Cargando…

Experimental Analysis of the Mechanical Response of Masonry Columns Partially Confined with PBO FRCM (Fabric Reinforced Cementitious Mortar) Composites

An experimental investigation on partially PBO (short of Polyparaphenylenebenzobisthiazole) FRCM (Fiber Reinforced Cementitious Mortar) confined clay brick masonry columns has been conducted. Ten small-scale specimens measuring 445 mm high with a square cross-section of the 250 mm side have been tes...

Descripción completa

Detalles Bibliográficos
Autores principales:	Ombres, Luciano, Campolongo, Francesco, Guglielmi, Marielda, Verre, Salvatore
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2023
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC10343606/ https://www.ncbi.nlm.nih.gov/pubmed/37445126 http://dx.doi.org/10.3390/ma16134812

Ejemplares similares

Effect of PBO–FRCM Reinforcement on Stiffness of Eccentrically Compressed Reinforced Concrete Columns
por: Trapko, Tomasz, et al.
Publicado: (2020)

Fabric-Reinforced Cementitious Matrix (FRCM) Carbon Yarns with Different Surface Treatments Embedded in a Cementitious Mortar: Mechanical and Durability Studies
por: Bompadre, Francesca, et al.
Publicado: (2022)

Experimental Test of Reinforced Timber of FRCM-PBO with Pull-Off Adhesion Method
por: Sokołowski, Piotr, et al.
Publicado: (2022)

Fatigue Behavior of PBO FRCM Composite Applied to Concrete Substrate
por: Calabrese, Angelo Savio, et al.
Publicado: (2020)

Static Analysis of Wooden Beams Strengthened with FRCM-PBO Composite in Bending
por: Sokołowski, Piotr Kazimierz, et al.
Publicado: (2023)

Tensile Behaviour of FRCM Composites for Strengthening of Masonry Structures—An Experimental Investigation
por: Hojdys, Łukasz, et al.
Publicado: (2021)

Long-Term Behavior of PBO FRCM and Comparison with Other Inorganic-Matrix Composites
por: Calabrese, Angelo Savio, et al.
Publicado: (2022)

Masonry Columns Confined by Steel Fiber Composite Wraps
por: Borri, Antonio, et al.
Publicado: (2011)

Diagonal Tensile Test on Masonry Panels Strengthened with Textile-Reinforced Mortar
por: Ungureanu, Dragoș, et al.
Publicado: (2021)

Flexural Strengthening of Stone Masonry Walls Using Textile-Reinforced Sarooj Mortar
por: Al-Saidy, Abdullah Hilal, et al.
Publicado: (2023)

Multi-layer modelling of masonry structures strengthened through textile-reinforced mortar
por: Boem, Ingrid
Publicado: (2023)

Mechanical Behavior of Masonry Mortars Made with Recycled Mortar Aggregate
por: Mora-Ortiz, René Sebastián, et al.
Publicado: (2020)

Recycled Fine Aggregates from Mortar Debris and Red Clay Brick to Fabricate Masonry Mortars: Mechanical Analysis
por: Mora-Ortiz, René Sebastián, et al.
Publicado: (2022)

Compressive and Shear Behavior of Masonry Reinforced with Ultra-Rapid-Hardening Fiber-Reinforced Mortar (URH-FRM)
por: Lee, Joo Ha
Publicado: (2022)

Development of Fibre-Reinforced Cementitious Mortar with Mineral Wool and Coconut Fibre
por: Awoyera, Paul O., et al.
Publicado: (2022)

Lime-Based Mortar Reinforced by Randomly Oriented Short Fibers for the Retrofitting of the Historical Masonry Structure
por: Angiolilli, Michele, et al.
Publicado: (2020)

Effect of Pre-Wetting Recycled Mortar Aggregate on the Mechanical Properties of Masonry Mortar
por: Mora-Ortiz, René Sebastián, et al.
Publicado: (2021)

Effect of Different Environments’ Conditioning on the Debonding Phenomenon in Fiber-Reinforced Cementitious Matrix-Concrete Joints
por: Verre, Salvatore
Publicado: (2021)

Internal Sulphate Attack in Masonry Mortars with Thaumasite Formation
por: Chinchón-Payá, Servando, et al.
Publicado: (2022)

Reinforced masonry design /
por: Schneider, Robert R.
Publicado: (1987)

Recycled PET Sand for Cementitious Mortar
por: Campanhão, Angélica Faria, et al.
Publicado: (2021)

Stress State Analysis and Failure Mechanisms of Masonry Columns Reinforced with FRP under Concentric Compressive Load
por: Witzany, Jiří, et al.
Publicado: (2016)

A Method for Determining Ultimate Grouting Pressure for Reinforcement of Masonry Arch Dam with Mortar Deterioration: A Case Study
por: Yu, Jia’ao, et al.
Publicado: (2022)

Analysis and Economic Evaluation of the Use of Recycled Polyamide Powder in Masonry Mortars
por: Salas, Miguel A., et al.
Publicado: (2020)

New Composite Material for Masonry Repair: Mortar Formulations and Experimental Studies
por: Deboucha, Walid, et al.
Publicado: (2021)

Investigation of the Mechanical and Microstructural Properties of Masonry Mortar Made with Seashell Particles
por: Nduka, David O., et al.
Publicado: (2023)

Analytical Approach and Numerical Simulation of Reinforced Concrete Beams Strengthened with Different FRCM Systems
por: Mercedes, Luis, et al.
Publicado: (2021)

Comparative Overview of the Performance of Cementitious and Non-Cementitious Nanomaterials in Mortar at Normal and Elevated Temperatures
por: Khan, M. Arsalan, et al.
Publicado: (2021)

Effect of the Partial Replacement of Cement with Waste Granite Powder on the Properties of Fresh and Hardened Mortars for Masonry Applications
por: Woźniak, Zuzanna Zofia, et al.
Publicado: (2022)

Flexural Behaviour of Cementitious Mortars with the Addition of Basalt Fibres
por: Wydra, Małgorzata, et al.
Publicado: (2021)

Comparative Studies of the Confined Effect of Shear Masonry Walls Made of Autoclaved Aerated Concrete Masonry Units
por: Jasiński, Radosław, et al.
Publicado: (2023)

Effects of Defects on Masonry Confinement with Inorganic Matrix Composites
por: Lignola, Gian Piero, et al.
Publicado: (2023)

Tailoring Confining Jacket for Concrete Column Using Ultra High Performance-Fiber Reinforced Cementitious Composites (UHP-FRCC) with High Volume Fly Ash (HVFA)
por: Fantilli, Alessandro P., et al.
Publicado: (2019)

Seismic Performance Evaluation of RC Columns Retrofitted by 3D Textile Reinforced Mortars
por: Kim, Siyun, et al.
Publicado: (2022)

Seismic design of reinforced concrete and masonry buildings /
por: Paulay, T., 1923-
Publicado: (1992)

Fiberglass Grids as Sustainable Reinforcement of Historic Masonry
por: Righetti, Luca, et al.
Publicado: (2016)

Combined Effects of Non-Conforming Fly Ash and Recycled Masonry Aggregates on Mortar Properties
por: Torres-Gómez, Ana Isabel, et al.
Publicado: (2016)

Bond Strength Tests under Pure Shear and Tension between Masonry and Sprayed Mortar
por: Huang, Dawei, et al.
Publicado: (2020)

Use of Municipal Solid Waste Incineration Fly Ash in Geopolymer Masonry Mortar Manufacturing
por: Lu, Ning, et al.
Publicado: (2022)

L-Box Form Filling of Thixotropic Cementitious Paste and Mortar
por: Thiedeitz, Mareike, et al.
Publicado: (2020)

Cannot write session to /tmp/vufind_sessions/sess_u8kdg4ek739f5mmtldkpeer1nr