Guided Bone Regeneration Effects on Bone Quantity and Outcomes of Dental Implants in Patients With Insufficient Bone Support: A Single-Center Observational Study

Background Guided bone regeneration (GBR) is used to influence on stabilization of dental implants in patients with insufficient bone quantity and anatomical problems. But many studies using GBR resulted in divergent results according to the efficiency of new bone quantity formation and implant survival. This research aimed to study the effects of GBR on the increase of bone quantity and short-term stabilization of dental implants in patients with insufficient bone support. Methodology The study included 26 patients that underwent the procedure for 40 dental implants from September 2020 to September 2021. In each case, the vertical bone support was intraoperatively measured, through the MEDIDENT Italia paradontal millimetric probe (Medident Italia, Carpi, Italy). The vertical bone defect was considered when the mean vertical depth between the abutment junction and the marginal bone was greater than 1mm up to 8mm. In the group with the presence of the vertical bone defect, GBR technique was used during the procedure of dental implants realized with synthetic bone graft, resorbable membrane, and platelet-rich fibrin (PRF), and the group was considered the study (GBR) group. The group of patients with no vertical bone defects (less than 1mm) and no need for any GBR technique use was considered the control (no-GBR) group. The bone support was evaluated again intraoperatively after six months in both groups when the healing abutments were positioned. The vertical bone defect for each group in baseline and after six months is presented as mean±SD and compared using a t-test. A t-test for Equality of Means was used to calculate the mean depth difference (MDD) between baseline and six months values in each group (GBR and no-GBR) and also between both groups. P-value ≤ 0.05 is considered statistically significant. Results Overall 40 dental implants were placed, 20 of them were included in the GBR group and 20 in the no-GBR group. In the GBR group, a statistically significant greater mean vertical bone defect in baseline (day 1), compared to the no-GBR group was found (-4.46±2.76 vs -0.27±0.22; MDD = -4.19 [-5.44 to -2.94] p<0.001). At six months of follow-up in the GBR group, a new bone around the implant was formed, presenting a significantly lower bone defect compared to the baseline measure (-0.39±0.43 vs -4.46±2.76; MDD = -4.07 mm [-5.37 to -2.78] p<0.001). In six months, no statistically significant difference between GBR and no-GBR group in bone support was found (-0.39±0.43 vs -0.27±0.22; MDD = -0.19 [-0.40 to -0.03] p=0.10). In each group, only one implant failure was observed. Conclusions The use of GBR showed an important reduction of vertical depth defect between healing abutment and marginal bone predisposing similar short-term stability and survival of dental implants. The use of GBR techniques could be essential in the stabilization of dental implants in patients with insufficient bone support.