Effect of Blade Geometry on γ′ Lattice Parameter and Primary Orientation of SX Cored Turbine Blades (II)

The distributions of the lattice parameter of the γ′-phase (aγ′) and angular components of the primary crystal orientation along the lines parallel to the main axis of the single-crystalline CMSX 4-cored turbine blades were studied. The studies were carried out on the regions of the blades located far from the selector and its continuer extension (CE), positioned asymmetrically relative to the blade’s axis. It was found that, similarly to the regions of the blade located close to the CE (studied in part I), at the level of the blade related to the change of its cross-section, there were correlated local changes in aγ′ and the angular components of the primary crystal orientation representing the bending of the dendrites. However, the correlation was less clear due to the presence of low-angle boundaries (LABs) and the intensification of the consequences of the “fanning effect” in the regions far from the CE. It was found that the range of local changes in aγ′ and the angular components of the primary crystal orientation of the blade regions were influenced by both the distance from the CE and the separation of these regions from the CE by surfaces of the cooling bores. It was found that the deviation angle in the [001] direction from the blade axis increased with an increase in the distance from the CE. Based on the aγ′ changes, differences in the alloying element concentration near the cooling bores were discussed.