Cargando…

A Three-Dimensional Finite Element Analysis of the Stress Distribution Around the Bone Mini-Implant Interface Based on the Mini-Implant Angle of Insertion, Diameter, and Length

BACKGROUND: Temporary anchorage devices or mini implants have gained great attraction due to their capability to provide absolute anchorage, low cost, versatility, and can be loaded immediately after placement. MATERIAL AND METHODS: Finite element analysis was used to evaluate the distribution of st...

Descripción completa

Detalles Bibliográficos
Autores principales: Sarika, K, Kumaran, Navaneethakrishnan Kurunji, Seralathan, Sakthidaran, Sathishkumar, Rathinavel Kumar, Preethi, Somasundaram Kanmani
Formato: Online Artículo Texto
Lenguaje:English
Publicado: Wolters Kluwer - Medknow 2023
Materias:
Acceso en línea:https://www.ncbi.nlm.nih.gov/pmc/articles/PMC10466509/
https://www.ncbi.nlm.nih.gov/pubmed/37654398
http://dx.doi.org/10.4103/jpbs.jpbs_524_22
Descripción
Sumario:BACKGROUND: Temporary anchorage devices or mini implants have gained great attraction due to their capability to provide absolute anchorage, low cost, versatility, and can be loaded immediately after placement. MATERIAL AND METHODS: Finite element analysis was used to evaluate the distribution of stress at the bone mini implant interface based on different angles of insertion (30°, 45°, 60°, and 90°) mini implant diameter (1.3 mm, 1.6 mm, and 2 mm) and mini implant length (6 mm, 8 mm, and 10 mm). A retraction force of 2 N was applied. RESULTS: Areas of maximum stress concentration were the head and neck of the mini implant and cortical bone around the mini implant. A very minimal amount of stress was found in the cancellous bone. The maximum stress found in the cortical bone was 5.1301 MPa and in the mini implant was 26.355 MPa with an angle of insertion of 30°, a 1.3 mm diameter, and a 6 mm length. The minimum stress found in the cortical bone was 1.4702 MPa and that in the mini implant was 5.3895 MPa with an angle of insertion of 90°, a 2 mm diameter, and a 10 mm length. CONCLUSION: For maximum stability, mini implants should be placed at a perpendicular angle of insertion with sufficient diameter and length.