Cargando…

Vacuum Pumping by Freezing Molecules

Detalles Bibliográficos
Autor principal:	Benvenuti, Cristoforo
Lenguaje:	eng
Publicado:	2017
Materias:	Accelerators and Storage Rings
Acceso en línea:	http://cds.cern.ch/record/2746077

Ejemplares similares

A Pumping Vacuum Chamber: Ultimate Simplicity
por: Benvenuti, Cristoforo
Publicado: (2017)

A linear pump for conductance limited vacuum systems
por: Benvenuti, Cristoforo, et al.
Publicado: (1977)

Pumping LEP: Sticky Tape for Molecules
por: Benvenuti, Cristoforo
Publicado: (2017)

Recent advances in vacuum techniques for accelerators
por: Benvenuti, Cristoforo
Publicado: (1984)

Vacuum system for Proton Storage Rings equipped with superconducting magnets
por: Benvenuti, Cristoforo
Publicado: (1974)

The technology of the LHC: the LHC and its vacuum technology
por: Strubin, Pierre, et al.
Publicado: (2009)

Vacuum system for proton storage rings equipped with super-conducting magnets
por: Benvenuti, Cristoforo
Publicado: (1974)

Vacuum for particle accelerators and storage rings
por: Benvenuti, Cristoforo, et al.
Publicado: (1987)

A new pumping approach for the large electron positron collider (LEP)
por: Benvenuti, Cristoforo
Publicado: (1983)

A vacuum cold bore test section at the CERN ISR
por: Benvenuti, Cristoforo, et al.
Publicado: (1977)

Ultimate pressures achieved in TiZrV sputter-coated vacuum chambers
por: Benvenuti, Cristoforo, et al.
Publicado: (1999)

Room temperature pumping characteristics of a Zr-Al non-evaporable getter for individual gases
por: Benvenuti, Cristoforo, et al.
Publicado: (1988)

Room temperature pumping characteristics for gas mixtures of a Zr-Al non-evaporable getter
por: Benvenuti, Cristoforo, et al.
Publicado: (1989)

Vacuum stability with beam pumping
por: Gröbner, Oswald
Publicado: (1998)

High vacuum pumping equipment
por: Power, Basil Dixon
Publicado: (1966)

Ultimate pressures of the large electron positron collider (LEP) vacuum system
por: Benvenuti, Cristoforo, et al.
Publicado: (1993)

Vacuum properties of TiZrV non-evaporable getter films [for LHC vacuum system]
por: Benvenuti, Cristoforo, et al.
Publicado: (2001)

Pumping characteristics of the St707 non-evaporable getter (Zr 70-V 24.6-Fe 5.4 wt%)
por: Benvenuti, Cristoforo, et al.
Publicado: (1996)

Vacuum tests in the Booster with sublimation pumps
por: Brouet, M
Publicado: (1988)

Dimensional drawings of LPI vacuum pumping components (vacuum section PS/ML)
por: Malthouse, H F
Publicado: (1983)

Sputter ion pumps for the LEAR vacuum system
Publicado: (1981)

Titanium sublimation pump for the PSB vacuum system
por: Hoekemeijer, F
Publicado: (1978)

Vacuum properties of TiZrV non-evaporable getter films
por: Benvenuti, Cristoforo, et al.
Publicado: (1999)

Vacuum science and engineering: properties of gases at low pressure, vacuum measurements, design and operating features of vacuum pumps and systems
por: Van Atta, C W
Publicado: (1965)

Energy loss from pumping holes in the vacuum chamber
por: Henke, H
Publicado: (1983)

Vacuum Simulation of RF Cavities to Optimize Pump Configurations
por: Shen, S, et al.
Publicado: (1999)

Technical specifications super-ion pumps for the SPS vacuum system
por: Wahl, H
Publicado: (1981)

Technical specification sputter-ion pumps for the SPS vacuum system
por: Wahl, H
Publicado: (1981)

Technical specification of PE insulated vacuum pump supply cable
por: CERN. Geneva
Publicado: (1978)

Technical specification of radiation-resistant vacuum pump supply cables
por: CERN. Geneva
Publicado: (1972)

Technical note - First pump down of the AA vacuum system
por: Malthouse, H F
Publicado: (1980)

Getter pumping
por: Benvenuti, C
Publicado: (2007)

Influence of the elemental composition and crystal structure on the vacuum properties of Ti-Zr-V non-evaporable getter films
por: Prodromides, A E, et al.
Publicado: (2001)

Leakage of RF power from the LEP vacuum chamber into the distributed pump
por: Bramham, Peter
Publicado: (1981)

The use of NEG pumps and coatings in large vacuum systems: experience and limitations
por: Mazzolini, F
Publicado: (2007)

Technical specifications - Turbomolecular pumps for the antiproton accumulator ring vacuum system
Publicado: (1978)

High-voltage power converters feeding the ion pumps of the LEP vacuum system
por: Genand, R, et al.
Publicado: (1990)

Note on acceptance test of 400 l/s ion pumps for LEAR vacuum system
Publicado: (1982)

Note on acceptance test of 60 l/s ion pumps for for LEAR vacuum system
por: Hoekemeijer, F
Publicado: (1982)

Technical specification for rough pumping stations for the vacuum system of the TT2 line
por: Hoekemeijer, F
Publicado: (1977)

Cannot write session to /tmp/vufind_sessions/sess_d7u6iue3b2k8903a9palc9mhvo