Upgrade of the ALICE inner tracking system: Construction and commissioning

ALICE (A Large Ion Collider Experiment) is the CERN LHC experiment optimized for the study of the strongly interacting matter produced in heavy-ion collisions, in particular the characterization of the quark-gluon plasma. After the successful operation of the experiment during the first two runs of the LHC, the ALICE collaboration is currently working on a major upgrade of its detectors, to be installed during the 2019–2020 Long Shutdown (LS2). The main goal is to increase the readout capabilities and allow recording of Pb–Pb minimum bias events at rates in excess of 50 kHz, which is the expected Pb–Pb interaction rate at the LHC after LS2. One key part of the upgrade is the construction of a new Inner Tracking System (called ITS2) that will significantly improve the impact parameter resolution of the tracks, tracking efficiency, and readout capacity which enables precise measurements of low momentum charged particles. The ITS2 consists of seven approximately-cylindrical detector layers of CMOS Monolithic Active Pixel Sensors (MAPS) with the sensor matrix and readout integrated on a single chip, named ALPIDE (ALice PIxel DEtector), covering an area of 10 m$^{2}$ and containing about 12.5 billion pixels. All layers are mounted on ultra-lightweight carbon support structures with an embedded cooling system. This allows a reduction of the material budgets down to about 0.3% X$_{0}$ for the inner layers and 1% X$_{0}$ for the outer layers, with respect to the previous ITS system. After a brief overview of the upgrade motivation, details of the overall layout will be given as well as the construction and commissioning status and plans.