Cargando…

Structure and Frictional Properties of Ultrahard AlMgB(14) Thin Coatings

This paper presents the results of studies on AlMgB(14)-based ceramic coatings deposited on WC-Co hard alloy substrates using RF plasma sputtering. The aim of this work is to study the structure, phase composition, and mechanical properties of AlMgB(14)-based coatings depending on the sputtering mod...

Descripción completa

Detalles Bibliográficos
Autores principales:	Tkachev, Dmitrii, Zhukov, Ilya, Nikitin, Pavel, Sachkov, Victor, Vorozhtsov, Alexander
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2023
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC10220629/ https://www.ncbi.nlm.nih.gov/pubmed/37242006 http://dx.doi.org/10.3390/nano13101589

Ejemplares similares

On the Tensile Strength of Spark Plasma Sintered AlMgB(14) Ceramics
por: Nikitin, Pavel, et al.
Publicado: (2022)

Experimental and Theoretical Study of Ultra-Hard AlMgB(14)-TiB(2) Composites: Structure, Hardness and Self-Lubricity
por: Nikitin, Pavel, et al.
Publicado: (2022)

On the Structure and Properties of AlMgB(14)-TiB(2) Composites Obtained from SHS Powders by Spark Plasma Sintering
por: Nikitin, Pavel, et al.
Publicado: (2021)

Phase Composition, Structure and Properties of the Spark Plasma Sintered Ceramics Obtained from the Al(12)Mg(17)-B-Si Powder Mixtures
por: Nikitin, Pavel, et al.
Publicado: (2022)

Hard and Highly Adhesive AlMgB(14) Coatings RF Sputtered on Tungsten Carbide and High-Speed Steel
por: Grishin, Alexander M., et al.
Publicado: (2023)

p-n Control of AlMgB(14)-Based Thermoelectric Materials by Metal Site Occupancy
por: Fujima, Takuya, et al.
Publicado: (2019)

The Study of HEMs Based on the Mechanically Activated Intermetallic Al(12)Mg(17) Powder
por: Sokolov, Sergei, et al.
Publicado: (2020)

Photocurable High-Energy Polymer-Based Materials for 3D Printing
por: Tkachev, Dmitrii, et al.
Publicado: (2023)

Enhancing steel properties through in situ formation of ultrahard ceramic surface
por: Pahlevani, Farshid, et al.
Publicado: (2016)

Ultrahard stitching of nanotwinned diamond and cubic boron nitride in C(2)-BN composite
por: Liu, Xiaobing, et al.
Publicado: (2016)

Influence of TiN Coating on the Drawing Force and Friction Coefficient in the Deep Drawing Process of AlMg4.5Mn0.7 Thin Sheets
por: Djordjević, Milan T., et al.
Publicado: (2023)

Prediction of Novel Ultrahard Phases in the B–C–N System from First Principles: Progress and Problems
por: Solozhenko, Vladimir L., et al.
Publicado: (2023)

Joining of Dissimilar Al and Mg Metal Alloys by Friction Stir Welding
por: Sidhu, Ramandeep Singh, et al.
Publicado: (2022)

Influence of Dy and Ho on the Phase Composition of the Ti-Al System Obtained by ‘Hydride Technology’
por: Karakchieva, Natalia, et al.
Publicado: (2022)

Enhancement of short/medium-range order and thermal conductivity in ultrahard sp(3) amorphous carbon by C(70) precursor
por: Shang, Yuchen, et al.
Publicado: (2023)

Effect of Mechanical Activation of Al-Ti-B Powder Mixture on Phase Composition and Structure of Al-TiB(2) Composite Materials Obtained by Self-Propagating High-Temperature Synthesis (SHS)
por: Matveev, Alexey, et al.
Publicado: (2022)

Effect of Different Tool Probe Profiles on Material Flow of Al–Mg–Cu Alloy Joined by Friction Stir Welding
por: Naumov, Anton, et al.
Publicado: (2021)

AlN Production in Co-Flow Filtration Mode at Low Pressures
por: Evseev, Nikolay, et al.
Publicado: (2021)

Self-lubricating, low-friction, wear-resistant Al-based quasicrystalline coatings
por: Silva Guedes de Lima, Bruno Alessandro, et al.
Publicado: (2016)

A Study on Dissimilar Friction Stir Welded between the Al–Li–Cu and the Al–Zn–Mg–Cu Alloys
por: Wu, Pengfei, et al.
Publicado: (2018)

Microstructure and Corrosion Behavior of Composite Coating on Pure Mg Acquired by Sliding Friction Treatment and Micro-Arc Oxidation
por: Cao, Huihui, et al.
Publicado: (2018)

A Connection Method between Ultrahard PtW8 Wire and a Au Thick Film Based on Parallel-Gap Resistance Microwelding
por: Pan, Mingqiang, et al.
Publicado: (2020)

Surface Degradation of Thin-Layer Al/MgF(2) Mirrors under Exposure to Powerful VUV Radiation
por: Skriabin, Andrei, et al.
Publicado: (2023)

Formation Investigation of Intermetallic Compounds of Thick Plate Al/Mg Alloys Joint by Friction Stir Welding
por: Xu, Yang, et al.
Publicado: (2019)

Friction-Stir Welding of a Wrought Al-Si-Mg Alloy in As-Fabricated and Heat-Treatment States
por: Wang, Chunxia, et al.
Publicado: (2020)

Fractal Dimension Characterization of Joint Surface Morphology on Dissimilar Friction Stir Lap Welding of Al/Mg
por: Zhao, Yadong, et al.
Publicado: (2019)

Analysis of Friction Stir Welding Tool Offset on the Bonding and Properties of Al–Mg–Si Alloy T-Joints
por: Memon, Shabbir, et al.
Publicado: (2021)

Understanding the friction of atomically thin layered materials
por: Andersson, David, et al.
Publicado: (2020)

Porosity Formation in Thin Welded Joints of Al–MG–LI Alloys
por: Olshanskaya, Tatyana, et al.
Publicado: (2022)

Effect of Zn and Mg Content on Crashworthiness of Al-Zn-Mg Alloy Thin-Walled Square Extrusions
por: Guo, Hui, et al.
Publicado: (2020)

The effect of texture and grain size on improving the mechanical properties of Mg-Al-Zn alloys by friction stir processing
por: Peng, Jinhua, et al.
Publicado: (2018)

Osteogenesis, angiogenesis and immune response of Mg-Al layered double hydroxide coating on pure Mg
por: Cheng, Shi, et al.
Publicado: (2020)

Polaronic Contributions to Friction in a Manganite Thin Film
por: Weber, Niklas A., et al.
Publicado: (2021)

Microstructure and Corrosion Behavior of Friction Stir-Welded 6061 Al/AZ31 Mg Joints with a Zr Interlayer
por: Zheng, Yang, et al.
Publicado: (2019)

Impact of Impulses on Microstructural Evolution and Mechanical Performance of Al-Mg-Si Alloy Joined by Impulse Friction Stir Welding
por: Morozova, Iuliia, et al.
Publicado: (2021)

Multipass Friction Stir Processing of Laser-Powder Bed Fusion AlSi10Mg: Microstructure and Mechanical Properties
por: Heidarzadeh, Akbar, et al.
Publicado: (2023)

The Influence of Scandium on the Composition and Structure of the Ti-Al Alloy Obtained by “Hydride Technology”
por: Karakchieva, Natalia, et al.
Publicado: (2021)

Effect of Boron and Vanadium Addition on Friction-Wear Properties of the Coating AlCrN for Special Applications
por: Nguyen, Huu Chien, et al.
Publicado: (2021)

Role of 5 wt.% Mg Alloying in Al on Corrosion Characteristics of Al-Mg Coating Deposited by Plasma Arc Thermal Spray Process
por: Jeong, Hwa-Rang, et al.
Publicado: (2023)

Induced Superconducting Transition in Ultra-Thin Iron-Selenide Films by a Mg-Coating Process
por: Cao, Zhiqiang, et al.
Publicado: (2021)

Cannot write session to /tmp/vufind_sessions/sess_cqm9i7l1cqrsf5cfdff4vh9cd5