Cargando…

A Vexing Problem of Air Trapping in the Trima Accel During Plateletpheresis Procedure: Reflecting Our Experience in Troubleshooting

Troubleshooting for any fault of apheresis equipment or kit is hardly addressed. Here, we report a unique problem of air trapping in a kit at two different positions leading to failure of the plateletpheresis procedure. Two plateletpheresis procedures were aborted due to “Access pressure low”, thoug...

Descripción completa

Detalles Bibliográficos
Autores principales: Routray, Suman S, Tripathy, Sukanta, Ray, Gopal
Formato: Online Artículo Texto
Lenguaje:English
Publicado: Cureus 2023
Materias:
Acceso en línea:https://www.ncbi.nlm.nih.gov/pmc/articles/PMC10238822/
https://www.ncbi.nlm.nih.gov/pubmed/37273319
http://dx.doi.org/10.7759/cureus.38518
Descripción
Sumario:Troubleshooting for any fault of apheresis equipment or kit is hardly addressed. Here, we report a unique problem of air trapping in a kit at two different positions leading to failure of the plateletpheresis procedure. Two plateletpheresis procedures were aborted due to “Access pressure low”, though the needle position was absolutely perfect. In the third event, platelet yield was not increasing even after 30 minutes from the time of initiation. It was completed after stopping the centrifuge pump which could have displaced the air bubble from the collection port. The root cause for these events was analyzed in consultation with the apheresis technical expert and “air block” was found to be the cause. Air block can also result in a “low access pressure” alarm despite improper phlebotomy being the common cause. Perfect kit loading, checking of tubing defects prior to loading, and comparative analysis of troubleshooting to have adequate knowledge are essential tools for the smooth functioning of apheresis.