Cargando…

Effect of Boron on the Microstructure, Superplastic Behavior, and Mechanical Properties of Ti-4Al-3Mo-1V Alloy

The decrease of superplastic forming temperature and improvement of post-forming mechanical properties are important issues for titanium-based alloys. Ultrafine-grained and homogeneous microstructure are required to improve both processing and mechanical properties. This study focuses on the influen...

Descripción completa

Detalles Bibliográficos
Autores principales:	Postnikova, Maria N., Kotov, Anton D., Bazlov, Andrey I., Mosleh, Ahmed O., Medvedeva, Svetlana V., Mikhaylovskaya, Anastasia V.
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2023
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC10221323/ https://www.ncbi.nlm.nih.gov/pubmed/37241341 http://dx.doi.org/10.3390/ma16103714

Ejemplares similares

Superplasticity of Ti-6Al-4V Titanium Alloy: Microstructure Evolution and Constitutive Modelling
por: Mosleh, Ahmed O., et al.
Publicado: (2019)

Microstructure Evolution, Constitutive Modelling, and Superplastic Forming of Experimental 6XXX-Type Alloys Processed with Different Thermomechanical Treatments
por: Mochugovskiy, Andrey G., et al.
Publicado: (2023)

High Strain Rate Superplasticity in Al-Zn-Mg-Based Alloy: Microstructural Design, Deformation Behavior, and Modeling
por: Yakovtseva, Olga, et al.
Publicado: (2020)

A High-Strain-Rate Superplasticity of the Al-Mg-Si-Zr-Sc Alloy with Ni Addition
por: Mochugovskiy, Andrey, et al.
Publicado: (2021)

Effect of Multidirectional Forging on the Grain Structure and Mechanical Properties of the Al–Mg–Mn Alloy
por: Kishchik, Mikhail S., et al.
Publicado: (2018)

Boronization and Carburization of Superplastic Stainless Steel and Titanium-Based Alloys
por: Matsushita, Masafumi
Publicado: (2011)

Low-Temperature Superplasticity and Deformation Mechanism of Ti-6Al-4V Alloy
por: Zhou, Ge, et al.
Publicado: (2018)

Superplastic Deformation Mechanisms of Superfine/Nanocrystalline Duplex PM-TiAl-Based Alloy
por: Gong, Xuebo, et al.
Publicado: (2017)

Superplasticity of alloys, intermetallides and ceramics
por: Kaibyshev, Oscar A
Publicado: (1992)

Microstructure and Texture Evolution during Superplastic Deformation of SP700 Titanium Alloy
por: Tian, Ning, et al.
Publicado: (2022)

Low-Temperature Superplasticity and High Strength in the Al 2024 Alloy with Ultrafine Grains
por: Bobruk, Elena V., et al.
Publicado: (2023)

The Microstructure and Strength of UFG 6060 Alloy after Superplastic Deformation at a Lower Homologous Temperature
por: Bobruk, Elena V., et al.
Publicado: (2022)

Superplastic Behavior and Microstructural Features of the VT6 Titanium Alloy with an Ultrafine-Grained Structure during Upsetting
por: Dyakonov, Grigory S., et al.
Publicado: (2023)

Microstructures and Phases in Electron Beam Additively Manufactured Ti-Al-Mo-Zr-V/CuAl9Mn2 Alloy
por: Zykova, Anna, et al.
Publicado: (2023)

Superplastic Deformation Mechanisms in Fine-Grained 2050 Al-Cu-Li Alloys
por: Li, Hongping, et al.
Publicado: (2020)

Rheological Law and Mechanism for Superplastic Deformation of Ti–6Al–4V
por: Liu, Chao, et al.
Publicado: (2019)

Kinetic Diffusion Couple for Mapping Microstructural and Mechanical Data on Ti–Al–Mo Titanium Alloys
por: Chen, Yi, et al.
Publicado: (2018)

Room-Temperature Superplasticity in an Ultrafine-Grained Magnesium Alloy
por: Edalati, Kaveh, et al.
Publicado: (2017)

The improved properties and microstructure of β-solidify TiAl alloys by boron addition and multi steps forging process
por: Xiao, Shulong, et al.
Publicado: (2019)

Microstructure and Mechanical Properties of β-Titanium Ti-15Mo Alloy Produced by Combined Processing including ECAP-Conform and Drawing
por: Gatina, Svetlana A., et al.
Publicado: (2022)

Superplastic Deformation of Al–Cu Alloys after Grain Refinement by Extrusion Combined with Reversible Torsion
por: Rodak, Kinga, et al.
Publicado: (2020)

On the role of composition and processing parameters on the microstructure evolution of Ti-xMo alloys
por: Mendoza, Michael. Y., et al.
Publicado: (2019)

Microstructure and Mechanical Properties of Hot-Extruded Mg–Zn–Ga–(Y) Biodegradable Alloys
por: Bazhenov, Viacheslav, et al.
Publicado: (2022)

Effect of Repetitive Bending and Straightening Process on Microstructure Properties and Deformation Mechanism of a Ti–Al–Cr–Mo Alloy
por: Li, Zhuoliang, et al.
Publicado: (2023)

Superplasticity in a lean Fe-Mn-Al steel
por: Han, Jeongho, et al.
Publicado: (2017)

Microstructural and Mechanical Properties of Binary Ti-Rich Fe–Ti, Al-Rich Fe–Al, and Ti–Al Alloys
por: Chanbi, Daoud, et al.
Publicado: (2019)

Microstructure and Properties of Ti-Zr-Mo Alloys Fabricated by Laser Directed Energy Deposition
por: Zhang, Jingtao, et al.
Publicado: (2023)

Effects of TiAl Alloy as a Binder on Cubic Boron Nitride Composites
por: Liu, Yuxi, et al.
Publicado: (2021)

Bearing Aluminum-Based Alloys: Microstructure, Mechanical Characterizations, and Experiment-Based Modeling Approach
por: Mosleh, Ahmed O., et al.
Publicado: (2022)

Superplasticity in an organic crystal
por: Takamizawa, Satoshi, et al.
Publicado: (2018)

Ultrahigh high-strain-rate superplasticity in a nanostructured high-entropy alloy
por: Nguyen, Nhung Thi-Cam, et al.
Publicado: (2020)

Investigation of Effect of Preliminary Annealing on Superplasticity of Ultrafine-Grained Conductor Aluminum Alloys Al-0.5%Mg-Sc
por: Gryaznov, Mikhail, et al.
Publicado: (2021)

Influence of Friction Stir Process on the Physical, Microstructural, Corrosive, and Electrical Properties of an Al–Mg Alloy Modified with Ti–B Additives
por: Moustafa, Essam B., et al.
Publicado: (2022)

Transition from poor ductility to room-temperature superplasticity in a nanostructured aluminum alloy
por: Edalati, Kaveh, et al.
Publicado: (2018)

Efficient Coarse‐Grained Superplasticity of a Gigapascal Lightweight Refractory Medium Entropy Alloy
por: Jia, Yuefei, et al.
Publicado: (2023)

Micrograin Superplasticity: Characteristics and Utilization
por: Mohamed, Farghalli A.
Publicado: (2011)

Cavitation During Superplastic Forming
por: Campbell, John
Publicado: (2011)

Publisher Correction: Superplasticity in a lean Fe-Mn-Al steel
por: Han, Jeongho, et al.
Publicado: (2018)

Microstructural Evolution in High-Strain-Rate Deformation of Ti-5Al-5Mo-5V-1Cr-1Fe Alloy
por: Ran, Chun, et al.
Publicado: (2018)

The Effect of EBM Process Parameters on Porosity and Microstructure of Ti-5Al-5Mo-5V-1Cr-1Fe Alloy
por: Kurzynowski, Tomasz, et al.
Publicado: (2019)

Cannot write session to /tmp/vufind_sessions/sess_plq40i5e2bu880gbbeudv2q0t6