Cargando…

Synthesis, Microstructure Investigation, Mechanical and Tribological Behaviour of the AA5083–WC Composite

In this study, AA5083–WC composites were developed by ball milling followed by hot consolidation. The microstructures of the developed composites were investigated using XRD, SEM, EDX, and EBSD. The developed composites exhibited a homogeneous dispersion of WC particulates in the AA5083 matrix witho...

Descripción completa

Detalles Bibliográficos
Autores principales:	Ammar, Hany R., Sivasankaran, Subbarayan, Sherif, El-Sayed M., Almufadi, Fahad A., Mekky, Abdel-baset H.
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2023
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC10096134/ https://www.ncbi.nlm.nih.gov/pubmed/37049185 http://dx.doi.org/10.3390/ma16072891

Ejemplares similares

Developing Improved Corrosion-Resistant AA5083—BN/WC Composites for Tribological Applications
por: Ammar, Hany R., et al.
Publicado: (2023)

Effect of Al(2)O(3) (x = 0, 1, 2, and 3 vol.%) in CrFeCuMnNi-x High-Entropy Alloy Matrix Composites on their Microstructure and Mechanical and Wear Performance
por: Sivasankaran, S., et al.
Publicado: (2023)

Investigation of the Microstructure and Compressibility of Biodegradable Fe-Mn-Cu/W/Co Nanostructured Alloy Powders Synthesized by Mechanical Alloying
por: Ammar, Hany R., et al.
Publicado: (2021)

Microstructure and Mechanical Properties of Dissimilar Friction Stir Welded Joint AA7020/AA5083 with Different Joining Parameters
por: Torzewski, Janusz, et al.
Publicado: (2022)

Effect of Heat Treatment on the Microstructure and Mechanical Properties of Rotary Friction Welded AA7075 and AA5083 Dissimilar Joint
por: Mahajan, Aditya M., et al.
Publicado: (2023)

Microstructure and Low Cycle Fatigue Properties of AA5083 H111 Friction Stir Welded Joint
por: Torzewski, Janusz, et al.
Publicado: (2020)

Investigation on mechanical properties and corrosion resistance of Ti-modified AA5083 aluminum alloy for aerospace and automotive applications
por: Alghannam, Abdullah A., et al.
Publicado: (2023)

Experimental study on high temperature tensile behaviour of aluminium alloy AA5083 with oscillating load
por: Shirinzadeh Dastgiri, Mohammad, et al.
Publicado: (2023)

Comparative analysis of experimental and numerical investigation on multiple projectile impact of AA5083 friction stir welded targets
por: Balaji, S., et al.
Publicado: (2023)

Mechanical and Tribological Characterization of WC-Co and WC-AISI 304 Composites by a Newly Developed Equipment
por: Vilhena, Luís, et al.
Publicado: (2022)

Effect of Laser Processing Parameters on Microstructure, Hardness and Tribology of NiCrCoFeCBSi/WC Coatings
por: Škamat, Jelena, et al.
Publicado: (2021)

Synthesis and Multi Scale Tribological Behavior of WC-Co/Nanodiamond Nanocomposites
por: Nieto, Andy, et al.
Publicado: (2017)

Lotus-Inspired Multiscale Superhydrophobic AA5083 Resisting Surface Contamination and Marine Corrosion Attack
por: Zhang, Binbin, et al.
Publicado: (2019)

Comparative Study of FSW, MIG, and TIG Welding of AA5083-H111 Based on the Evaluation of Welded Joints and Economic Aspect
por: Habba, Mohamed I. A., et al.
Publicado: (2023)

Effect of Textured Dimples on the Tribological Behavior of WC/Co Cemented Carbide in Dry Sliding with Al(2)O(3)/WC Ceramic
por: Chen, Jiansong, et al.
Publicado: (2022)

Influence of Heat Treatment and Reinforcements on Tensile Characteristics of Aluminium AA 5083/Silicon Carbide/Fly Ash Composites
por: Nagaraja, Santhosh, et al.
Publicado: (2021)

Data on microhardness and structural analysis of friction stir spot welded lap joints of AA5083-H116
por: Akinlabi, Esther T., et al.
Publicado: (2020)

High-Cycle Fatigue Behaviour of the Aluminium Alloy 5083-H111
por: Nečemer, Branko, et al.
Publicado: (2023)

Microstructure and Properties of WC/Ni-Based Laser-Clad Coatings with Different WC Content Values
por: Shen, Xuehui, et al.
Publicado: (2022)

Microstructure Investigation of WC-Based Coatings Prepared by HVOF onto AZ31 Substrate
por: Jonda, Ewa, et al.
Publicado: (2021)

Influence of the Fly Ash Material Inoculants on the Tensile and Impact Characteristics of the Aluminum AA 5083/7.5SiC Composites
por: Nagaraja, Santhosh, et al.
Publicado: (2021)

A New Approach in Surface Modification and Surface Hardening of Aluminum Alloys Using Friction Stir Process: Cu-Reinforced AA5083
por: Papantoniou, Ioannis G., et al.
Publicado: (2020)

Microstructural and Mechanical Characterization of Additive Friction Stir-Deposition of Aluminum Alloy 5083 Effect of Lubrication on Material Anisotropy
por: Phillips, Brandon J., et al.
Publicado: (2021)

Printability and Microstructure of Selective Laser Melting of WC/Co/Cr Powder
por: Campanelli, Sabina Luisa, et al.
Publicado: (2019)

Experiment-based modelling of grain boundary β-phase (Mg(2)Al(3)) evolution during sensitisation of aluminium alloy AA5083
por: Zhang, R., et al.
Publicado: (2017)

Surface Pretreatments of AA5083 Aluminum Alloy with Enhanced Corrosion Protection for Cerium-Based Conversion Coatings Application: Combined Experimental and Computational Analysis
por: Shishesaz, Mohammad Reza, et al.
Publicado: (2021)

Comparing the Corrosion Resistance of 5083 Al and Al(2)O(3)3D/5083 Al Composite in a Chloride Environment
por: Yu, Liang, et al.
Publicado: (2022)

Finished rings in AW5083 for CMS external cylinders
por: Dembiermont
Publicado: (2001)

Investigation of the Hot Stamping-in-Die Quenching Composite Forming Process of 5083 Aluminum Alloy Skin
por: Yi, Lingling, et al.
Publicado: (2023)

Investigation on Microstructure, Mechanical and Wear Properties of HVOF Sprayed Composite Coatings (WC–Co + CR) On Ductile Cast Iron
por: Ksiazek, Marzanna, et al.
Publicado: (2021)

Tribological Characterization of Micron-/Nano-Sized WC-9%Co Cemented Carbides Prepared by Spark Plasma Sintering at Elevated Temperatures
por: Wohaibi, Saleh Al, et al.
Publicado: (2019)

Evaluation of Mechanical and Tribological Aspect of Self-Lubricating Cu-6Gr Composites Reinforced with SiC–WC Hybrid Particles
por: Usca, Üsame Ali, et al.
Publicado: (2022)

Crack Restraining Methods and their Effects on the Microstructures and Properties of Laser Cladded WC/Fe Coatings
por: Dai, Qiu-Lian, et al.
Publicado: (2018)

Microstructure and Mechanical Properties of HfC-SiC Ceramics Influenced by WC Addition
por: Cheng, Yue, et al.
Publicado: (2023)

Investigation of the Mechanical and Tribological Behavior of Epoxy-Based Hybrid Composite
por: Albahkali, Thamer, et al.
Publicado: (2023)

Tribological Properties of Solid Solution Strengthened Laser Cladded NiCrBSi/WC-12Co Metal Matrix Composite Coatings
por: Bergant, Zoran, et al.
Publicado: (2022)

Investigation of the Tribological Behavior and Microstructure of Plasma-Cladded Fe–Cr–Mo–Ni–B Coating
por: Chen, Junfu, et al.
Publicado: (2022)

Mechanical Performance and Corrosion Behaviour of Diffusion-Bonded A5083 Aluminium and A36 Mild Steel with Gallium Interlayer
por: Ismail, Asmawi, et al.
Publicado: (2022)

Investigation of the Tribological Behaviour of Various AMC Surfaces against Brake Lining Material
por: Hirsch, Sarah Johanna, et al.
Publicado: (2023)

Investigation of the Implementation of Laser Surface Alloying of Cu with Cr–WC
por: Domagała-Dubiel, Justyna, et al.
Publicado: (2022)

Cannot write session to /tmp/vufind_sessions/sess_avk4ga0cm76spcccgm4i0njgr6