Design and Experimental Validation of a Switchable Frequency Selective Surface with Incorporated Control Network

Tunable/switchable devices are more and more required in modern communication systems. However, the realization of the tuning requires the presence of active devices, which in turn must be biased. The current paper comes up with a solution for designing and experimentally validating such a switchable Frequency Selective Surface. Two different metallic structures are simulated and measured, having incorporated the same topology control network (CN). In this scenario, the main innovation of this paper is the presence of the feeding part, namely the control network. In this work, the main FSS structure is flanked by three parallel CN microstrip lines and several via holes that allow biasing the active elements, namely PIN diodes. The switchability of the proposed structure is achieved through PIN diodes, whose bias determines the values of the elements in the equivalent circuit. At different biases, the response of the FSS changes accordingly. From all possible values of the bias, the extreme cases when the diodes act as (almost) short- and open-circuits are considered in the submitted manuscript for the sake of brevity. These cases are modeled by the main and cut-slot structures, respectively. The proposed structures have been evaluated using electromagnetic simulation and implemented on an FR4 substrate having a thickness of 1.58 mm. With the periodicity of the square-shaped unit cell of 18 mm edge length, different filtering bands are obtained below 12 GHz. Another novelty that has received very little consideration in the existing literature is the use of a finite array of unit cells instead of an infinite one. And finally, tests in an anechoic chamber have proved that there is a good agreement between practical and simulation results and also demonstrated the proper performance of the devices for wide angular incidence for both TE and TM polarizations.