Cargando…

Durability of Two Epoxy Adhesive BFRP Joints Dipped in Seawater under High Temperature Environment

Fiber-reinforced polymers (FRPs) have great potential in shipbuilding. As a new type of material, basalt-fiber-reinforced polymer (BFRP) has received increasing attention due to its good economic and environmental performance. In this paper, BFRP single-lap joints (SLJs) bonded by Araldite(®)2011 an...

Descripción completa

Detalles Bibliográficos
Autores principales:	Niu, Ruitao, Yang, Yang, Liu, Zhen, Ding, Ziyang, Peng, Han, Fan, Yisa
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2023
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC10422660/ https://www.ncbi.nlm.nih.gov/pubmed/37571126 http://dx.doi.org/10.3390/polym15153232

Ejemplares similares

Failure Study of BFRP Joints with Two Epoxy Adhesives under Hygrothermal Coupling
por: Niu, Ruitao, et al.
Publicado: (2023)

Comparison of Mechanical Properties of Ductile/Brittle Epoxy Resin BFRP-AL Joints under Different Immersion Solutions
por: Liu, Haichao, et al.
Publicado: (2023)

Influence of Hydrothermal Aging under Two Typical Adhesives on the Failure of BFRP Single Lap Joint
por: Fan, Yisa, et al.
Publicado: (2022)

Investigation on the Durability of E-Glass/Epoxy Composite Exposed to Seawater at Elevated Temperature
por: Idrisi, Amir Hussain, et al.
Publicado: (2021)

Comparative Failure Study of Different Bonded Basalt Fiber-Reinforced Polymer (BFRP)-AL Joints in a Humid and Hot Environment
por: Fan, Yisa, et al.
Publicado: (2021)

Study on the Effect of Salt Solution on Durability of Basalt-Fiber-Reinforced Polymer Joints in High-Temperature Environment
por: Fan, Yisa, et al.
Publicado: (2022)

Long-Term Durability of Basalt Fiber-Reinforced Polymer (BFRP) Sheets and the Epoxy Resin Matrix under a Wet–Dry Cyclic Condition in a Chloride-Containing Environment
por: Lu, Zhongyu, et al.
Publicado: (2017)

Evaluation of Deformation for Steel Fiber Concrete Beams with BFRP Tendons Eroded by Seawater under Cyclic Loading
por: Zhu, Haitang, et al.
Publicado: (2022)

Experimental Investigation of BFRP Tendons under Monotonic and Hysteretic Loadings
por: Wang, Yongwei, et al.
Publicado: (2021)

Durability of Fibre Reinforced Polymers in Exposure to Dual Environment of Seawater Sea Sand Concrete and Seawater
por: Guo, Fan, et al.
Publicado: (2022)

Seawater Absorption and Adhesion Properties of Hydrophobic and Superhydrophobic Thermoset Epoxy Nanocomposite Coatings
por: Atta, Ayman M., et al.
Publicado: (2021)

Durability and Mechanical Properties of Concrete Reinforced with Basalt Fiber-Reinforced Polymer (BFRP) Bars: Towards Sustainable Infrastructure
por: Mohamed, Osama Ahmed, et al.
Publicado: (2021)

Degradation of the In-plane Shear Modulus of Structural BFRP Laminates Due to High Temperature
por: Hu, Yu-Jia, et al.
Publicado: (2018)

Influence of POSS Type on the Space Environment Durability of Epoxy-POSS Nanocomposites
por: Bram, Avraham I., et al.
Publicado: (2022)

Friction Performance of Aged T-BFRP Composite for Bearing Applications
por: Nirmal, Umar
Publicado: (2018)

Bond Stress–Slip Model of BFRP Grid to ECC
por: Deng, Langni, et al.
Publicado: (2022)

A Colorimetric Dip Strip Assay for Detection of Low Concentrations of Phosphate in Seawater
por: Heidari-Bafroui, Hojat, et al.
Publicado: (2021)

Cold-Cured Bisphenolic Epoxy Adhesive Filled with Low Amounts of CaCO(3): Effect of the Filler on the Durability to Aqueous Environments
por: Rudawska, Anna, et al.
Publicado: (2021)

Numerical Modeling of Earthquake-Damaged Circular Bridge Columns Repaired Using Combination of Near-Surface-Mounted BFRP Bars with External BFRP Sheets Jacketing
por: Zeng, Xing-Gui, et al.
Publicado: (2019)

Comparative Study of the Durability Behaviors of Epoxy- and Polyurethane-Based CFRP Plates Subjected to the Combined Effects of Sustained Bending and Water/Seawater Immersion
por: Hong, Bin, et al.
Publicado: (2017)

Preparation and characterization of fast-curing powder epoxy adhesive at middle temperature
por: Xu, Jie, et al.
Publicado: (2018)

Delamination Study in Edge Trimming of Basalt Fiber Reinforced Plastics (BFRP)
por: Navarro-Mas, Maria Dolores, et al.
Publicado: (2018)

Analytical and Numerical Approaches for the Design of Concrete Structural Elements with Internal BFRP Reinforcement
por: Zhelyazov, Todor, et al.
Publicado: (2022)

Experimental Study on Shear-Peeling Debonding Behavior of BFRP Sheet-to-Steel Interfaces
por: Xue, Hanyang, et al.
Publicado: (2023)

Investigating the effect of curing temperature on the corrosion resistance of epoxy-based composite coatings for aluminium alloy 7075 in artificial seawater
por: Khan, Arshad Ali, et al.
Publicado: (2023)

Effects of Epoxy Adhesive Layer Thickness on Bond Strength of Joints in Concrete Structures
por: Yeon, Jaeheum, et al.
Publicado: (2019)

Study of the fatigue delamination behaviour of adhesive joints in carbon fibre reinforced epoxy composites, influence of the period of exposure to saline environment
por: Argüelles, A., et al.
Publicado: (2022)

Multi-Excitation Infrared Fusion for Impact Evaluation of Aluminium-BFRP/GFRP Hybrid Composites
por: Hu, Jue, et al.
Publicado: (2021)

Dynamic Responses of Blast-Loaded Shallow Buried Concrete Arches Strengthened with BFRP Bars
por: Wu, Jianqin, et al.
Publicado: (2022)

Characterization of Corrosion Behavior of TA2 Titanium Alloy Welded Joints in Seawater Environment
por: Zhang, Dalei, et al.
Publicado: (2022)

Interfacial Shear Performance of Epoxy Adhesive Joints of Prefabricated Elements Made of Ultra-High-Performance Concrete
por: Yu, Kun, et al.
Publicado: (2022)

A Review of Electro Conductive Textiles Utilizing the Dip-Coating Technique: Their Functionality, Durability and Sustainability
por: Ojstršek, Alenka, et al.
Publicado: (2022)

Durability of Epoxy Adhesives and Carbon Fibre Reinforced Polymer Laminates Used in Strengthening Systems: Accelerated Ageing versus Natural Ageing
por: Cruz, Ricardo, et al.
Publicado: (2021)

Experimental Study on One-Way BFRP Bar-Reinforced UHPC Slabs under Concentrated Load
por: Xu, Xiaoqing, et al.
Publicado: (2020)

Comparison of Different Parameters to Evaluate Delamination in Edge Trimming of Basalt Fiber Reinforced Plastics (BFRP)
por: Navarro-Mas, María Dolores, et al.
Publicado: (2020)

Tensile Behaviour of Double- and Triple-Adhesive Single Lap Joints Made with Spot Epoxy and Double-Sided Adhesive Tape
por: Golewski, Przemysław
Publicado: (2022)

An Increase of Seawater Temperature Upregulates the Expression of Vibrio parahaemolyticus Virulence Factors Implicated in Adhesion and Biofilm Formation
por: Billaud, Mélanie, et al.
Publicado: (2022)

Temperature Sensing in Seawater Based on Microfiber Knot Resonator
por: Yang, Hongjuan, et al.
Publicado: (2014)

Preparation of Novel Epoxy Resins Bearing Phthalazinone Moiety and Their Application as High-Temperature Adhesives
por: Wang, Liwei, et al.
Publicado: (2018)

Effect of Seawater Environment on the Structure and Performance of Basalt Continuous Fiber
por: Wang, Qingwei, et al.
Publicado: (2021)

Cannot write session to /tmp/vufind_sessions/sess_ks6gmr1b0d42q050mpamrn2rbm