Cargando…

Production of Austenitic Steel for the LHC Superconducting Dipole Magnets

The austenitic-steel collars are an important component of the LHC dipole magnets, operating at cryogenic temperature under high mechanical stress. The required steel, known as YUS 130S, has been specifically developed for this application by Nippon Steel Corporation (NSC), who was awarded a CERN co...

Descripción completa

Detalles Bibliográficos
Autores principales:	Bertinelli, F, Fudanoki, F, Komori, T, Peiro, G, Rossi, L
Lenguaje:	eng
Publicado:	2006
Materias:	Accelerators and Storage Rings
Acceso en línea:	https://dx.doi.org/10.1109/TASC.2006.873244 http://cds.cern.ch/record/970389

Ejemplares similares

Production of Low-Carbon Magnetic Steel for the LHC Superconducting Dipole and Quadrupole Magnets
por: Bertinelli, F, et al.
Publicado: (2006)

Influence of Austenitic Steel Collar Dimensions on Magnetic Field Harmonics in the LHC Main Dipole
por: Bellesia, B, et al.
Publicado: (2005)

Towards the production of 50'000 tonnes of low-carbon steel sheet for the LHC superconducting dipole and quadrupole magnets
por: Babic, S, et al.
Publicado: (2002)

Status Report on the Superconducting Dipole Magnet Production for the LHC
por: Bajko, M, et al.
Publicado: (2007)

Characteristics of the Austenitic Steels Used in the LHC Main Dipoles
por: Lanza, C, et al.
Publicado: (2002)

Toward the production of 50 000 tonnes of low-carbon steel sheet for the LHC superconducting dipole and quadrupole magnets
por: Babic, S, et al.
Publicado: (2002)

Phased Array Ultrasonic Testing of Austenitic Stainless Steel Welds of the 11 T HL-LHC Dipole Magnets
por: Lorentzon, Marcus
Publicado: (2018)

Quality Control Techniques Applied to the Large Scale Production of Superconducting Dipole Magnets for LHC
por: Savary, F, et al.
Publicado: (2006)

Superconducting Dipole Magnets for the LHC Insertion Regions
por: Willen, E, et al.
Publicado: (2000)

Superconducting Sextupole Corrector Magnet for the LHC Main Dipoles
por: Salminen, J, et al.
Publicado: (1996)

Towards series measurements of the LHC superconducting dipole magnets
por: Walckiers, L, et al.
Publicado: (1998)

Techniques applied to the magnetic design of the superconducting dipoles for LHC
por: Russenschuck, Stephan
Publicado: (1993)

Design and Fabrication of Superfluid Heat Exchanger Tubes for the LHC Superconducting Magnets
por: Bertinelli, F, et al.
Publicado: (2004)

Production of the soft magnetic steel laminations for the LEP dipole magnets
por: Laeger, H, et al.
Publicado: (1988)

Proposal for the award of a contract for the supply of austenitic steel strips for collars of the LHC superconducting dipole magnets
Publicado: (1999)

Proposal for the award of a contract for the supply of austenitic steel end covers for the LHC superconducting dipole magnets
Publicado: (2001)

Magnetic Field Quality of Short Superconducting Dipole Model Magnets for LHC
por: Ang, Z, et al.
Publicado: (1998)

Statistical Analysis of Conductor Motion in LHC Superconducting Dipole Magnets
por: Calvi, M, et al.
Publicado: (2004)

Investigation of the Periodic Magnetic Field Modulation in LHC Superconducting Dipoles
por: Pugnat, P, et al.
Publicado: (2002)

Secondary Phases Quantification and Fracture Toughness at Cryogenic Temperature of Austenitic Stainless Steel Welds for High-Field Superconducting Magnets
por: Santillana, Ignacio Aviles, et al.
Publicado: (2018)

Dependence of Magnetic Field Quality on Collar Supplier and Dimensions in the Main LHC Dipole
por: Bellesia, B, et al.
Publicado: (2006)

Performance of the LHC Final Prototype and First Pre-series Superconducting Dipole Magnets
por: Bottura, L, et al.
Publicado: (2002)

Main Field Tracking Measurement in the LHC Superconducting Dipole and Quadrupole Magnets
por: Xydi, P, et al.
Publicado: (2008)

Magnetic Properties of Pure Iron for the Upgrade of the LHC Superconducting Dipole and Quadrupole Magnets
por: Parrella, A, et al.
Publicado: (2019)

Proposal for the award of a contract for the supply of austenitic steel strips for non-magnetic laminations of the LHC superconducting dipole magnets
Publicado: (1999)

The Dependence of the Field Decay on the Powering History of the LHC Superconducting Dipole Magnets
por: Sammut, N, et al.
Publicado: (2006)

Data Analysis of Transient Energy Releases in the LHC Superconducting Dipole Magnets
por: Calvi, M, et al.
Publicado: (2007)

Performance of the First LHC Pre-series Superconducting Dipoles
por: Bottura, L, et al.
Publicado: (2002)

Study Of Superconducting Dipole Magnet For The Unk
por: Ageev, A I, et al.
Publicado: (1990)

The LHC Superconducting Magnets
por: Rossi, L
Publicado: (2003)

Measurement of Superconducting Busbars Models for the LHC Main Dipole
por: Le Coroller, A, et al.
Publicado: (1999)

Description of the Main Features of the Series Production of the LHC Main Dipole Magnets
por: Savary, F, et al.
Publicado: (2008)

On the Use of Wavelet Transform for Quench Precursors Characterisation in the LHC Superconducting Dipole Magnets
por: Calvi, M, et al.
Publicado: (2006)

Manufacturing of high (10 Tesla) twin aperture superconducting dipole magnet for LHC
por: Borne, J L, et al.
Publicado: (1992)

Development of a 56 mm aperture superconducting dipole model magnet for LHC
por: Shintomi, T, et al.
Publicado: (1996)

Design of a cryostat for superconducting accelerator magnets: the LHC main dipole case
por: Lebrun, P
Publicado: (2004)

Design and analysis of the tooling upgrade for the production of the superconductive main dipole magnet prototypes of LHC
por: Murtomaki, Jaakko Samuel
Publicado: (2016)

LHC Superconducting Dipole Production Follow-up: Results of Audit on QA Aspects in Industry
por: Modena, M, et al.
Publicado: (2006)

Quench Performance and Field Quality of the LHC Preseries Superconducting Dipoles
por: Siemko, A, et al.
Publicado: (2004)

Construction of the CERN Fast Cycled Superconducting Dipole Magnet Prototype
por: Borgnolutti, F, et al.
Publicado: (2012)

Cannot write session to /tmp/vufind_sessions/sess_4e9apbeb71u53uam7hmbqhlogj