Cargando…
Preheating Influence on the Precipitation Microstructure, Mechanical and Corrosive Properties of Additively Built Al–Cu–Li Alloy Contrasted with Conventional (T83) Alloy
In this paper, the high strength and lightweight Al–Cu–Li alloy (AA2099) is considered in as-built and preheated conditions (440 °C, 460 °C, 480 °C, 500 °C, and 520 °C). The purpose of this study is to investigate the influence of laser powder bed fusion (LPBF) in situ preheating on precipitation mi...
Autores principales: | Adjei-Kyeremeh, Frank, Pratesa, Yudha, Shen, Xiao, Song, Wenwen, Raffeis, Iris, Vroomen, Uwe, Zander, Daniela, Bührig-Polaczek, Andreas |
---|---|
Formato: | Online Artículo Texto |
Lenguaje: | English |
Publicado: |
MDPI
2023
|
Materias: | |
Acceso en línea: | https://www.ncbi.nlm.nih.gov/pmc/articles/PMC10382017/ https://www.ncbi.nlm.nih.gov/pubmed/37512191 http://dx.doi.org/10.3390/ma16144916 |
Ejemplares similares
-
Characterising the Microstructure of an Additively Built Al-Cu-Li Alloy
por: Raffeis, Iris, et al.
Publicado: (2020) -
Phase-Field Simulation of Microstructure Formation in Gas-Atomized Al–Cu–Li–Mg Powders
por: Phyu, May Pwint, et al.
Publicado: (2023) -
Enhancing the Corrosion Resistance of Al–Cu–Li Alloys through Regulating Precipitation
por: Xu, Jinjun, et al.
Publicado: (2020) -
Effect of Ag alloying and trace precipitation on corrosion resistance of Ti-Ta-Ag ternary alloy
por: Zhang, Jun-Min, et al.
Publicado: (2021) -
Effects of Beryllium Addition on Microstructure, Mechanical and Corrosion Performance of Al-Mg-Li Alloys
por: Huang, Yang, et al.
Publicado: (2023)