Effect of Scanning Strategy on the Microstructure and Triboperformance of FeNiCrMo Coating Manufactured by Plasma Transferred Arc

To increase the coating thickness and service life of the FeNiCrMo coating, a plasma transferred arc (PTA) double-track alloying technique was employed to enhance the surface triboperformance of the ductile iron. Optical microscopy (OM), X-ray diffraction (XRD), electron probe X-ray microanalyzer (EPMA), scanning electron microscopy (SEM), transmission electron microscopy (TEM), Vickers hardness tester, and tribological tester were subsequently used to evaluate the effect of the double alloying treatment tracks on the microstructure and triboperformance of the coating. The results indicate that the content of the cementite in the sample with a double-track treatment increases 3.90 wt.% and the content of the martensite decreases 13.04 wt.% compared with the sample with a single-track treatment, which results in the maximum microhardness of the sample fabricated by double track increasing from 837 ± 10 HV(0.2) for the sample fabricated by single track to 871 ± 7 HV(0.2). Thus, the wear rate is lower than that of the sample with a single-track treatment. In addition, the distribution of alloying elements is more uniform and coating thickness is higher in the double track than those of the single-track-treated one. Therefore, the double-track PTA alloying treatment is favored for hardfacing ductile iron with a FeNiCrMo alloy coating due to its enhanced triboperformance and longer service life.