Cargando…

Calculations for breakdown induced by "large defects" in superconducting niobium cavities

Detalles Bibliográficos
Autor principal:	Padamsee, H
Lenguaje:	eng
Publicado:	1983
Materias:	Accelerators and Storage Rings
Acceso en línea:	https://dx.doi.org/10.1109/TMAG.1983.1062561 http://cds.cern.ch/record/952133

Ejemplares similares

Superconducting cavities from niobium-copper material
por: Padamsee, H
Publicado: (1983)

Calculated temperature profiles for a niobium plate used to calibrate thermometers for superconducting cavity diagnostics
por: Padamsee, H
Publicado: (1982)

Superconducting cavities made from niobium-copper composite material
por: Padamsee, H
Publicado: (1983)

Characterization of surface defects in niobium microwave cavities
por: Padamsee, H, et al.
Publicado: (1982)

Microscopic Investigation of Field Emitters Located By thermometry in 1.5-ghz Superconducting Niobium Cavities
por: Knobloch, J, et al.
Publicado: (1996)

Niobium films for superconducting accelerating cavities
por: Benvenuti, Cristoforo, et al.
Publicado: (1984)

Surface Condition Of Niobium For Superconducting Rf Cavities
por: Strongin, M, et al.
Publicado: (1972)

Superconducting niobium cavities of improved thermal conductivity
por: Lengeler, Herbert, et al.
Publicado: (1984)

RF Characterization of Niobium Films for Superconducting Cavities
por: Aull† , S, et al.
Publicado: (2013)

Light Emission Phenomena in Superconducting Niobium Cavities
por: Delayen, J R, et al.
Publicado: (1999)

Superconducting cavities produced by magnetron sputtering of niobium on copper
por: Benvenuti, Cristoforo, et al.
Publicado: (1988)

Superconducting niobium cavities, a case for the film technology
por: Calatroni, Sergio, et al.
Publicado: (2000)

Thin Superconducting Niobium-coatings For RF Accelerator Cavities
por: Langner, J, et al.
Publicado: (2005)

Designing superconducting cavities for accelerators
por: Padamsee, H
Publicado: (2004)

Change of RF superconductivity parameters induced by heat treatment on Niobium cavities
por: Visentin, B, et al.
Publicado: (2001)

On electrical breakdown in superconducting accelerating cavities
por: Weingarten, Wolfgang
Publicado: (1988)

Preparation of niobium coated copper superconducting rf cavities for the Large Electron Positron collider
por: Benvenuti, Cristoforo, et al.
Publicado: (1989)

A 1500MHz Niobium Cavity Made of Electropolished Half-Cells
por: Geng, R, et al.
Publicado: (2003)

Superconducting niobium sputter-coated copper cavities at 1500 MHz
por: Bernard, P, et al.
Publicado: (1991)

Brazing of niobium to stainless steel for UHV applications in superconducting cavities
por: Bacher, J P, et al.
Publicado: (1987)

On the Field Dependent Surface Resistance Observed in Superconducting Niobium Cavities
por: Weingarten, W
Publicado: (2009)

Field-dependent surface resistance for superconducting niobium accelerating cavities
por: Weingarten, Wolfgang
Publicado: (2011)

Design Topics for Superconducting RF Cavities and Ancillaries
por: Padamsee, H
Publicado: (2015)

Metallurgical analysis and RF losses in superconducting niobium thin film cavities
por: Bloess, D, et al.
Publicado: (1996)

Measurement of the Radio-Frequency photo electron source with superconducting niobium cavity
por: Teichert, J, et al.
Publicado: (2007)

Industrial production of superconducting niobium sputter coated copper cavities for LEP
por: Chiaveri, Enrico, et al.
Publicado: (1993)

Surface Study of the Niobium Samples Used in Superconducting RF Cavity Production
por: Ma, Q, et al.
Publicado: (2001)

Effects Of Oxide Films On Surface Resistance And Peak Fields of superconducting Niobium Cavities
por: Halama, H J
Publicado: (1971)

High power measurements in superconducting lead and niobium TMo11 mode cavities
por: Gorlé, D, et al.
Publicado: (1969)

Niobium superconducting cavity
por: CERN PhotoLab
Publicado: (1980)

Explosive field emitter processing in superconducting RF cavities
por: Knobloch, J, et al.
Publicado: (1998)

Microscopic examination of defects located by thermometry in 1.5 GHz superconducting niobium cavities
por: Knobloch, J, et al.
Publicado: (1996)

Cathode geometry and flow dynamics impact on vertical electropolishing of superconducting niobium cavities
por: Ferreira, Leonel
Publicado: (2015)

Superconducting niobium sputter-coated copper cavity modules for the LEP energy upgrade
por: Benvenuti, Cristoforo, et al.
Publicado: (1991)

Superconducting hydroformed niobium sputter coated copper cavities at 1.5 GHz
por: Bernard, P, et al.
Publicado: (1993)

Superconducting 500 MHz accelerating copper cavities sputter-coated with niobium films
por: Benvenuti, Cristoforo, et al.
Publicado: (1984)

Superconducting, hydroformed, niobium sputter coated copper cavities at 1.5 GHz
por: Bloess, D, et al.
Publicado: (1994)

Deposition of superconducting niobium films for RF cavities by means of UHV cathodic Arc
por: Langner, J, et al.
Publicado: (2005)

Production of superconducting RF cavities by coating copper with a sputtered layer of niobium
por: Benvenuti, D, et al.
Publicado: (1987)

Limitations of RF field by thermal breakdown in superconducting niobium cavity
por: Isagawa, S, et al.
Publicado: (1980)

Cannot write session to /tmp/vufind_sessions/sess_bh1apd8hnhss9608e93aogihgs