Cargando…

Influence of Flank Wear on the Microstructure Characteristics of the GH4169 Metamorphic Layer under High-Pressure Cooling

Since the flank has an important influence on the surface of a workpiece, and as microstructure flaws of the surface metamorphic layer are a key factor that affects the service performance of a part, this work studied the influence of flank wear on the microstructure characteristics of the metamorph...

Descripción completa

Detalles Bibliográficos
Autores principales: Wei, Min, Wu, Mingyang, Xu, Jiamiao, Cheng, Yaonan
Formato: Online Artículo Texto
Lenguaje:English
Publicado: MDPI 2023
Materias:
Acceso en línea:https://www.ncbi.nlm.nih.gov/pmc/articles/PMC10146843/
https://www.ncbi.nlm.nih.gov/pubmed/37109780
http://dx.doi.org/10.3390/ma16082944
Descripción
Sumario:Since the flank has an important influence on the surface of a workpiece, and as microstructure flaws of the surface metamorphic layer are a key factor that affects the service performance of a part, this work studied the influence of flank wear on the microstructure characteristics of the metamorphic layer under the conditions of high-pressure cooling. First, Third Wave AdvantEdge was used to create a simulation model of cutting GH4169 using tools with different flank wears under high-pressure cooling. The simulation findings emphasized the impact of flank wear width (VB) on the cutting force, cutting temperature, plastic strain, and strain rate. Second, an experimental platform was established for cutting GH4169 under high-pressure cooling, and the cutting force during the machining process was recorded in real time and compared with the simulation results. Finally, an optical microscope was used to observe the metallographic structure of the GH4169 workpiece section. The microstructure characteristics of the workpiece were analyzed using a scanning electron microscope (SEM) and electron backscattered diffraction (EBSD). It was discovered that, as the flank wear width increased, so did the cutting force, cutting temperature, plastic strain, strain rate, and plastic deformation depth. The relative error between the simulation results of the cutting force and the experimental results was within 15%. At the same time, near the surface of the workpiece, there was a metamorphic layer with fuzzy grain boundaries and refined grain. With an increase in flank wear width, the thickness of the metamorphic layer increased from 4.5 μm to 8.7 μm and the grain refinement intensified. The high strain rate promoted recrystallization, which caused an increase in the average grain boundary misorientation and high-angle grain boundaries, as well as a reduction in twin boundaries.