Cargando…
FDM technology and the effect of printing parameters on the tensile strength of ABS parts
The effect of printing speed on the tensile strength of acrylonitrile butadiene styrene (ABS) samples fabricated using the fused deposition modelling (FDM) process is addressed in this research. The mechanical performance of FDM-ABS products was evaluated using four different printing speeds (10, 30...
Autores principales: | Daly, Mohamed, Tarfaoui, Mostapha, Chihi, Manel, Bouraoui, Chokri |
---|---|
Formato: | Online Artículo Texto |
Lenguaje: | English |
Publicado: |
Springer London
2023
|
Materias: | |
Acceso en línea: | https://www.ncbi.nlm.nih.gov/pmc/articles/PMC10150688/ https://www.ncbi.nlm.nih.gov/pubmed/37252263 http://dx.doi.org/10.1007/s00170-023-11486-y |
Ejemplares similares
-
Effect of CNTs Additives on the Energy Balance of Carbon/Epoxy Nanocomposites during Dynamic Compression Test
por: Chihi, Manel, et al.
Publicado: (2020) -
An Experimental Study on the Impact of Layer Height and Annealing Parameters on the Tensile Strength and Dimensional Accuracy of FDM 3D Printed Parts
por: Stojković, Jelena R., et al.
Publicado: (2023) -
Optimization of Fatigue Performance of FDM ABS and Nylon Printed Parts
por: Yankin, Andrey, et al.
Publicado: (2023) -
Optimisation of Strength Properties of FDM Printed Parts—A Critical Review
por: Syrlybayev, Daniyar, et al.
Publicado: (2021) -
The Influence of the Layer Height and the Filament Color on the Dimensional Accuracy and the Tensile Strength of FDM-Printed PLA Specimens
por: Frunzaverde, Doina, et al.
Publicado: (2023)