Ni-Al Bronze in Molten Carbonate Manufactured by LPBF: Effect of Porosity Design on Mechanical Properties and Oxidation

Fuel cell technology has developed due to diminishing dependence on fossil fuels and carbon footprint production. This work focuses on a nickel–aluminum bronze alloy as an anode produced by additive manufacturing as bulk and porous samples, studying the effect of designed porosity and thermal treatment on mechanical and chemical stability in molten carbonate (Li(2)CO(3)-K(2)CO(3)). Micrographs showed a typical morphology of the martensite phase for all samples in as-built conditions and a spheroid structure on the surface after the heat treatment, possibly revealing the formation of molten salt deposits and corrosion products. FE-SEM analysis of the bulk samples showed some pores with a diameter near 2–5 μm in the as-built condition, which varied between 100 and −1000 μm for the porous samples. After exposure, the cross-section images of porous samples revealed a film composed principally of Cu and Fe, Al, followed by a Ni-rich zone, whose thickness was approximately 1.5 µm, which depended on the porous design but was not influenced significantly by the heat treatment. Additionally, by incorporating porosity, the corrosion rate of NAB samples increased slightly.