Cargando…

Microstructural and Mechanical Characterization of Colloidal Processed WC/(W5Vol%Ni) via Spark Plasma Sintering

This study investigates the sintering behaviour and properties of WC-based composites in which WC was mixed with W5vol%Ni in concentrations of 10vol% and 20vol%. Colloidal processing in water and spark plasma sintering were employed to disperse the WC particles and facilitate sintering. The addition...

Descripción completa

Detalles Bibliográficos
Autores principales:	Zegai, Ahmed-Ameur, Besharatloo, Hossein, Ortega, Pablo, Djerdjare, Boubekeur, Ferrari, Begoña, Sanchez-Herencia, Antonio Javier
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2023
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC10342733/ https://www.ncbi.nlm.nih.gov/pubmed/37444897 http://dx.doi.org/10.3390/ma16134584

Ejemplares similares

Effect of SiC Nanowhisker on the Microstructure and Mechanical Properties of WC-Ni Cemented Carbide Prepared by Spark Plasma Sintering
por: Ren, Xiaoyong, et al.
Publicado: (2014)

Microstructure and Mechanical Properties of Spark Plasma Sintered Si(3)N(4)/WC Ceramic Tools
por: Wang, Zhenhua, et al.
Publicado: (2019)

The Analysis of Erosive Wear Resistance of WC-Co Carbides Obtained by Spark Plasma Sintering Method
por: Wachowicz, Joanna, et al.
Publicado: (2021)

Invar/WC Composite Compacts Obtained by Spark Plasma Sintering from Mechanically Alloyed Powders
por: Prica, Călin-Virgiliu, et al.
Publicado: (2022)

Mechanical Milling-Assisted Spark Plasma Sintering of Fine-Grained W-Ni-Mn Alloy
por: Pan, Yanlin, et al.
Publicado: (2018)

Spark Plasma Sintering of WC-Based 10wt%Co Hard Alloy: A Study of Sintering Kinetics and Solid-Phase Processes
por: Buravleva, Anastasia A., et al.
Publicado: (2022)

Microstructure and Properties of WC/Ni-Based Laser-Clad Coatings with Different WC Content Values
por: Shen, Xuehui, et al.
Publicado: (2022)

Microstructure of Spark Plasma-Sintered Silicon Nitride Ceramics
por: Lukianova, O. A., et al.
Publicado: (2017)

Influence of Heat Treatment on Microstructure and Properties of NiTi46 Alloy Consolidated by Spark Plasma Sintering
por: Salvetr, Pavel, et al.
Publicado: (2019)

Assessment of microstructure, nanomechanical and tribological properties of Ti-xNi alloys fabricated by spark plasma sintering
por: Rominiyi, Azeez Lawan, et al.
Publicado: (2023)

Data on the impact of increasing the W amount on the mass density and compressive properties of Ni–W alloys processed by spark plasma sintering
por: Sadat, T., et al.
Publicado: (2016)

Microstructure and Mechanical Properties of Composites Obtained by Spark Plasma Sintering of Ti(3)SiC(2)-15 vol.%Cu Mixtures
por: Zhang, Rui, et al.
Publicado: (2022)

Two-Step Spark Plasma Sintering Process of Ultrafine Grained WC-12Co-0.2VC Cemented Carbide
por: Wang, Zhenhua, et al.
Publicado: (2019)

Tribological Characterization of Micron-/Nano-Sized WC-9%Co Cemented Carbides Prepared by Spark Plasma Sintering at Elevated Temperatures
por: Wohaibi, Saleh Al, et al.
Publicado: (2019)

The Effect of ZrO(2) Nanoparticles on the Microstructure and Properties of Sintered WC–Bronze-Based Diamond Composites
por: Sun, Youhong, et al.
Publicado: (2016)

Influence of Sintering Process Conditions on Microstructural and Mechanical Properties of Boron Carbide Ceramics Synthesized by Spark Plasma Sintering
por: Liu, Yingying, et al.
Publicado: (2021)

The Influence of Milling and Spark Plasma Sintering on the Microstructure and Properties of the Al7075 Alloy
por: Molnárová, Orsolya, et al.
Publicado: (2018)

Microstructure and Electrical Properties of AZO/Graphene Nanosheets Fabricated by Spark Plasma Sintering
por: Yang, Shuang, et al.
Publicado: (2016)

The Property Characterization of α-Sialon/Ni Composites Synthesized by Spark Plasma Sintering
por: Adeniyi, Adedayo Sheriff, et al.
Publicado: (2019)

Effect of Nano Copper on the Densification of Spark Plasma Sintered W–Cu Composites
por: Madhur, Vadde, et al.
Publicado: (2021)

Microstructure and Mechanical Properties of Spark Plasma Sintered CoCrFeNiNbX High-Entropy Alloys with Si Addition
por: Karlík, Miroslav, et al.
Publicado: (2023)

Liquid Phase Sintering of (Ti,Zr)C with WC-Co
por: Ma, Taoran, et al.
Publicado: (2017)

Fabrication and Microstructure of Laminated HAP–45S5 Bioglass Ceramics by Spark Plasma Sintering
por: Meng, Ye, et al.
Publicado: (2019)

Spark Plasma Sintering of a Gas Atomized Al7075 Alloy: Microstructure and Properties
por: Molnárová, Orsolya, et al.
Publicado: (2016)

Effect of Zr Addition on the Microstructure and Mechanical Properties of CoCrFeNiMn High-Entropy Alloy Synthesized by Spark Plasma Sintering
por: Zhang, Hongling, et al.
Publicado: (2018)

Phases, Microstructures and Mechanical Properties of CoCrNiCuZn High-Entropy Alloy Prepared by Mechanical Alloying and Spark Plasma Sintering
por: Sun, Yuchen, et al.
Publicado: (2019)

Phase prediction, microstructure, and mechanical properties of spark plasma sintered Ni–Al–Ti–Mn–Co–Fe–Cr high entropy alloys
por: Olorundaisi, Emmanuel, et al.
Publicado: (2023)

Effect of Heat Treatment on Microstructure and Tribocorrosion Performance of Laser Cladding Ni-65 WC Coating
por: Liu, Ze, et al.
Publicado: (2020)

Microstructure Refinement in W-Y(2)O(3) Alloy Fabricated by Wet Chemical Method with Surfactant Addition and Subsequent Spark Plasma Sintering
por: Dong, Zhi, et al.
Publicado: (2017)

Comparative Study of Corrosion Behaviors of WC-NiMo and WC-Co Cemented Carbides
por: Balbino, Nádia Alves Nery, et al.
Publicado: (2023)

Application of U-FAST Technology in Sintering of Submicron WC-Co Carbides
por: Wachowicz, Joanna, et al.
Publicado: (2023)

Bimodal Microstructure in an AlZrTi Alloy Prepared by Mechanical Milling and Spark Plasma Sintering
por: Molnárová, Orsolya, et al.
Publicado: (2020)

Microstructure and Mechanical Properties of AA7075 Aluminum Alloy Fabricated by Spark Plasma Sintering (SPS)
por: Soares, Elder, et al.
Publicado: (2021)

Investigation of Spark Plasma Sintering on Microstructure-Properties of Zirconia Reinforced Fluormica Glass for Dental Restorations
por: Gali, Sivaranjani, et al.
Publicado: (2023)

Effect of Sintering Temperature and Iron Addition on Properties and Microstructure of High Speed Steel Based Materials Produced by Spark Plasma Sintering Method
por: Madej, Marcin, et al.
Publicado: (2022)

Microstructure and Wear Properties of Laser Cladding WC/Ni-Based Composite Layer on Al–Si Alloy
por: Wu, Xiaoquan, et al.
Publicado: (2021)

Morphological Analyses of W/Cu Functional Graded Materials Obtained by Conventional and Spark Plasma Sintering
por: Nicolicescu, Claudiu, et al.
Publicado: (2023)

Comparative Study on the Densification, Microstructure and Properties of WC-10(Ni, Ni/Co) Cemented Carbides Using Electroless Plated and Coprecipitated Powders
por: Jiang, Haoli, et al.
Publicado: (2023)

The Manufacturing of High Porosity Iron with an Ultra-Fine Microstructure via Free Pressureless Spark Plasma Sintering
por: Cui, Guodong, et al.
Publicado: (2016)

Influence of ZrB(2) on Microstructure and Properties of Steel Matrix Composites Prepared by Spark Plasma Sintering
por: Sulima, Iwona, et al.
Publicado: (2020)

Cannot write session to /tmp/vufind_sessions/sess_8p4oli7eu9nfop8ig4an0tglec