Effects of a commercial whitening toothpaste containing hydrogen peroxide and citric acid on dentin abrasion and erosion

BACKGROUND: Hydrogen peroxide (HP) and citric acid (CA), key contributors to toothpaste acidity, can lead to dental loss. This study aimed to compare the amount of abrasion or loss of dentin based on pH, buffering, and concentration of HP and CA in commercial and experimental toothpastes after toothbrushing or immersion. METHODS: Bovine dentin specimens were randomly assigned to nine solutions. The prepared solutions included two commercial toothpastes (whitening toothpaste [WT] with HP and CA; conventional toothpaste [CT] without HP and CA), reference slurry (RS), two CA solutions (1.92%, CAS1; 0.001%, CAS2), basic solution (7.16% sodium phosphate dibasic [SPDS]), CA phosphate buffer solution (3.58% SPDS and 0.96% CA [CAPB]), HP solution (4%, HPS), and distilled water (DW). Dentin specimens were performed in two treatments: one with only abrasion (10,000 brushings) and one with only immersion (1 h). After treatments, the amount of dentin loss and surface images were measured and observed using noncontact profilometry. Data were analyzed using an one-way analysis of variance and the Tukey test as a post hoc analysis (p < 0.05). RESULTS: WT with pH 5.0 had lower dentin abrasion than CT and RS after brushing but had higher dentin loss than both after immersion. The dentin surfaces of CAS1, CAPB, and WT were damaged after immersion, whereas HPS, CAS2, CT, SPDS, RS, and DW remained intact after soaking. CAS2 and HPS, which had a pH of 5.0 like WT, did not significantly differ from those of DW after brushing. CONCLUSIONS: WT containing HP and CA did not cause significant dentin abrasion but may cause additional dentin loss even without brushing. After brushing or immersion, the CA concentration may affect the dentin surface more than the HP concentration included in WT. The amount of abrasion or loss of dentin after brushing or soaking can vary based on the composition, concentration, and buffer in the solution, even if the pH of the solution is similar to pH 5.0.