Cargando…

Upgradation of methane in the biogas by hydrogenation of CO(2) in a prototype reactor with double pass operation over optimized Ni-Ce/Al-MCM-41 catalyst

The upgradation of methane in biogas by hydrogenation of CO(2) has been currently recognized as a promising route for efficient full utilization of renewable biogas with potential benefits for storage of renewable hydrogen energy and abatement of greenhouse gas emission. As a main constituent of bio...

Descripción completa

Detalles Bibliográficos
Autores principales: Aieamsam-Aung, Pichawee, Srifa, Atthapon, Koo-Amornpattana, Wanida, Assabumrungrat, Suttichai, Reubroycharoen, Prasert, Suchamalawong, Phorndranrat, Fukuhara, Choji, Ratchahat, Sakhon
Formato: Online Artículo Texto
Lenguaje:English
Publicado: Nature Publishing Group UK 2023
Materias:
Acceso en línea:https://www.ncbi.nlm.nih.gov/pmc/articles/PMC10250424/
https://www.ncbi.nlm.nih.gov/pubmed/37291234
http://dx.doi.org/10.1038/s41598-023-36425-5
Descripción
Sumario:The upgradation of methane in biogas by hydrogenation of CO(2) has been currently recognized as a promising route for efficient full utilization of renewable biogas with potential benefits for storage of renewable hydrogen energy and abatement of greenhouse gas emission. As a main constituent of biogas, CO(2) can act as a backbone for the formation of additional CH(4) by hydrogenation, then producing higher amounts of biomethane. In this work, the upgradation process was investigated in a prototype reactor of double pass operation with vertical alignment using an optimized Ni-Ce/Al-MCM-41 catalyst. The experimental results show that the double pass operation that removes water vapor during the run can significantly increase CO(2) conversion, resulting in higher CH(4) production yield. As a result, the purity of biomethane increased by 15% higher than a single pass operation. In addition, search for optimum condition of the process was carried out within an investigated range of conditions including flowrate (77–1108 ml min(−1)), pressure (1 atm–20 bar), and temperature (200–500 °C). The durability test for 458 h was performed using the obtained optimum condition, and it shows that the optimized catalyst can perform excellent stability with negligible influence by the observed change in catalyst properties. The comprehensive characterization on physicochemical properties of fresh and spent catalysts was performed, and the results were discussed.