole Cold Masses for the Arc Short Straight Sections of LHC
por: Peyrot, M, et al.
Publicado: (2000)

Thermo - hydraulic analysis of a cryogenic jet: application to helium recovery following resistive transitions in the LHC
por: Chorowski, M, et al.
Publicado: (1999)

Fabrication of the Fermilab Pre-Series Cold Mass for the HL-LHC Accelerator Upgrade Project
por: Vouris, A, et al.
Publicado: (2023)

Adaption of the LHC cold mass cooling system to the requirements of the Future Circular Collider (FCC)
por: Kotnig, C, et al.
Publicado: (2017)

Test of heat exchanger in line N
por: Herberg, Cathrine
Publicado: (2007)

Specifications for the order of 10 heat exchangers
por: Bourgeois, M
Publicado: (1980)

Technical Specification: For a heat exchanger
Publicado: (1985)

Technical specification for a heat exchanger
Publicado: (1985)

Quality Control of the LHC Main Dipole Cold Mass through Magnetic Measurements at Room Temperature
por: Todesco, Ezio, et al.
Publicado: (2003)

A Simplified Structural Model for the Analysis of Shape Deformations of the LHC Superconducting Dipole Cold Mass
por: La China, M, et al.
Publicado: (2006)

Mass Leak and Heat Leak Measurements on the Prototype LHC Quench Relief Valve
por: Jenninger, B
Publicado: (1995)

Cold Leak Tests of LHC Beam Screens
por: Collomb-Patton, C, et al.
Publicado: (2008)

Leak Tightness of LHC Cold Vacuum Systems
por: Cruikshank, P, et al.
Publicado: (2011)

The Design of Cold to Warm Transitions of the LHC
por: Knaster, J R, et al.
Publicado: (2004)

LHC magnets: cold tests & throughput
por: Chohan, V
Publicado: (2005)

Overview on heat loads in the LHC
por: Iadarola, G, et al.
Publicado: (2020)

Beam Vacuum Interconnects for the LHC Cold Arcs
por: Veness, R J M, et al.
Publicado: (1999)

Cannot write session to /tmp/vufind_sessions/sess_h9bvm93og162a8lvhs6i0vos3n