Cargando…

Microstructural Changes Caused by the Creep Test in ZK60 Alloy Reinforced by SiC(p) at Intermediate Temperature after KOBO Extrusion and Aging

In this study, we investigated the creep properties of ZK60 alloy and a ZK60/SiC(p) composite at 200 °C and 250 °C in the 10–80 MPa stress range after the KOBO extrusion and precipitation hardening process. The true stress exponent was obtained in the range of 1.6–2.3 for both the unreinforced alloy...

Descripción completa

Detalles Bibliográficos
Autores principales:	Wang, Yang-Yang, Jia, Chen, Xu, Min, Kaseem, Mosab, Tayebi, Morteza
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2023
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC10222035/ https://www.ncbi.nlm.nih.gov/pubmed/37241511 http://dx.doi.org/10.3390/ma16103885

Ejemplares similares

Microstructural Evolution during Accelerated Tensile Creep Test of ZK60/SiC(p) Composite after KoBo Extrusion
por: Wang, Yang-Yang, et al.
Publicado: (2022)

Microstructure and Corrosion of Cast Magnesium Alloy ZK60 in NaCl Solution
por: Li, Zhen, et al.
Publicado: (2020)

Dry Wear Behaviour of the New ZK60/AlN/SiC Particle Reinforced Composites
por: Sager, Abdulmuaen, et al.
Publicado: (2022)

Effect of heat treatment on mechanical and biodegradable properties of an extruded ZK60 alloy
por: Chen, Junxiu, et al.
Publicado: (2016)

The Influence of Conventional or KOBO Extrusion Process on the Properties of AZ91 (MgAl9Zn1) Alloy
por: Długosz, Piotr, et al.
Publicado: (2021)

Twinning Behavior, Microstructure Evolution and Mechanical Property of Random-Orientated ZK60 Mg Alloy Compressed at Room Temperature
por: Zhang, Chengyu, et al.
Publicado: (2023)

Biodegradation behavior of magnesium and ZK60 alloy in artificial urine and rat models
por: Zhang, Shiying, et al.
Publicado: (2017)

Mechanism for corrosion protection of β-TCP reinforced ZK60 via laser rapid solidification
por: Deng, Youwen, et al.
Publicado: (2017)

Effect of the Strain Rate on the Damping and Mechanical Properties of a ZK60 Magnesium Alloy
por: Feng, Xuhui, et al.
Publicado: (2020)

Modification of the Tensile Performance of an Extruded ZK60 Magnesium Alloy with the Addition of Rare Earth Elements
por: Najafi, Soroush, et al.
Publicado: (2023)

Effects of Texture and Grain Size on the Yield Strength of ZK61 Alloy Rods Processed by Cyclic Extrusion and Compression
por: Zhang, Lixin, et al.
Publicado: (2017)

Effects of Aging Process on the Damping Performance of ZK60 Magnesium Alloys Prepared by Large Strain Rolling
por: Feng, Xuhui, et al.
Publicado: (2020)

Microstructure and Mechanical Properties of Friction Stir-Welded Dissimilar Joints of ZK60 and Mg-4.6Al-1.2Sn-0.7Zn Alloys
por: Xie, Liangwen, et al.
Publicado: (2021)

Microstructure and Mechanical Properties of EK30 Alloy Synergistically Reinforced by Ag Alloying and Hot Extrusion for Aerospace Applications
por: Zhang, Daohe, et al.
Publicado: (2022)

Influence of Extrusion Rate on Microstructure and Mechanical Properties of Magnesium Alloy AM60 and an AM60-Based Metal Matrix Nanocomposite
por: Giannopoulou, Danai, et al.
Publicado: (2022)

Influence of ECAP process on mechanical and corrosion properties of pure Mg and ZK60 magnesium alloy for biodegradable stent applications
por: Mostaed, Ehsan, et al.
Publicado: (2014)

Investigation of a New Screw Press Forming Process for Manufacturing Connectors from ZK60 Magnesium Alloy Preforms
por: Dziubinska, Anna
Publicado: (2023)

On the Corrosion Fatigue of Magnesium Alloys Aimed at Biomedical Applications: New Insights from the Influence of Testing Frequency and Surface Modification of the Alloy ZK60
por: Linderov, Mikhail, et al.
Publicado: (2022)

Thermal cycles behavior and microstructure of AZ31/SiC composite prepared by stir casting
por: Mousavi, Seyed Fereidon, et al.
Publicado: (2022)

A Review on LDH-Smart Functionalization of Anodic Films of Mg Alloys
por: Kaseem, Mosab, et al.
Publicado: (2021)

Chemical Composition, Microstructure, Tensile and Creep Behavior of Ti60 Alloy Fabricated via Electron Beam Directed Energy Deposition
por: Zhang, Guodong, et al.
Publicado: (2022)

Metallic creep: and creep resistant alloys
por: Sully, A H
Publicado: (1949)

In Vitro Corrosion and Cytocompatibility of ZK60 Magnesium Alloy Coated with Hydroxyapatite by a Simple Chemical Conversion Process for Orthopedic Applications
por: Wang, Bing, et al.
Publicado: (2013)

Characterization of a Sandwich PLGA-Gallic Acid-PLGA Coating on Mg Alloy ZK60 for Bioresorbable Coronary Artery Stents
por: Lin, Li-Han, et al.
Publicado: (2020)

Improving the Chemical Stability of Al Alloy through the Densification of the Alumina Layer Assisted by SiF(6)(2−) Anion Hydrolysis
por: Kaseem, Mosab, et al.
Publicado: (2022)

Effects of Pre-Stretching on Creep Behavior, Mechanical Property and Microstructure in Creep Aging of Al-Cu-Li Alloy
por: Zhang, Jin, et al.
Publicado: (2019)

Letter to the editor in response to Kobo et al. 2022
por: Kageyama, Shigetaka, et al.
Publicado: (2022)

Influence of Ultrafine-Grained Microstructure and Texture Evolution of ECAPed ZK30 Magnesium Alloy on the Corrosion Behavior in Different Corrosive Agents
por: Alateyah, Abdulrahman I., et al.
Publicado: (2022)

Grain Refinement by Second Phase Particles under Applied Stress in ZK60 Mg Alloy with Y through Phase Field Simulation
por: Song, Yuhao, et al.
Publicado: (2018)

In-vivo bone remodeling potential of Sr-d-Ca-P /PLLA-HAp coated biodegradable ZK60 alloy bone plate
por: Park, Seong-Su, et al.
Publicado: (2022)

Effect of Air Storage on Stress Corrosion Cracking of ZK60 Alloy Induced by Preliminary Immersion in NaCl-Based Corrosion Solution
por: Merson, Evgeniy, et al.
Publicado: (2022)

Intermediate-Temperature Creep Deformation and Microstructural Evolution of an Equiatomic FCC-Structured CoCrFeNiMn High-Entropy Alloy
por: Cao, Chengming, et al.
Publicado: (2018)

Effect of ECAP Route Type on the Microstructural Evolution, Crystallographic Texture, Electrochemical Behavior and Mechanical Properties of ZK30 Biodegradable Magnesium Alloy
por: Alateyah, Abdulrahman I., et al.
Publicado: (2022)

Microstructure, Tensile, and Creep Behaviors of Ti-22Al-25Nb (at.%) Orthorhombic Alloy with Equiaxed Microstructure
por: Wang, Wei, et al.
Publicado: (2018)

Creep of metals and alloys
por: Evans, R W, et al.
Publicado: (1985)

Perspectives of Microstructure Refinement of Aluminum and Its Alloys by the Reciprocating Extrusion (Cyclic Extrusion Compression—CEC)
por: Richert, Maria, et al.
Publicado: (2022)

Poly(Lactic Acid) Composites
por: Kaseem, Mosab
Publicado: (2019)

Influence of Hot Consolidation Conditions and Cr-Alloying on Microstructure and Creep in New-Generation ODS Alloy at 1100 °C
por: Svoboda, Jiří, et al.
Publicado: (2020)

Surface Properties of Graphene Functionalized TiO(2)/nHA Hybrid Coatings Made on Ti6Al7Nb Alloys via Plasma Electrolytic Oxidation (PEO)
por: Yigit, Oktay, et al.
Publicado: (2021)

Transformation-Induced Creep and Creep Recovery of Shape Memory Alloy
por: Takeda, Kohei, et al.
Publicado: (2012)

Cannot write session to /tmp/vufind_sessions/sess_4iaa1v8dr77ke204gpl5on2122