Signal variations in high granularity Si pixel detectors

Fixed pattern noise is one of the limiting factors of image quality and degrades the achievable spatial resolution. In the case of silicon sensors non-uniformities due to doping inhomogeneities can be limited by operating the sensor in strong overdepletion. For high granularity photon counting pixel detectors an additional high frequency interpixel signal variation is an important factor for the achievable signal to noise ratio (SNR). It is common practice to apply flatfield corrections to increase the SNR of the detector system. For the case of direct conversion detectors it can be shown that the Poisson limit can be reached for floodfield irradiation. However when used for imaging with spectral X-ray sources flatfield corrections are less effective. This is partly a consequence of charge sharing between adjacent pixels, which gives rise to an effective energy spectrum seen by the readout, which is different from the spectral content of the incident beam. In this paper we present simulations and measurements of the limited applicability of flatfield corrections for spectral source imaging and investigate the origins of the high frequency interpixel noise component The model, calculations and measurements performed suggest that flatfield correction maps for photon counting detectors with a direct conversion Si sensor can be obtained from electrical characterization of the readout chip alone. (11 refs).