Injectable sustained‐release poly(lactic‐co‐glycolic acid) (PLGA) microspheres of exenatide prepared by supercritical fluid extraction of emulsion process based on a design of experiment approach

This study aimed to develop an improved sustained‐release (SR) PLGA microsphere of exenatide using supercritical fluid extraction of emulsions (SFEE). As a translational research, we investigated the effect of various process parameters on the fabrication of exenatide‐loaded PLGA microspheres by SFEE (ELPM_SFEE) using the Box–Behnken design (BBD), a design of experiment approach. Further, ELPM obtained under optimized conditions and satisfying all the response criteria were compared with PLGA microspheres prepared using the conventional solvent evaporation (ELPM_SE) method through various solid‐state characterizations and in vitro and in vivo evaluations. The four process parameters selected as independent variables were pressure (X (1)), temperature (X (2)), stirring rate (X (3)), and flow ratio (X (4)). The effects of these independent variables on five responses, namely the particle size, its distribution (SPAN value), encapsulation efficiency (EE), initial drug burst release (IBR), and residual organic solvent, were evaluated using BBD. Based on the experimental results, a desirable range of combinations of various variables in the SFEE process was determined by graphical optimization. Solid‐state characterization and in vitro evaluation revealed that ELPM_SFEE improved properties, including a smaller particle size and SPAN value, higher EE, lower IBR, and lower residual solvent. Furthermore, the pharmacokinetic and pharmacodynamic study results indicated better in vivo efficacy with desirable SR properties, including a reduction in blood glucose levels, weight gain, and food intake, for ELPM_SFEE than those generated using SE. Therefore, the potential drawback of conventional technologies such as the SE for the preparation of injectable SR PLGA microspheres could be improved by optimizing the SFEE process.