Cargando…

An Evaluation of the Effectiveness of Various Luting Cements on the Retention of Implant-Supported Metal Crowns

Background and objective Cement-retained prostheses have replaced screw-retained prostheses as the preferred restoration in recent years in order to overcome the latter's limitations. In this study, four different luting cements were compared to evaluate their efficacy on the retention of cemen...

Descripción completa

Detalles Bibliográficos
Autores principales:	Mehta, Surbhi, Kesari, Anubhav, Tomar, Mohit, Sharma, Urvashi, Sagar, Preeti, Nakum, Pooja, Rao, Kumuda
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	Cureus 2023
Materias:	Dentistry
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC10413795/ https://www.ncbi.nlm.nih.gov/pubmed/37575823 http://dx.doi.org/10.7759/cureus.41691

Ejemplares similares

Retention of Various Luting Agents Used with Implant-Supported Crowns
por: Sathyanarayan, Santhosh, et al.
Publicado: (2021)

Influence of Luting Materials on the Retention of Cemented Implant-Supported Crowns: An In Vitro Study
por: Naumova, Ella A., et al.
Publicado: (2018)

Effect of Three Different Liquid Medias in the Sorption and Solubility of Luting Cements: An In Vitro Study
por: Radhakrishnan, Lakshmi, et al.
Publicado: (2023)

An In Vitro Comparison of Shear Bond Strength for Heated Composite Resin With Three Conventional Luting Cements
por: Aravind, Prasad, et al.
Publicado: (2023)

Effect of Axial Groove and Resin Luting Cements on the Retention of Complete Cast Metal Crowns
por: Rajkumar, K., et al.
Publicado: (2009)

Comparison of effect of desensitizing agents on the retention of crowns cemented with luting agents: an in vitro study
por: Jalandar, Sonune Shital, et al.
Publicado: (2012)

Effect of Implant Abutment Acid Etching on the Retention of Crowns Luted with Different Cements: An In Vitro Comparative Evaluation
por: Ajay, R., et al.
Publicado: (2019)

Management of short clinical crowns by utilizing horizontal groove retentive technique in crown/tooth or both with different luting cements – An analysis on extracted teeth
por: Haritha, J., et al.
Publicado: (2020)

Comparative Evaluation of Enhancing Retention of Dislodged Crowns Using Preparation Modifications and Luting Cements: An In-Vitro Study
por: Amarnath, G S, et al.
Publicado: (2015)

Evaluation of retentive strength of four luting cements with stainless steel crowns in primary molars: An in vitro study
por: Parisay, Iman, et al.
Publicado: (2018)

Evaluation of Microleakage of Stainless Steel Crowns and Pedo Jacket Crowns after Cementation With Different Luting Cements
por: Varghese, Eby, et al.
Publicado: (2023)

Three-Dimensional Finite Element Analysis of Worn Molars With Prosthetic Crowns and Onlays Made of Various Materials
por: Houdaifa, Raafat, et al.
Publicado: (2022)

Effect of Different Luting Agents on the Retention of Lithium Disilicate Ceramic Crowns
por: Mobilio, Nicola, et al.
Publicado: (2015)

Effect of Laser Etching and Spark Erosion on Retention and Resistance of Partial Veneer Crown Copings Luted with Adhesive Resin Cement
por: Sarath, Chandra Govindaraj, et al.
Publicado: (2018)

Comparative evaluation of bond strength of all-metal crowns with different luting agents after undergoing various modes of surface treatments: An in-vitro study
por: Tomar, Shivam Singh, et al.
Publicado: (2015)

Comparative Evaluation of Retention of Fiber Posts in Different Dentin Regions Using Various Bonding Techniques: An In Vitro Study
por: Thanikachalam, Yashini, et al.
Publicado: (2023)

An in vitro study to compare the influence of newer luting cements on retention of cement-retained implant-supported prosthesis
por: Sarfaraz, Hasan, et al.
Publicado: (2019)

The Effect of Hemostatic Agents on the Retention Strength of Zirconia Crowns Luted to Dentin Abutments
por: Maischberger, Christian, et al.
Publicado: (2019)

Comparative evaluation of marginal leakage of provisional crowns cemented with different temporary luting cements: In vitro study
por: Arora, Sheen Juneja, et al.
Publicado: (2016)

An Invitro Chewing Simulation Study Comparing the Wear Resistance Behavior of Polyetheretherketone-Layered Composite Crown and Ceramic-Layered Zirconia Crown
por: Rupawat, Divya, et al.
Publicado: (2023)

Comparison of Microleakage in Nanocomposite and Amalgam as a Crown Foundation Material Luted with Different Luting Cements under CAD-CAM Milled Metal Crowns: An In Vitro Microscopic Study
por: Amina,, et al.
Publicado: (2022)

Comparative Evaluation of Surface Roughness of Porcelain Fused to Metal and Stainless-Steel Crown Following Ultrasonic and Hand Scaling: A Comparative Study
por: Bagde, Hiroj, et al.
Publicado: (2022)

Knowledge, Opinion, and Practices Towards Screening of Oral Cancer Among Homeopathy and Ayurveda Students in Indore, Madhya Pradesh, India
por: Chatterjee, Silpi, et al.
Publicado: (2023)

Management of Complex Crown Fractures: A Case Series
por: Lakshmaiah, Deepika, et al.
Publicado: (2023)

CORRELATION BETWEEN MARGIN FIT AND MICROLEAKAGE IN COMPLETE CROWNS CEMENTED WITH THREE LUTING AGENTS
por: Rossetti, Paulo Henrique Orlato, et al.
Publicado: (2008)

Ultraconservative and Aesthetic Approach for Rehabilitation of Complicated Crown Fracture of Tooth
por: Dugar, Meghna, et al.
Publicado: (2022)

Retentive Strength of CAD/CAM-Fabricated All-Ceramic Crowns Luted on Titanium Implant Abutments Using Different Ceramic Materials and Luting Agents: An In Vitro Study
por: Bjelopavlovic, Monika, et al.
Publicado: (2022)

Conservative Management of Complicated Crown-Root Fracture: An Immediate Esthetic Rehabilitation
por: Rajnekar, Rutuja, et al.
Publicado: (2022)

In Vitro Evaluation of the Effect of Different Luting Cements and Tooth Preparation Angle on the Microleakage of Zirconia Crowns
por: Ebadian, Behnaz, et al.
Publicado: (2021)

Necrotic Pulp With Crown Discoloration Associated With Orthodontic Treatment: A Case Report
por: Alshammari, Abdulrahman K
Publicado: (2023)

Evaluation of the effect of dentin surface treatment by air abrasion and Er:YAG laser on the retention of metal crowns luted with glass ionomer cement in teeth with reduced crown height: An in vitro study
por: Chauhan, Sameer, et al.
Publicado: (2019)

Correlation between Microleakage and Absolute Marginal Discrepancy in Zirconia Crowns Cemented with Four Resin Luting Cements: An In Vitro Study
por: Cristian, Abad-Coronel, et al.
Publicado: (2016)

Comparative evaluation of microleakage of metallic copings luted with three different commercially available luting cements: An in vitro study
por: Handa, Mohit, et al.
Publicado: (2021)

A Review of Bacterial Colonization on Dental Implants With Various Hygiene Instruments
por: Chen, Ashmita, et al.
Publicado: (2023)

Comparison of microleakage between different restorative materials to restore marginal gap at crown margin
por: Haralur, Satheesh B., et al.
Publicado: (2021)

Assessment of a developed pig cadaver model for teaching crown lengthening surgical procedures
por: Zhong, Jinsheng, et al.
Publicado: (2022)

An In Vitro Comparison of Zirconia and Hybrid Ceramic Crowns With Heavy Chamfer and Shoulder Finish Lines
por: Yadav, Priyanka, et al.
Publicado: (2023)

Graftless Immediate Dual Implant Anatomic Placement With Immediate Provisional Passive Loading and Definitive Hybrid Crown for the Restoration of Mandibular Molar: A Clinical Report
por: Ramakrishnan, Hariharan, et al.
Publicado: (2023)

Comparative Evaluation of Bond Strength of Different Luting Cements for Cementation of Stainless Steel Bands on Primary Molar Crowns (Stainless Steel and Zirconia Crowns): An In Vitro Study
por: Kalaskar, Ritesh, et al.
Publicado: (2021)

Effect of Abutment Modification and Cement Type on Retention of Cement-Retained Implant Supported Crowns
por: Farzin, Mitra, et al.
Publicado: (2014)

Cannot write session to /tmp/vufind_sessions/sess_leta80bllhthdh93vd4p9gde0r