Cargando…

Micrometric Propagation of Error Using Overlapping Streched Wires for the CLIC Pre-Alignment

The geodetic network for the Compact LInear collider (CLIC) will consist of a combination of overlapping wires stretched in parallel and Wire Positioning Sensors (WPS). Such a configuration will limit the propagation of errors (maximum deviation w.r.t. a fit line) below 10 micrometres over 200 metre...

Descripción completa

Detalles Bibliográficos
Autores principales:	Mainaud Durand, Helene, Pfingstner, Juergen, Rude, Vivien
Lenguaje:	eng
Publicado:	2017
Materias:	Accelerators and Storage Rings
Acceso en línea:	https://dx.doi.org/10.18429/JACoW-IPAC2017-TUPIK098 http://cds.cern.ch/record/2289681

Ejemplares similares

Drive Beam Quadrupoles for the CLIC Project: a Novel Method of Fiducialisation and a New Micrometric Adjustment System
por: Mainaud Durand, Helene, et al.
Publicado: (2014)

CLIC pre-alignment — status and remaining challenges
por: Kemppinen, Juha, et al.
Publicado: (2021)

Study and application of micrometric alignment on the prototype girders of the CLIC Two-Beam Module
por: Gazis, Nikolaos, et al.
Publicado: (2011)

Fiducialisation and initial alignment of CLIC component with micrometric accuracy
por: Mainaud Durand, Helene, et al.
Publicado: (2016)

Theoretical and practical feasibility demonstration of a micrometric remotely controlled pre-alignment system for the CLIC linear collider
por: Mainaud Durand, H, et al.
Publicado: (2011)

The New CLIC Main Linac Installation and Alignment Strategy
por: Mainaud Durand, Helene, et al.
Publicado: (2018)

Alignment Methods Developed for the Validation of the Thermal and Mechanical Behaviour of the Two Beam Test Modules for the CLIC Project
por: Mainaud Durand, Helene, et al.
Publicado: (2014)

Strategy and validation of fiducialisation for the pre-alignment of CLIC components
por: Griffet, S, et al.
Publicado: (2012)

Pre-Alignment of CLIC using the Double-Wire Method
por: Coosemans, Williame, et al.
Publicado: (1997)

Pre-alignment of CLIC using the double-wire method
por: Coosemans, W, et al.
Publicado: (1997)

Cam Mover Alignment System positioning with the Wire Positioning with the Wire Position Sensor Feedback for CLIC
por: Kemppinen, Juha, et al.
Publicado: (2016)

A Micrometric Positioning Sensor for Laser-Based Alignment
por: Stern, Guillaume, et al.
Publicado: (2016)

Propagation error simulations concerning the CLIC active prealignment
por: Touzé, T, et al.
Publicado: (2009)

Frictionless pulley to strech an invar wire
por: PhotoLab
Publicado: (1965)

Validation of a Micrometric remotely controlled pre-alignment system for the CLIC Linear Collider using a test setup (Mock-Up) with 5 degrees of freedom
por: Mainaud Durand, H, et al.
Publicado: (2011)

Remote alignment of Low beta quadrupoles with micrometric resolution
por: Acar, M, et al.
Publicado: (2008)

Validation of the CLIC alignment strategy on short range
por: Mainaud Durand, H, et al.
Publicado: (2012)

Study of the Dynamic Response of CLIC Accelerating Structures
por: Daskalaki, Eleni, et al.
Publicado: (2015)

Strech of water
por: Valeriane Duvivier
Publicado: (2001)

Strech of water
por: Valeriane Duvivier
Publicado: (2001)

Strech of water
por: Valeriane Duvivier
Publicado: (2001)

Evaluation of Streched Wire Measurement Based on Photogrammetry in the Context of CERN
por: Behrens, A, et al.
Publicado: (2016)

The CLIC Alignment Studies: Past, Present and Future
por: Mainaud Durand, H
Publicado: (2004)

Alignement général du CLIC: stratégie et progrès
por: Mainaud-Durand, H
Publicado: (2008)

Integration and Testing of 3 Consecutive CLIC Two-Beam Modules
por: Vamvakas, Alexios, et al.
Publicado: (2016)

Robust Optical Instrumentation for Accelerator Alignment Using Frequency Scanning Interferometry
por: Sosin, Mateusz, et al.
Publicado: (2021)

Design and Study on a 5 Degree-of-freedom Adjustment Platform for CLIC Drive Beam Quadrupoles
por: Sosin, Mateusz, et al.
Publicado: (2014)

CLIC main beam quadrupole active pre-alignment based on cam movers
por: Kemppinen, J, et al.
Publicado: (2012)

Determination of the Magnetic Axis of a CLIC Drive Beam Quadrupole with respect to External Alignment Targets using a Combination of WPS, CMM and Laser Tracker Measurements
por: Duquenne, Mathieu, et al.
Publicado: (2014)

Main Achievements of the PACMAN Project for the Alignment at Micrometric Scale of Accelerator Components
por: Mainaud Durand, Helene, et al.
Publicado: (2017)

3D calculation for the alignment of LHC low-beta quadrupoles
por: Rude, Vivien, et al.
Publicado: (2022)

Strech of water at point 5
por: Valeriane Duvivier
Publicado: (2001)

HL-LHC Alignment Requirements and Associated Solutions
por: Mainaud Durand, Helene, et al.
Publicado: (2017)

Experiment of Laser Pointing Stability on Different Surfaces to validate Micrometric Positioning Sensor
por: Stern, Guillaume, et al.
Publicado: (2014)

The Active Prealignment of the CLIC Components
por: Mainaud-Durand, Hélène, et al.
Publicado: (2007)

Characterization and alignment of a resonant cavity beam position monitor for the Compact LInear Collider (CLIC) project at CERN
por: Zorzetti, Silvia, et al.
Publicado: (2023)

Feasibility study of multipoint based laser alignment system for CLIC
por: Stern, G, et al.
Publicado: (2012)

Development of an Eccentric CAM Based Active Pre-Alignment System for the CLIC Main Beam Quadrupole Magnet
por: Lackner, F, et al.
Publicado: (2010)

Position Monitoring System for HL-LHC Crab Cavities
por: Sosin, Mateusz, et al.
Publicado: (2016)

Experiments of Laser Pointing Stability in Air and in Vacuum to Validate Micrometric Positioning Sensor
por: Stern, G, et al.
Publicado: (2014)

Cannot write session to /tmp/vufind_sessions/sess_ou5d6j8d5e0834f4s0junleuk3