Cargando…

Metrological characterization of high-performance delta-sigma ADCs: A case study of CERN DS-22

Metrological characterization of high-performance ΔΣ Analog-to-Digital Converters (ADCs) poses severe challenges to reference instrumentation and standard methods. In this paper, most important tests related to noise and effective resolution, nonlinearity, environmental uncertainty, and stability ar...

Descripción completa

Detalles Bibliográficos
Autores principales:	Arpaia, Pasquale, Baccigalupi, Carlo, Martino, Michele
Lenguaje:	eng
Publicado:	2018
Materias:	Accelerators and Storage Rings Engineering
Acceso en línea:	https://dx.doi.org/10.1109/I2MTC.2018.8409653 http://cds.cern.ch/record/2646283

Ejemplares similares

Simulation challenges in high-resolution $\Delta\Sigma$ ADCs: The experimental case study of CERN DS-22
por: Arpaia, Pasquale, et al.
Publicado: (2018)

Metrological Characterization of an Ultra-low Noise Acquisition System for Fast Voltage Pulses Measurements
por: Baccigalupi, Carlo, et al.
Publicado: (2015)

Metrological Characterization of an Improved DSP-Based On-line Integrator for Magnetic Measurements at CERN
por: Arpaia, Pasquale, et al.
Publicado: (2007)

High speed and wide bandwidth delta-sigma ADCs
por: Bolatkale, Muhammed, et al.
Publicado: (2014)

Extreme Value Statistical Characterization of Time Domain Pulse-to-Pulse Measurements
por: Baccigalupi, Carlo, et al.
Publicado: (2015)

Metrological Characterisation of a Fast Digital Integrator for Magnetic Measurements at CERN
por: Arpaia, P, et al.
Publicado: (2007)

Enhanced analogue front-end for the measurement of the high state of wide-band voltage pulses with 87 dB common-mode rejection ratio and ±0.65 ppm 1-day offset stability
por: Baccigalupi, Carlo, et al.
Publicado: (2015)

Type-A Worst-Case Uncertainty for Gaussian noise instruments
por: Baccigalupi, Carlo, et al.
Publicado: (2015)

Metrological Performance of a Ferrimagnetic Resonance Marker for the Field Control of the CERN Proton Synchrotron
por: Arpaia, P, et al.
Publicado: (2012)

Modeling and metrological analysis of an X-ray diffractometer for crystal-assisted collimation in particle accelerator
por: Arpaia, Pasquale, et al.
Publicado: (2018)

Design of an Ultra-Low Noise Analogue Front-End for Fast Voltage Pulses Measurement
por: Baccigalupi, Carlo, et al.
Publicado: (2015)

±25ppm repeatable measurement of trapezoidal pulses with 5MHz bandwidth
por: Baccigalupi, Carlo, et al.
Publicado: (2015)

Design of a 1 _s real-time low-noise data acquisition for power converters control loop
por: Baccigalupi, Carlo, et al.
Publicado: (2015)

Metrological Characterization of the Bunch Length Measurement by Means of a RF Deflector at the ELI-NP Compton Gamma source
por: Sabato, Luca, et al.
Publicado: (2016)

Static Metrological Characterization of a Ferrimagnetic Resonance Transducer for Real-Time Magnetic Field Markers in Particle Accelerators
por: Arpaia, P, et al.
Publicado: (2012)

WP7: Metrology and Mechanical Stabilisation, presented at CERN
por: Karyotakis, Yannis
Publicado: (2004)

Geodesy and metrology at CERN: a source of economy for the SPS programme
por: Gervaise, Jean
Publicado: (1976)

Metrology for experiments
por: Lasseur, C
Publicado: (1987)

A Metrology-grade Digitizer for Power Converters in the High Luminosity Large Hadron Collider
por: Beev, Nikolai, et al.
Publicado: (2022)

Impact of flux jumps on high-precision powering of Nb$_3$Sn superconducting magnets
por: Martino, Michele, et al.
Publicado: (2019)

Modelling for metrological analysis of an X-ray diﬀractometer for bent crystals characterization in crystal-assisted collimation
por: Gargiulo, Simone
Publicado: (2021)

Metrological Characterization of Nuclear Magnetic Resonance Markers for Real-Time Field Control of the CERN ELENA Ring Dipoles
por: Grech, Christian, et al.
Publicado: (2018)

High-Repeatable Data Acquisition Systems for Pulsed Power Converters in Particle Accelerator Structures
por: Baccigalupi, Carlo
Publicado: (2016)

Understanding delta-sigma data converters
por: Pavan, Shanti, et al.
Publicado: (2017)

Understanding delta-sigma data converters
por: Schreier, Richard, et al.
Publicado: (2005)

PACMAN (Particle Accelerator Components Metrology and Alignment to the Nanometer scale)
por: Caalan-Lasheras, Nuria, et al.
Publicado: (2013)

Performance simulation of a digital integrator for magnetic measurements at CERN
por: Arpaia, Pasquale, et al.
Publicado: (2008)

A high accuracy 22 bit sigma-delta converter for digital regulation of superconducting magnet currents
por: Pett, John G
Publicado: (1999)

Some Specific Features Of LEP Metrology
por: Gervaise, Jean, et al.
Publicado: (1980)

Metrology of the LHC Dipole Cold Masses
por: Bajkó, M, et al.
Publicado: (2002)

Error Modeling of a Fast Digital Integrator for Magnetic Measurements at CERN
por: Arpaia, Pasquale, et al.
Publicado: (2007)

Sensors applications within the research framework of the PACMAN project on metrology for particle accelerators at CERN
por: Arpaia, P, et al.
Publicado: (2016)

Sigma-delta converters: practical design guide
por: De la Rosa, Jose M
Publicado: (2018)

Geodetic metrology of particle accelerators and physics equipment
por: Mayoud, Michel
Publicado: (1987)

Workshop Report on Metrology and Stabilization for Linear Colliders
por: Guignard, Gilbert, et al.
Publicado: (2005)

Work Package 7: Metrology and Mechanical Stabilisation
por: Buesser, Karsten
Publicado: (2004)

A SIGMA- beam for the Omega spectrometer in the West Hall at CERN
por: Grafström, P
Publicado: (1990)

Surface Response-based Behavioral Modeling of Accurate Digitizers: a Case Study on a Fast Digital Integrator at CERN
por: Arpaia, Pasquale, et al.
Publicado: (2007)

Augmented Reality monitoring of robot-assisted intervention in harsh environments at CERN
por: Angrisani, Leopoldo, et al.
Publicado: (2018)

MPV908A-ADC driver: The MPV908A ADC VMEbus board driver under LynxOS
por: Abie, Habtamu, et al.
Publicado: (1992)

Cannot write session to /tmp/vufind_sessions/sess_ua7fv1om2u4p2rcgsskhgjrft9