Effect of Short Glass Fiber Addition on Flexural and Impact Behavior of 3D Printed Polymer Composites

[Image: see text] Fused deposition modeling (FDM), one of the most widely used additive manufacturing (AM) processes, is used for fabrication of 3D models from computer-aided design data using various materials for a wide scope of applications. The principle of FDM or, in general, AM plays an important role in minimizing the ill effects of manufacturing on the environment. Among the various available reinforcements, short glass fiber (SGF), one of the strong reinforcement materials available, is used as a reinforcement in the acrylonitrile butadiene styrene (ABS) matrix. At the outset, very limited research has been carried out till date in the analysis of the impact and flexural strength of the SGF-reinforced ABS polymer composite developed by the FDM process. In this regard, the present research investigates the impact and flexural strength of SGF–ABS polymer composites by the addition of 15 and 30 wt % SGF to ABS. The tests were conducted as per ASTM standards. Increments in flexural and impact properties were observed with the addition of SGF to ABS. The increment of 42% in impact strength was noted for the addition of 15 wt % SGF and 54% increase with the addition of 30 wt % SGF. On similar lines, flexural properties also showed improved values of 44 and 59% for the addition of 15 and 30 wt % SGF to ABS. SGF addition greatly enhanced the properties of flexural and impact strength and has paved the path for the exploration of varied values of reinforcement into the matrix.