Cargando…

Microstructure and Mechanical Behavior of Quaternary Eutectic α+θ+Q+Si Clusters in As-Cast Al-Mg-Si-Cu Alloys

Cu additions notably strengthen Al-Mg-Si and Al-Si-Mg alloys due to the dense precipitation of quaternary nano precipitates during ageing. However, the chemical evolution and mechanical behaviors of the quaternary micro-scale Q constituent phase occurring in cast and homogenized states have rarely b...

Descripción completa

Detalles Bibliográficos
Autores principales:	Li, Kai, Yu, Yan, Lu, Qiang, Li, Yuanfei, Yan, Qiao, Lan, Xinyue, Li, Liya, Chen, Baishan, Song, Min
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2023
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC10532811/ https://www.ncbi.nlm.nih.gov/pubmed/37763370 http://dx.doi.org/10.3390/ma16186091

Ejemplares similares

Microstructural Improvement of Eutectic Al + Mg(2)Si Phases on Al–Zn–Si–Mg Cast Alloy with TiB(2) Particles Additions
por: Kim, Byungjoo, et al.
Publicado: (2021)

Formation of strength platform in cast Al–Si–Mg–Cu alloys
por: Dong, Xixi, et al.
Publicado: (2019)

Intermetallics Formation during Solidification of Al-Si-Cu-Mg Cast Alloys
por: Mohamed, Adel M. A., et al.
Publicado: (2022)

Effects of Solidification Cooling Rate on the Microstructure and Mechanical Properties of a Cast Al-Si-Cu-Mg-Ni Piston Alloy
por: Tian, Lusha, et al.
Publicado: (2018)

Synergistic Effects of La and Y on the Microstructure and Mechanical Properties of Cast Al-Si-Cu Alloys
por: Shuai, Luming, et al.
Publicado: (2022)

Effects of Trace Elements on the Microstructural and Machinability Characteristics of Al–Si–Cu–Mg Castings
por: Zedan, Yasser, et al.
Publicado: (2022)

Influence of the Ni/Co Mass Ratio on the Microstructure and Properties of Quaternary Cu-Ni-Co-Si Alloys
por: Li, Jiang, et al.
Publicado: (2019)

Microstructure Evolution and Mechanical Properties of Al–Cu–Mg Alloys with Si Addition
por: Shah, Abdul Wahid, et al.
Publicado: (2023)

Microstructural Characterization of the As-Cast and Homogenized Al-Cu-Mg-Ag Alloy
por: Lin, Haitao, et al.
Publicado: (2023)

Effects of Rapid Quenching on Grain Boundary Microstructure and Mechanical Properties of an Al-Mg-Si-Cu Alloy
por: Yan, Qiao, et al.
Publicado: (2023)

Microstructure, Precipitates Behavior, and Mechanical Properties of Age-Hardened Al-Mg-Si Alloy Sheet Fabricated by Twin-Roll Casting
por: Gao, Guanjun, et al.
Publicado: (2022)

Effects of Si Content and Ca Addition on Thermal Conductivity of As-Cast Mg–Si Alloys
por: Zhou, Xiong, et al.
Publicado: (2018)

Microstructure Evolution of AlSi10Mg(Cu) Alloy Related to Isothermal Exposure
por: Cai, Cheng, et al.
Publicado: (2018)

Effects of Co Addition on the Properties and Microstructure of Cu-Ni-Si-P-Mg Alloys
por: Cheng, Jianyi, et al.
Publicado: (2021)

Microstructure and Mechanical Properties of High Vacuum Die-Cast AlSiMgMn Alloys at as-Cast and T6-Treated Conditions
por: Liu, Fei, et al.
Publicado: (2019)

Effect of the Type of Inorganic Binder on the Microstructure and Properties of AlSi7Mg Alloy Castings Made by Ablation Casting Technology
por: Kamińska, Jadwiga, et al.
Publicado: (2022)

Effect of laser surface remelting on the microstructure and properties of Al-Al(2)Cu-Si ternary eutectic alloy
por: Ramakrishnan, Bhupendera Prashanth, et al.
Publicado: (2017)

Microstructure, Phase Formation and Heat-Treating of Novel Cast Al-Mg-Zn-Cu-Si Lightweight Complex Concentrated Aluminum Based Alloy
por: Chaskis, Spyridon, et al.
Publicado: (2022)

Microstructure and Mechanical Properties of Hypo- and Hypereutectic Cast Mg/Mg(2)Si Composites
por: Braszczyńska-Malik, Katarzyna N., et al.
Publicado: (2020)

Microstructure and Low-Cycle Fatigue Behavior of Al-9Si-4Cu-0.4Mg-0.3Sc Alloy with Different Casting States
por: Wang, Guanyi, et al.
Publicado: (2020)

The roles of Eu during the growth of eutectic Si in Al-Si alloys
por: Li, Jiehua, et al.
Publicado: (2015)

The Behaviour of Bifilm Defects in Cast Al-7Si-Mg Alloy
por: El-Sayed, Mahmoud Ahmed
Publicado: (2016)

A Novel Approach to Improve the Microstructure and Mechanical Properties of Al–Mg–Si Aluminum Alloys during Twin-Roll Casting
por: Li, Yong, et al.
Publicado: (2020)

Calculation Based on the Formation of Mg(2)Si and Its Effect on the Microstructure and Properties of Al–Si Alloys
por: Hao, Jianfei, et al.
Publicado: (2021)

Microstructure and Mechanical Properties of Cast Al-Si-Cu-Mg-Ni-Cr Alloys: Effects of Time and Temperature on Two-Stage Solution Treatment and Ageing
por: Xiao, Lairong, et al.
Publicado: (2023)

Mechanical Performance and Precipitation Behavior in Al-Si-Cu-Mg Cast Alloys: Effect of Prolonged Thermal Exposure
por: Abdelaziz, Mohamed H., et al.
Publicado: (2022)

Metallurgical Parameters Controlling the Eutectic Silicon Charateristics in Be-Treated Al-Si-Mg Alloys
por: Ibrahim, Mohamed F., et al.
Publicado: (2016)

Effects of the Mg/Si Ratio on Microstructure, Mechanical Properties, and Precipitation Behavior of Al–Mg–Si–1.0 wt %-Zn Alloys
por: Li, Yong, et al.
Publicado: (2018)

Research Progress on Multi-Component Alloying and Heat Treatment of High Strength and Toughness Al–Si–Cu–Mg Cast Aluminum Alloys
por: Zhang, Mingshan, et al.
Publicado: (2023)

Revealing heterogeneous nucleation of primary Si and eutectic Si by AlP in hypereutectic Al-Si alloys
por: Li, Jiehua, et al.
Publicado: (2016)

Effects of Cu/Er on Tensile Properties of Cast Al-Si Alloy at Low Temperature
por: Zhang, Huidi, et al.
Publicado: (2023)

Effect of Ni/Si Mass Ratio and Thermomechanical Treatment on the Microstructure and Properties of Cu-Ni-Si Alloys
por: Li, Jiang, et al.
Publicado: (2019)

The Influence of Ag on the Microstructure and Properties of Cu-Ni-Si Alloys
por: Krupińska, Beata, et al.
Publicado: (2020)

Effect of Al(2)Ca Addition and Heat Treatment on the Microstructure Modification and Tensile Properties of Hypo-Eutectic Al–Mg–Si Alloys
por: Shah, Abdul Wahid, et al.
Publicado: (2021)

Influence of Si, Cu, B, and Trace Alloying Elements on the Conductivity of the Al-Si-Cu Alloy
por: Yang, Zhao, et al.
Publicado: (2022)

Effects of Solidification Pressure and Heat Treatment on the Microstructure and Micro-Hardness of AlSi9CuMg Alloy
por: Wei, Lijun, et al.
Publicado: (2019)

Observation of Morphology Changes of Fine Eutectic Si Phase in Al-10%Si Cast Alloy during Heat Treatment by Synchrotron Radiation Nanotomography
por: Furuta, Shougo, et al.
Publicado: (2018)

Microstructures and Macrosegregation of Al–Zn–Mg–Cu Alloy Billet Prepared by Uniform Direct Chill Casting
por: Zhou, Li, et al.
Publicado: (2021)

Achievement of High Strength and Ductility in Al–Si–Cu–Mg Alloys by Intermediate Phase Optimization in As-Cast and Heat Treatment Conditions
por: Zhang, Bingrong, et al.
Publicado: (2020)

Selected Properties of a Zr-Containing AlSi5Cu2Mg Alloy Intended for Cylinder Head Castings
por: Bolibruchová, Dana, et al.
Publicado: (2022)

Cannot write session to /tmp/vufind_sessions/sess_stecd465jengholvckfrnfv39n