Cargando…

Qualification of ITER Correction Coil Superconducting Joint

The correction coils (CCs) are a system of 18 superconducting coils composed of top CCs, side CCs, and bottom CCs, and are required to correct asymmetries and reduce magnetic error fields detrimental to the plasma performance of the ITER machine. The CC terminals will be connected with those of the...

Descripción completa

Detalles Bibliográficos
Autores principales:	Wang, Lin, Wu, Weiyue, Wei, Jing, Ilyin, Yuri, Dolgetta, Nello, Simon, Fabrice, Libeyre, Paul, Aviles Santillana, Ignacio, Langeslag, Stefanie, Sgobba, Stefano, Bernard, Turck
Lenguaje:	eng
Publicado:	2018
Materias:	Accelerators and Storage Rings
Acceso en línea:	https://dx.doi.org/10.1109/TPS.2018.2849592 http://cds.cern.ch/record/2646288

Ejemplares similares

Qualification of structural stainless steel products for the ITER correction coil cases
por: Sgobba, Stefano, et al.
Publicado: (2017)

Qualification of the Manufacturing Procedures of the ITER Correction Coils
por: Libeyre, P, et al.
Publicado: (2017)

Advanced examination techniques applied to the qualification of critical welds for the ITER correction coils
por: Sgobba, Stefano, et al.
Publicado: (2015)

Requirements for qualification of manufacture of the ITER Central Solenoid and Correction Coils
por: Libeyre, Paul, et al.
Publicado: (2015)

The Effect of Specific Manufacturing Characteristics on PF ITER Full-Size Joint Performance
por: Pison, Pilar Fernandez, et al.
Publicado: (2019)

The Laser Welding with Hot Wire of 316LN Thick Plate Applied on ITER Correction Coil Case
por: Fang, Chao, et al.
Publicado: (2014)

Investigation of Materials and Welds for the Precompression Structure of the ITER Central Solenoid
por: Sgobba, Stefano, et al.
Publicado: (2018)

Examination of ITER Central Solenoid prototype joints
por: Aviles Santillana, I, et al.
Publicado: (2019)

Extensive Characterisation of Copper-clad Plates, Bonded by the Explosive Technique, for ITER Electrical Joints
por: Langeslag, S A E, et al.
Publicado: (2015)

Assessment of Residual Stresses in ITER CS Helium Inlet Welds Fatigue Tested at Cryogenic Temperature
por: Sgobba, S, et al.
Publicado: (2019)

Progress of the ITER Correction Coils in China
por: Wei, J, et al.
Publicado: (2014)

Examination and Assessment of Large Forged Structural Components for the Precompression Structure of the ITER Central Solenoid
por: Sgobba, Stefano, et al.
Publicado: (2020)

Metallurgical assessment of large size tensioning components for the precompression structure of the ITER central solenoid
por: Sgobba, Stefano, et al.
Publicado: (2021)

Microstructure and Mechanical Properties of the Enclosure Welding Joint for ITER Correction Coils Cases
por: Xin, Jijun, et al.
Publicado: (2020)

Examination and Characterization of Physical and Mechanical Properties of the ITER Central Solenoid Module Coils
por: Sgobba, Stefano, et al.
Publicado: (2022)

Post-mortem analysis of ITER CS helium inlets fatigue tested at cryogenic temperature
por: Aviles Santillana, I, et al.
Publicado: (2019)

Microstructure and Mechanical Properties of ITER Correction Coil Case Material
por: Xin, Jijun, et al.
Publicado: (2017)

Design Optimization and Assessment of Fabrication of ITER Central Solenoid Twin Box Joints
por: Santillana, Ignacio Aviles, et al.
Publicado: (2020)

Physical Properties of a High-Strength Austenitic Stainless Steel for the Precompression Structure of the ITER Central Solenoid
por: Sgobba, Stefano, et al.
Publicado: (2016)

Design of load-to-failure tests of high-voltage insulation breaks for ITER's cryogenic network
por: Langeslag, S A E, et al.
Publicado: (2015)

Manufacture of the ITER Central Solenoid Components
por: Libeyre, Paul, et al.
Publicado: (2018)

Extensive characterisation of advanced manufacturing solutions for the ITER Central Solenoid pre-compression system
por: Langeslag, S.A.E., et al.
Publicado: (2015)

Secondary Phases Quantification and Fracture Toughness at Cryogenic Temperature of Austenitic Stainless Steel Welds for High-Field Superconducting Magnets
por: Santillana, Ignacio Aviles, et al.
Publicado: (2018)

Advanced Examination Techniques Applied to the Assessment of Vacuum Pressure Impregnation (VPI) of ITER Correction Coils
por: Sgobba, Stefano, et al.
Publicado: (2014)

Characterization of low temperature high voltage axial insulator breaks for the ITER cryogenic supply line
por: Fernandez Pison, P, et al.
Publicado: (2017)

Starting Manufacture of the ITER Central Solenoid
por: Libeyre, P, et al.
Publicado: (2016)

Fatigue performance evaluation for ITER IVC conductor component materials
por: Jin, H, et al.
Publicado: (2017)

Final Design of ITER In-Vessel Coils and Manufacturing of In-Vessel Coil Conductor
por: Encheva, Anna, et al.
Publicado: (2022)

Design and fabrication of a cryostat for low temperature mechanical testing for the Mechanical and Materials Engineering group at CERN
por: Aviles Santillana, I, et al.
Publicado: (2015)

Electrical insulation testing for ITER fusion tokamak
por: Gaxiola, E, et al.
Publicado: (2017)

From manufacture to assembly of the ITER central solenoid
por: Libeyre, P, et al.
Publicado: (2019)

Design, qualification & manufacture of ITER gravity supports
por: Lee, P.Y., et al.
Publicado: (2020)

Validation of Helium Inlet Design for ITER Toroidal Field Coil
por: Boyer, C, et al.
Publicado: (2014)

Tailored Structural Material Solutionsfor Large-Scale Superconducting Magnets
por: Langeslag, Stefanie
Publicado: (2020)

Qualification of Fin-Type Heat Exchangers for the ITER Current Leads
por: Ballarino, A, et al.
Publicado: (2015)

Superconducting coil
por: CERN PhotoLab
Publicado: (1969)

Failure analysis of a heavy gauge fastener of the ITER toroidal field gravity support system
por: Sgobba, Stefano, et al.
Publicado: (2023)

Studies on the LHC superconducting circuits and routine qualification of their functionalities
por: Pojer, M, et al.
Publicado: (2012)

Advanced ultrasonic examination of heavy–gauge high strength studs for the ITER toroidal field gravity supports
por: Santillana, I Aviles, et al.
Publicado: (2023)

The ITER Superconducting Magnet Programme
por: Salpietro, E
Publicado: (2005)

Cannot write session to /tmp/vufind_sessions/sess_t4cjhrjnepnks1o785kl3r9mda