Cargando…
Degradation of Steel Rebar Tensile Properties Affected by Longitudinal Non-Uniform Corrosion
Rebar corrosion is the primary cause of the durability degradation of reinforced concrete (RC) structures, where non-uniform corrosion is the typical pattern in engineering. This study experimentally and numerically investigated the tensile degradation properties of non-uniform corroded rebars. Corr...
Autores principales: | , , |
---|---|
Formato: | Online Artículo Texto |
Lenguaje: | English |
Publicado: |
MDPI
2023
|
Materias: | |
Acceso en línea: | https://www.ncbi.nlm.nih.gov/pmc/articles/PMC10095783/ https://www.ncbi.nlm.nih.gov/pubmed/37049211 http://dx.doi.org/10.3390/ma16072917 |
Sumario: | Rebar corrosion is the primary cause of the durability degradation of reinforced concrete (RC) structures, where non-uniform corrosion is the typical pattern in engineering. This study experimentally and numerically investigated the tensile degradation properties of non-uniform corroded rebars. Corrosion morphology was accurately determined by three-dimensional (3D) laser scanning techniques, studying the characteristics of longitudinal non-uniform corrosion. The results showed that the non-uniformity of corrosion increased with an increase in corrosion levels. From tensile tests, the differences in nominal stress–strain curves among rebars with similar average corrosion levels indicated that corrosion non-uniformity has appreciable effects on the tensile behavior of rebars. The residual load-bearing capacity of corroded rebars was dominated by the reduced critical cross-section, while residual ductility was associated with the cross-section loss throughout the entire length of rebars. The degradation relations of nominal yield and ultimate strength, ultimate strain, and elongation after fracture were better correlated to the maximum cross-section loss than to the average volume loss. Additionally, numerical calculation based on the cross-sectional areas of corroded rebars was conducted to evaluate the tensile behavior of non-uniform corroded rebars. Equivalent distribution models simulating the longitudinal non-uniform corrosion were proposed, on the basis of probability characteristics of cross-sectional areas, for practical application of the numerical method. |
---|