Cargando…

Effects of Cu Addition on Age Hardening Behavior and Mechanical Properties of High-Strength Al-1.2Mg-1.2Si Alloy

In this study, the effects of Cu addition on artificial age hardening behavior and mechanical properties of Al-1.2Mg-1.2Si-(xCu) alloy was investigated quantitatively and qualitatively by Vickers hardness, tensile test, and transmission electron microscope. The results indicated that Cu addition enh...

Descripción completa

Detalles Bibliográficos
Autores principales:	Zhang, Xu, Yan, Lizhen, Li, Zhihui, Li, Xiwu, Gao, Guanjun, Yan, Hongwei, Wen, Kai, Zhang, Yongan, Xiong, Baiqing
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2023
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC10142078/ https://www.ncbi.nlm.nih.gov/pubmed/37109962 http://dx.doi.org/10.3390/ma16083126

Ejemplares similares

Microstructure, Precipitates Behavior, and Mechanical Properties of Age-Hardened Al-Mg-Si Alloy Sheet Fabricated by Twin-Roll Casting
por: Gao, Guanjun, et al.
Publicado: (2022)

Constitutive Analysis and Microstructure Characteristics of As-Homogenized 2198 Al–Li Alloy under Different Hot Compression Deformation Conditions
por: Li, Huiyu, et al.
Publicado: (2023)

Precipitation Hardening at Elevated Temperatures above 400 °C and Subsequent Natural Age Hardening of Commercial Al–Si–Cu Alloy
por: Li, Ruoqi, et al.
Publicado: (2021)

Recovery of strain-hardening rate in Ni-Si alloys
por: Yang, C. L., et al.
Publicado: (2015)

Impact of the Direct Ageing Procedure on the Age Hardening Response of Al-Mg-Si 6101 Alloy
por: Osuch, Piotr, et al.
Publicado: (2018)

Fretting Fatigue Experiment and Analysis of AlSi9Cu2Mg Alloy
por: Wang, Jun, et al.
Publicado: (2016)

Effects of the Mg/Si Ratio on Microstructure, Mechanical Properties, and Precipitation Behavior of Al–Mg–Si–1.0 wt %-Zn Alloys
por: Li, Yong, et al.
Publicado: (2018)

Differences in Dry Sliding Wear Behavior between Al–12Si–CuNiMg Alloy and Its Composite Reinforced with Al(2)O(3) Fibers
por: Zhang, Qing, et al.
Publicado: (2019)

Microstructural Characterization of the As-Cast and Homogenized Al-Cu-Mg-Ag Alloy
por: Lin, Haitao, et al.
Publicado: (2023)

Quantitative approach to realization of ultrasonic grain refinement of Al-7Si-2Cu-1Mg alloy
por: Kim, Soo-Bae, et al.
Publicado: (2019)

Effects of the Quenching Rate on the Microstructure, Mechanical Properties and Paint Bake-Hardening Response of Al–Mg–Si Automotive Sheets
por: Gao, Guanjun, et al.
Publicado: (2019)

Formation of strength platform in cast Al–Si–Mg–Cu alloys
por: Dong, Xixi, et al.
Publicado: (2019)

A First-Principles Study of the Cu-Containing β″ Precipitates in Al-Mg-Si-Cu Alloy
por: He, Shaozhi, et al.
Publicado: (2021)

Hardness data related to pre-ageing, natural secondary ageing, and paint bake hardening in Al-Mg-Si alloys
por: Yang, Zi, et al.
Publicado: (2019)

Revealing the Effect of Local Connectivity of Rigid Phases during Deformation at High Temperature of Cast AlSi12Cu4Ni(2,3)Mg Alloys
por: Bugelnig, Katrin, et al.
Publicado: (2018)

Microstructure Evolution of AlSi10Mg(Cu) Alloy Related to Isothermal Exposure
por: Cai, Cheng, et al.
Publicado: (2018)

Work Hardening Behavior and Microstructure Evolution of a Cu-Ti-Cr-Mg Alloy during Room Temperature and Cryogenic Rolling
por: Li, Rong, et al.
Publicado: (2023)

Kinetic Monte Carlo Simulation of Clustering in an Al-Mg-Si-Cu Alloy
por: Ye, Qilu, et al.
Publicado: (2021)

Intermetallics Formation during Solidification of Al-Si-Cu-Mg Cast Alloys
por: Mohamed, Adel M. A., et al.
Publicado: (2022)

The Effect of Cu Addition on the Precipitation Sequence in the Al-Si-Mg-Cr Alloy
por: Chen, Bin, et al.
Publicado: (2022)

Microstructure Evolution and Mechanical Properties of Al–Cu–Mg Alloys with Si Addition
por: Shah, Abdul Wahid, et al.
Publicado: (2023)

Microstructure and Mechanical Behavior of Quaternary Eutectic α+θ+Q+Si Clusters in As-Cast Al-Mg-Si-Cu Alloys
por: Li, Kai, et al.
Publicado: (2023)

A Yield Stress and Work Hardening Model of Al-Mg-Si Alloy Considering the Strengthening Effect of β” and β’ Precipitates
por: Zheng, Xiaoyu, et al.
Publicado: (2023)

First-Principles Study on Structure and Stability of GP Zones in Al-Mg-Si(-Cu) Alloy
por: Su, Yue, et al.
Publicado: (2023)

Effects of Rapid Quenching on Grain Boundary Microstructure and Mechanical Properties of an Al-Mg-Si-Cu Alloy
por: Yan, Qiao, et al.
Publicado: (2023)

Effects of Co Addition on the Properties and Microstructure of Cu-Ni-Si-P-Mg Alloys
por: Cheng, Jianyi, et al.
Publicado: (2021)

Effect of Final Thermomechanical Treatment on the Mechanical Properties and Microstructure of T Phase Hardened Al-5.8Mg-4.5Zn-0.5Cu Alloy
por: Tao, Kai, et al.
Publicado: (2023)

Novel Mg-ion conductive oxide of μ-cordierite Mg(0.6)Al(1.2)Si(1.8)O(6)
por: Takeda, Hayami, et al.
Publicado: (2020)

1,2-Dimorpholinoethane-1,2-dithione
por: Yu, Yan-Ping, et al.
Publicado: (2009)

Research Progress on Multi-Component Alloying and Heat Treatment of High Strength and Toughness Al–Si–Cu–Mg Cast Aluminum Alloys
por: Zhang, Mingshan, et al.
Publicado: (2023)

Influence of Si, Cu, B, and Trace Alloying Elements on the Conductivity of the Al-Si-Cu Alloy
por: Yang, Zhao, et al.
Publicado: (2022)

Structural and compositional study of precipitates in under-aged Cu-added Al-Mg-Si alloy
por: Maeda, Takuya, et al.
Publicado: (2018)

Enhancement of the Mechanical Properties in Al–Si–Cu–Fe–Mg Alloys with Various Processing Parameters
por: Ahn, Su-Seong, et al.
Publicado: (2018)

Effect of Boron Doping on Cellular Discontinuous Precipitation for Age-Hardenable Cu–Ti Alloys
por: Semboshi, Satoshi, et al.
Publicado: (2015)

Selected Properties of a Zr-Containing AlSi5Cu2Mg Alloy Intended for Cylinder Head Castings
por: Bolibruchová, Dana, et al.
Publicado: (2022)

Aging Response and Precipitation Behavior after 5% Pre-Deformation of an Al-Mg-Si-Cu Alloy
por: Jin, Shuoxun, et al.
Publicado: (2018)

Homogenization of Extrusion Billets of a Novel Al-Mg-Si-Cu Alloy with Increased Copper Content
por: Woźnicki, Antoni, et al.
Publicado: (2023)

Mg(OH)(2)‐Facilitated Liquid‐Phase Conversion of Lactic Acid into 1,2‐Propanediol over Cu: An Experimental and Theoretical Study
por: Wang, Xinde, et al.
Publicado: (2019)

Improved hydrogen storage kinetics of nanocrystalline and amorphous Ce–Mg–Ni-based CeMg(12)-type alloys synthesized by mechanical milling
por: Zhang, Yanghuan, et al.
Publicado: (2018)

Effect of Alloying Elements on the Stacking Fault Energy and Ductility in Mg(2)Si Intermetallic Compounds
por: Zhao, Xinpeng, et al.
Publicado: (2021)

Cannot write session to /tmp/vufind_sessions/sess_hhj5enjajt7lsji4j01ioiq0lh