Cargando…

The HL-LHC Short Model Recombination D2 Dipole: Cold Test Results and Analysis

The new D2 recombination superconducting dipole is a key two-in-one Nb-Ti magnet with a 105 mm bore aperture for the high luminosity LHC accelerator upgrade project (HL-LHC) at CERN expected in operation from 2024. A short model MBRDS1 magnet of 1.6 m magnetic length has been designed by INFN (Genov...

Descripción completa

Detalles Bibliográficos
Autores principales:	Foussat, Arnaud, Fabbricatore, Pasquale, Mangiarotti, Franco, Perez, Juan Carlos, Bersani, Andrea, Caiffi, Barbara, Farinon, Stefania, Cereseto, Roberto, Levi, Filippo, Id'Bahmane, Oussama, Sahner, Thomas, Bajko, Marta, Todesco, Ezio
Lenguaje:	eng
Publicado:	2020
Acceso en línea:	https://dx.doi.org/10.1109/TASC.2020.2976963 http://cds.cern.ch/record/2744542

Ejemplares similares

The superconducting separation dipoles MBRD for the High Luminosity upgrade of LHC: From short model to prototype
por: Bersani, Andrea, et al.
Publicado: (2019)

Development of a Short Model of the Superconducting Separation Dipoles D2 for the High Luminosity Upgrade of LHC
por: Fabbricatore, Pasquale, et al.
Publicado: (2017)

The Development of the Superconducting Dipoles D2 for the High Luminosity Upgrade of LHC
por: Caiffi, Barbara, et al.
Publicado: (2021)

The Separation-Recombination Dipole MBRD for the High-Luminosity LHC: From Prototype to Series
por: Levi, F, et al.
Publicado: (2022)

The MBRD Dipoles for the Luminosity Upgrade at the LHC: From Prototype Tests to the Series Production
por: Farinon, Stefania, et al.
Publicado: (2023)

Protection Scheme Effectiveness Study for the High-Luminosity LHC MBRD Magnet
por: Caiffi, Barbara, et al.
Publicado: (2023)

The EuroCirCol 16T Cosine–Theta Dipole Option for the FCC
por: Sorbi, Massimo, et al.
Publicado: (2016)

The Design of Superconducting Separation Dipoles D2 for the High Luminosity Upgrade of LHC
por: Farinon, S, et al.
Publicado: (2016)

Field quality and warm-cold correlations in the LHC main dipoles
por: Todesco, Ezio
Publicado: (2004)

Quench Protection Study of the Eurocircol 16 T cosθ Dipole for the Future Circular Collider (FCC)
por: Marinozzi, Vittorio, et al.
Publicado: (2016)

Field Quality and Mechanical Analysis of the Beam Separation Dipole for HL-LHC Upgrade
por: Sugano, Michinaka, et al.
Publicado: (2014)

Design Optimization of the New D1 Dipole for HL-LHC Upgrade
por: Xu, Qingjin, et al.
Publicado: (2014)

Design of a Large Single-Aperture Dipole Magnet for HL-LHC Upgrade
por: Qingjin, Xu, et al.
Publicado: (2013)

Metrology of the LHC Dipole Cold Masses
por: Bajkó, M, et al.
Publicado: (2002)

Update on the Electromagnetic Design of the Nb-Sn Cos-Theta Dipole Model for FCC-hh
por: Valente, R U, et al.
Publicado: (2022)

Quality Control of the LHC Main Dipole Cold Mass through Magnetic Measurements at Room Temperature
por: Todesco, Ezio, et al.
Publicado: (2003)

Geometric and Magnetic Axes of the LHC Dipole
por: Bajko, M, et al.
Publicado: (2001)

Mechanical Design of FalconD, a Nb$_3$Sn Cos$\theta$ Short Model Dipole for the FCC
por: Pampaloni, A, et al.
Publicado: (2022)

Warm-Cold Magnetic Field Correlation in the LHC Main Dipoles
por: Bottura, L, et al.
Publicado: (2003)

Performance of the Quench Protection Heater for the HL-LHC Beam Separation Dipole
por: Suzuki, Kento, et al.
Publicado: (2020)

Design Study of the Nb₃Sn Cos-Theta Dipole Model for FCC-hh
por: Valente, Riccardo U, et al.
Publicado: (2021)

Optical In-Situ Measurement of Relative Deformations of the LHC Main Dipole Cold Masses
por: Aznar, S, et al.
Publicado: (2002)

Finite Element Model to Study the Deformations of Nb$_{3}$Sn Wires for the Next European Dipole (NED)
por: Farinon, S, et al.
Publicado: (2007)

Stress on Cold Mass Due to the Supporting System of the CMS Coil in the Vacuum Tank
por: Farinon, S, et al.
Publicado: (2000)

Extrapolation of the systematic errors of the LHC dipoles and dynamic aperture
por: Todesco, Ezio
Publicado: (1992)

Status and challenges of the interaction region magnets for HL-LHC
por: Todesco, E, et al.
Publicado: (2022)

The LHC Pre-series Dipole Cold Mass Geometry
por: Bajko, M, et al.
Publicado: (2004)

Influence of geometrical parameters on the flexural rigidity of the LHC dipole cold mass assembly
por: Bajko, M, et al.
Publicado: (2002)

Updates on the Mechanical Design of FalconD, a Nb$_3$Sn Cos$\Theta$ Short Model Dipole for FCC-hh
por: Levi, F, et al.
Publicado: (2023)

Optimization of Electromagnetic Design After Winding Tests for the Nb3Sn Cos-Theta Dipole Model for FCC-hh
por: Valente, R U, et al.
Publicado: (2023)

REQUIREMENTS FOR SEPARATION DIPOLES: MILESTONE: MS34
por: Todesco, Ezio, et al.
Publicado: (2013)

Summary of mechanical, thermal and magnetic analyses on CMS cold mass made at INFN Genova during 1997
por: Fabbricatore, P, et al.
Publicado: (1998)

Unit 4 - How to generate dipole and quadrupole fields with current lines
por: Todesco, Ezio
Publicado: (2020)

Powering Performance and Endurance Beyond Design Limits of HL-LHC Low-Beta Quadrupole Model Magnets
por: Mangiarotti, Franco J, et al.
Publicado: (2021)

Electromagnetic Design of Superconducting Dipoles Based on Sector Coils
por: Todesco, Ezio, et al.
Publicado: (2007)

Conceptual Design of a Large-aperture Dipole Magnet for HL-LHC Upgrade
por: Xu, K, et al.
Publicado: (2012)

Status of the LHC Main Dipole Pre-Series Production
por: Modena, M, et al.
Publicado: (2003)

Test Result of the HL-LHC Beam Separation Dipole Model Magnet With the New Iron Cross Section
por: Suzuki, Kento, et al.
Publicado: (2019)

Quench Behavior of Prototype Nb-Ti HL-LHC Dipole Canted Cos-Theta Orbit Corrector Magnets
por: Wozniak, Mariusz, et al.
Publicado: (2022)

Test of short model and prototype of the HL-LHC D2 orbit corrector based on CCT technology
por: Mangiarotti, Franco, et al.
Publicado: (2019)

Cannot write session to /tmp/vufind_sessions/sess_e8rf77vtl9as0kq5fs1ub6ka3m