Preparation of Superhydrophobic Materials and Establishment of Anticorrosive Coatings on the Tinplate Substrate by Alkylation of Graphene Oxide

Corrosion of structural parts not only reduces the service life of the equipment but also causes safety accidents, so building a long-lasting anti-corrosion coating on its surface is the key to solving this problem. Under the action of alkali catalysis, n-octyltriethoxysilane (OTES), dimethyldimethoxysilane (DMDMS), and perfluorodecyltrimethoxysilane (FTMS) hydrolyzed and polycondensed co-modified graphene oxide (GO), modified to synthesize a self-cleaning superhydrophobic material fluorosilane-modified graphene oxide (FGO). The structure, film morphology, and properties of FGO were systematically characterized. The results showed that the newly synthesized FGO was successfully modified by long-chain fluorocarbon groups and silanes. FGO presented an uneven and rough morphology on the substrate surface, the water contact angle was 151.3°, and the rolling angle was 3.9°, which caused the coating to exhibit excellent self-cleaning function. Meanwhile, the epoxy polymer/fluorosilane-modified graphene oxide (E-FGO) composite coating adhered to the carbon structural steel’s surface, and its corrosion resistance was detected by the Tafel curve and EIS impedance. It was found that the current density of the 10 wt% E-FGO coating (I(corr)) was the lowest (1.087 × 10(−10) A/cm(2)), which was approximately 3 orders of magnitude lower than that of the unmodified epoxy coating. This was primarily due to the introduction of FGO, which formed a continuous physical barrier in the composite coating and gave the composite coating excellent hydrophobicity. This method might provide new ideas for advances in steel corrosion resistance in the marine sector.