Cargando…

Thermal behaviour of DC power inductor of 600 kW power supply for particle accelerators

The paper investigates a thermal behaviour of a DC inductor deployed in a 600 kW power converter for particle accelerators. The inductor is manufactured from electrical steel core and two magnetically coupled windings with integrated air ducts for enhanced air circulation. The thermal analysis of in...

Descripción completa

Detalles Bibliográficos
Autores principales:	Matejevic, D, Josifovic, I, Papastergiou, K, Le Godec, G, Burnet, J P
Lenguaje:	eng
Publicado:	2017
Materias:	Accelerators and Storage Rings
Acceso en línea:	https://dx.doi.org/10.23919/EPE17ECCEEurope.2017.8099279 http://cds.cern.ch/record/2314465

Ejemplares similares

A 600 kW power supply for particle accelerators insensitive to electrical network perturbations
por: Josifovic, I, et al.
Publicado: (2017)

The BTF (Beam Transfer Facility) DC/Pulsed 50 kW Power Supply for DAFNE injector
por: MacCaferri, R, et al.
Publicado: (2006)

Technical Specification for a high voltage 120 kW (180 kW peak) power supply
por: Höfle, Wolfgang
Publicado: (2000)

Inductor based switching DC-DC converter for low voltage power distribution in SLHC
por: Michelis, S, et al.
Publicado: (2007)

Non-isolated high step-up DC/DC power converter with coupled-inductor
por: Liu, Van-Tsai, et al.
Publicado: (2021)

IGBT Power Stack Integrity Assessment Method for High-Power Magnet Supplies
por: Asimakopoulos, Panagiotis, et al.
Publicado: (2019)

Evaluation of DC/DC switching power regulation with small-scale integrated inductors for PET/MR
por: Biagi, Laura, et al.
Publicado: (2015)

Technical specificaion: Specification for a 16 KA/300 KW pulsed DC power supply for magnet tests
por: Bossard, P
Publicado: (1969)

Proposal for the Award of a Contract for the Supply of 37.5 kW Switch-mode DC Power Converters for the LEP Main-Ring Magnet System
Publicado: (1987)

Adjudication of a Contract for the Supply of a Spare Rotor for the 6000 kW Motor of the PS Magnet Power Supply
Publicado: (1973)

The linac RF power system below 400 kW
por: Kracht, Ulf
Publicado: (1960)

Comparative study of two-quadrant DC/DC stage in power supply for superconducting magnets
por: Coulinge, Emilien, et al.
Publicado: (2018)

Specification for 9 180 KW power supplies for the new PS 200 MHz accelerating system
Publicado: (1977)

Thermal stressing mitigation possibility intended for a DC-current magnet supply based on high power IGBT modules
por: Asimakopoulos, P, et al.
Publicado: (2017)

Inductors and Transformers For Power Electronics
por: Van den Bossche, Alex
Publicado: (2005)

Specification of a 50 kW switched mode power converter
por: Vôlker, F
Publicado: (1995)

A modular 200kW-25kV DC medium frequency resonant converter for RF power amplifiers
por: Bonnin, X, et al.
Publicado: (2017)

Adjudication of a Contract for the Supply of a 450 kW, 800 MHz Radio-Frequency Power Amplifier for the SPS
Publicado: (1977)

On $V_{ce}$ Method: In Situ Temperature Estimation and Aging Detection of High-Current IGBT Modules Used in Magnet Power Supplies for Particle Accelerators
por: Asimakopoulos, Panagiotis, et al.
Publicado: (2019)

Four Quadrant 250KW Switchmode Power Supply for Fermilab Main Injector
por: Fang, S, et al.
Publicado: (1999)

Proposal for the Award of Two contracts for the Supply of Two cryogenic Plants of 6 kW Cooling Power at 4.5 K
Publicado: (1990)

Regulated D.C. power supplies
por: CERN. Geneva. Proton Synchrotron Division. Magnets Measurements Group
Publicado: (1958)

Power supplies for DC-Magnets: Specification
por: Bourgeois, M
Publicado: (1974)

DC power supplies: power management and surge protection for power electronic systems
por: Kularatna, Nihal
Publicado: (2011)

Proposal for the Award of Two Contracts for the Supply of Four Cryogenic Plants of 12 (18)kW Cooling Power at 4.5 K
Publicado: (1990)

Proposal for the award of a contract for the supply of eighteen 400 MHz, 330 kW high-power waveguide junction circulators for the LHC
Publicado: (2001)

Pantak High Voltage DC Power Supply
por: Vanden Broeck, Renilde
Publicado: (2019)

Technical specification for small DC power supplies
Publicado: (1978)

Specification of semiconductors and heatsinks for the power part of D.C. power supplies.
Publicado: (1985)

An efficient controller design of a PV integrated single inductor multiple output DC–DC converter for dynamic voltage and low power applications
por: Usman, Mudassar, et al.
Publicado: (2023)

A quasi-offline condition monitoring method of DC-link capacitor banks in accelerator power converters
por: Baumann, Timm Felix, et al.
Publicado: (2022)

Power supplies and accelerators
por: Marks, N
Publicado: (2006)

Design report of a 1 kW power ampliﬁer for the PS RF 10 MHz system
por: Favia, Giorgia
Publicado: (2018)

Power Converter Topologies with Energy Recovery and Grid Power Limitation For Inductive Load Applications
por: Rossini, Stefano, et al.
Publicado: (2015)

The CERN-LEP project and its dc power supplies
por: Isch, Hans W
Publicado: (1982)

Simulation of Waveforms of a Ferrite Inductor with Saturation and Power Losses
por: Salas, Rosa Ana, et al.
Publicado: (2014)

MEMS inductor fabrication and emerging applications in power electronics and neurotechnologies
por: Le, Hoa Thanh, et al.
Publicado: (2021)

Improvement of power quality parameters using modulated-unified power quality conditioner and switched-inductor boost converter by the optimization techniques for a hybrid AC/DC microgrid
por: Khosravi, Nima, et al.
Publicado: (2022)

Current modulation and polarity inversion of 100-250 kW power converters in the PS-Booster transfer lines
por: Völker, F
Publicado: (1998)

High-resolution imaging enabled by 100-kW-peak-power parametric source at 5.7 THz
por: Kuo, Cang-He, et al.
Publicado: (2023)

Cannot write session to /tmp/vufind_sessions/sess_7edar711r987gvvj9ti9futcuv