Cargando…
Additively Manufactured Parts from AA2011-T6 Large-Diameter Feedstocks Using Friction Stir Deposition
The current work investigates the possibility of fabricating additive manufacturing products in solid-state form, from AA2011-T6 of 40 mm diameter rods as a feedstock, using an additive friction stir deposition (A-FSD) technique. The use of large diameter feedstocks, especially high-strength aluminu...
Autores principales: | Alsaleh, Naser A., El-Sayed Seleman, Mohamed M., Hassan, Ahmed M. M., Ahmed, Mohamed M. Z., Ataya, Sabbah, Latief, Fahamsyah H., Abdul-Latif, Akrum, Habba, Mohamed I. A. |
---|---|
Formato: | Online Artículo Texto |
Lenguaje: | English |
Publicado: |
MDPI
2023
|
Materias: | |
Acceso en línea: | https://www.ncbi.nlm.nih.gov/pmc/articles/PMC10381854/ https://www.ncbi.nlm.nih.gov/pubmed/37512179 http://dx.doi.org/10.3390/ma16144904 |
Ejemplares similares
-
Microstructure and Mechanical Properties of Friction Stir Welded 2205 Duplex Stainless Steel Butt Joints
por: Ahmed, Mohamed M. Z., et al.
Publicado: (2021) -
Bobbin Tool Friction Stir Welding of Aluminum Thick Lap Joints: Effect of Process Parameters on Temperature Distribution and Joints’ Properties
por: Ahmed, Mohamed M. Z., et al.
Publicado: (2021) -
The Additive Manufacturing of Aluminum Matrix Nano Al(2)O(3) Composites Produced via Friction Stir Deposition Using Different Initial Material Conditions
por: El-Sayed Seleman, Mohamed M., et al.
Publicado: (2022) -
LCF and HCF of Short Carbon Fibers Reinforced AE42 Mg Alloy
por: Alsaleh, Naser A., et al.
Publicado: (2023) -
The Effect of Temper Condition and Feeding Speed on the Additive Manufacturing of AA2011 Parts Using Friction Stir Deposition
por: Ahmed, Mohamed M. Z., et al.
Publicado: (2021)