Cargando…

Novel Airflow-Field-Driven Melt Spinning 3D Printing of Tubular Scaffolds Based on Polycaprolactone Blends

The fabrication of various 3D tissue engineering tubular scaffolds with fibrous structures, to assist the human body in rapidly repairing a variety of ailments, is receiving more and more attention. Due to the inefficiency of the majority of fibrous preparation techniques, the question of how to rap...

Descripción completa

Detalles Bibliográficos
Autores principales: Zhang, Junyuan, Peng, Zilong, Wang, Mengjie, Li, Yinan, Wu, Jinyin, Jiang, Yifan, Liu, Chaolong, Li, Guqiang, Xu, Lin, Lan, Hongbo
Formato: Online Artículo Texto
Lenguaje:English
Publicado: MDPI 2023
Materias:
Acceso en línea:https://www.ncbi.nlm.nih.gov/pmc/articles/PMC10097219/
https://www.ncbi.nlm.nih.gov/pubmed/37050370
http://dx.doi.org/10.3390/polym15071755
Descripción
Sumario:The fabrication of various 3D tissue engineering tubular scaffolds with fibrous structures, to assist the human body in rapidly repairing a variety of ailments, is receiving more and more attention. Due to the inefficiency of the majority of fibrous preparation techniques, the question of how to rapidly produce the requisite three-dimensional tubular microfiber scaffold structures has become an urgent problem. In this study, an efficient polymer fiber preparation method was developed, using a high-speed airflow drive. Melt blending of polycaprolactone (PCL), polylactic acid (PLA), and tributyl citrate (TBC), was used for the printing material, to achieve the efficient preparation of tubular microfiber scaffolds with different structures. The scaffold diameter was as small as 2 mm, the wall thickness was up to 100 μm, and the fiber injection efficiency reached 15.48 g/h. By utilizing simulations to optimize the printing parameters and by adjusting the printing settings, it was possible to achieve a controlled fiber diameter in the range of 3 μm to 15 μm. In addition, plasma treatment was applied to the microfibers’ surface, to increase their wettability, and the efficiency of the hydrophilic modification was demonstrated. Furthermore, the mechanical property test demonstrated that the fibers have a tensile strength of 1.36 ± 0.16 MPa and a tensile strain of 30.8 ± 3.5%. The radial compressive strain of the tubular scaffold could reach 60% of the original scaffold’s diameter. Finally, the in vitro degradation of the fibers at various pH values was tested. The results showed that, under alkaline conditions, the surface of the fibers would be severely crushed and the rate of deterioration would increase.