Cargando…
Titanium modular stems in total hip arthroplasty due to developmental dysplasia: a registry comparison with single-taper implants
INTRODUCTION: The routine use of proximal femoral modularity was discouraged in total hip arthroplasties (THAs). However, titanium dual-taper (DT) implants may provide some advantages over single-taper (ST) stems in cases of complex deformity. A registry study comparing ST and DT stems in dysplasia...
Autores principales: | Castagnini, Francesco, Cosentino, Monica, Bordini, Barbara, Montalti, Maurizio, Biondi, Federico, Faldini, Cesare, Traina, Francesco |
---|---|
Formato: | Online Artículo Texto |
Lenguaje: | English |
Publicado: |
SAGE Publications
2022
|
Materias: | |
Acceso en línea: | https://www.ncbi.nlm.nih.gov/pmc/articles/PMC10486160/ https://www.ncbi.nlm.nih.gov/pubmed/36127850 http://dx.doi.org/10.1177/11207000221124115 |
Ejemplares similares
-
Survival rates and reasons for revision of different stem designs in total hip arthroplasty for developmental dysplasia: a regional registry study
por: Di Martino, Alberto, et al.
Publicado: (2021) -
Comparison of single taper and dual taper versions of the same stem design in total hip arthroplasty for primary osteoarthritis
por: Castagnini, Francesco, et al.
Publicado: (2023) -
The influence of bearing surfaces on revisions due to dislocations in total hip arthroplasty
por: Castagnini, Francesco, et al.
Publicado: (2021) -
Off-the-shelf 3D printed titanium cups in primary total hip arthroplasty
por: Castagnini, Francesco, et al.
Publicado: (2021) -
Which stem in total hip arthroplasty for developmental hip dysplasia? A comparative study using a 3D CT-based software for pre-operative surgical planning
por: Castagnini, Francesco, et al.
Publicado: (2022)