Cargando…

Effects of the Curing Regime, Acid Exposure, Alkaline Activator Dosage, and Precursor Content on the Strength Development of Mortar with Alkali-Activated Slag and Fly Ash Binder: A Critical Review

Reductions of green gas emissions and the reuse/recycling of industrial byproducts are important for the mitigation of the environmental impact of the construction industry. The replacement of ordinary Portland cement (OPC) is a concrete binder with industrial byproducts that possess sufficient ceme...

Descripción completa

Detalles Bibliográficos
Autor principal:	Mohamed, Osama A.
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2023
Materias:	Review
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC10007570/ https://www.ncbi.nlm.nih.gov/pubmed/36904489 http://dx.doi.org/10.3390/polym15051248

Ejemplares similares

Effect of Solution-to-Binder Ratio and Alkalinity on Setting and Early-Age Properties of Alkali-Activated Slag-Fly Ash Binders
por: Naqi, Ali, et al.
Publicado: (2022)

Role of Curing Conditions and Precursor on the Microstructure and Phase Chemistry of Alkali-Activated Fly Ash and Slag Pastes
por: Nedeljković, Marija, et al.
Publicado: (2021)

Fresh Properties and Sulfuric Acid Resistance of Sustainable Mortar Using Alkali-Activated GGBS/Fly Ash Binder
por: Mohamed, Osama Ahmed, et al.
Publicado: (2022)

Setting and Hardening Behaviour of Alkali-Activated Landfilled Fly Ash–Slag Binder at Room Temperature
por: Liu, Wei, et al.
Publicado: (2020)

The Influence of Accelerated Carbonation on Physical and Mechanical Properties of Hemp-Fibre-Reinforced Alkali-Activated Fly Ash and Fly Ash/Slag Mortars
por: Merta, Ildiko, et al.
Publicado: (2022)

Chloride Ions’ Penetration of Fly Ash and Ground Granulated Blast Furnace Slags-Based Alkali-Activated Mortars
por: Duży, Patrycja, et al.
Publicado: (2021)

Factors Influencing the Properties of Extrusion-Based 3D-Printed Alkali-Activated Fly Ash-Slag Mortar
por: Yuan, Qiang, et al.
Publicado: (2022)

Mechanical behavior of textile reinforced alkali-activated mortar based on fly ash, metakaolin and ladle furnace slag
por: Arce, Andres, et al.
Publicado: (2022)

Fresh and hardened properties of alkali-activated slag concrete: The effect of fly ash as a supplementary precursor
por: Sun, Yubo, et al.
Publicado: (2022)

Characterization and Comparison of Corrosion Layer Microstructure between Cement Mortar and Alkali-Activated Fly Ash/Slag Mortar Exposed to Sulfuric Acid and Acetic Acid
por: Zhao, Wenjing, et al.
Publicado: (2022)

Study on Shrinkage in Alkali-Activated Slag–Fly Ash Cementitious Materials
por: Cui, Peng, et al.
Publicado: (2023)

Aggregates Obtained by Alkali Activation of Fly Ash: The Effect of Granulation, Pelletization Methods and Curing Regimes
por: Rudić, Ognjen, et al.
Publicado: (2019)

Optimisation of GBFS, Fly Ash, and Nano-Silica Contents in Alkali-Activated Mortars
por: Algaifi, Hassan Amer, et al.
Publicado: (2021)

The Durability of Mortar Containing Alkali Activated Fly Ash-Based Lightweight Aggregate
por: Risdanareni, Puput, et al.
Publicado: (2021)

Setting, Strength, and Autogenous Shrinkage of Alkali-Activated Fly Ash and Slag Pastes: Effect of Slag Content
por: Nedeljković, Marija, et al.
Publicado: (2018)

Microstructural and Mechanical Characteristics of Alkali-Activated Binders Composed of Milled Fly Ash and Granulated Blast Furnace Slag with µ-Limestone Addition
por: Vázquez-Rodríguez, Francisco, et al.
Publicado: (2023)

Experimental Investigation on Ambient-Cured One-Part Alkali-Activated Binders Using Combined High-Calcium Fly Ash (HCFA) and Ground Granulated Blast Furnace Slag (GGBS)
por: Teo, Wee, et al.
Publicado: (2022)

Effect of Internal Curing by Super Absorbent Polymer on the Autogenous Shrinkage of Alkali-Activated Slag Mortars
por: Wang, Pengju, et al.
Publicado: (2020)

Influence of Different Parameters on the Performance of Alkali-Activated Slag/Fly Ash Composite System
por: Zhang, Zhipeng, et al.
Publicado: (2022)

Characteristics of Preplaced Aggregate Concrete Fabricated with Alkali-Activated Slag/Fly Ash Cements
por: Siddique, Salman, et al.
Publicado: (2021)

Strength Characteristics and Microstructure Analysis of Alkali-Activated Slag–Fly Ash Cementitious Material
por: Zhu, Chenhui, et al.
Publicado: (2022)

Influence of Water Content on Mechanical Strength and Microstructure of Alkali-Activated Fly Ash/GGBFS Mortars Cured at Cold and Polar Regions
por: Wei, Xiaobin, et al.
Publicado: (2019)

Study on the Compressive Strength of Alkali Activated Fly Ash and Slag under the Different Silicate Structure
por: Wang, Zhipu, et al.
Publicado: (2021)

Influence of the Fly Ash Content on the Fresh and Hardened Properties of Alkali-Activated Slag Pastes with Admixtures
por: de Hita, María Jimena, et al.
Publicado: (2022)

Study of the Mechanical Properties and Microstructure of Alkali-Activated Fly Ash–Slag Composite Cementitious Materials
por: Lv, Yigang, et al.
Publicado: (2023)

The Impact of Chloride and Sulphate Aggressiveness on the Microstructure and Phase Composition of Fly Ash-Slag Mortar
por: Falaciński, Paweł, et al.
Publicado: (2021)

Strength Characteristics of Alkali-Activated Slag Mortars with the Addition of PET Flakes
por: Kocot, Agnieszka, et al.
Publicado: (2021)

Effect of Heat Curing Method on the Mechanical Strength of Alkali-Activated Slag Mortar after High-Temperature Exposure
por: Tran, Tai Thanh, et al.
Publicado: (2019)

Long-Term Strength Development of Fly Ash-Based One-Part Alkali-Activated Binders
por: Haruna, Sani, et al.
Publicado: (2021)

The Effects of Partial Replacement of Ground Granulated Blast Furnace Slag by Ground Wood Ash on Alkali-Activated Binder Systems
por: Teker Ercan, Ece Ezgi, et al.
Publicado: (2023)

The Characterization of Fixation of Ba, Pb, and Cu in Alkali-Activated Fly Ash/Blast Furnace Slag Matrix
por: Koplík, Jan, et al.
Publicado: (2016)

Investigation of the Effect of Mixing Time on the Mechanical Properties of Alkali-Activated Cement Mixed with Fly Ash and Slag
por: Kim, Taewan, et al.
Publicado: (2021)

Exploration of Carbon Dioxide Curing of Low Reactive Alkali-Activated Fly Ash
por: Harirchi, Peyman, et al.
Publicado: (2022)

Influence of Silica Modulus and Curing Temperature on the Strength of Alkali-Activated Volcanic Ash and Limestone Powder Mortar
por: Adewumi, Adeshina Adewale, et al.
Publicado: (2021)

Properties of Alkali-Activated Slag Cement Activated by Weakly Alkaline Activator
por: He, Juan, et al.
Publicado: (2023)

Rheological and the Fresh State Properties of Alkali-Activated Mortars by Blast Furnace Slag
por: Marvila, Markssuel Teixeira, et al.
Publicado: (2021)

Strengthening Behavior of Cemented Paste Backfill Using Alkali-Activated Slag Binders and Bottom Ash Based on the Response Surface Method
por: Sun, Qi, et al.
Publicado: (2020)

Optimization of Alkali-Activated Municipal Slag Composite Performance by Substituting Varying Ratios of Fly Ash for Fine Aggregate
por: El-Wafa, Mahmoud Abo, et al.
Publicado: (2021)

Effect of Waste Ceramic Powder on the Properties of Alkali–Activated Slag and Fly Ash Pastes Exposed to High Temperature
por: Zhang, Gui-Yu, et al.
Publicado: (2021)

Study on the Pore and Microstructure Fractal Characteristics of Alkali-Activated Coal Gangue-Slag Mortars
por: Ma, Hongqiang, et al.
Publicado: (2020)

Cannot write session to /tmp/vufind_sessions/sess_0hagtl9mv4t044fbadm3flbauj