Cargando…

Microstructure Evolution of the Ti-46Al-8Nb-2.5V Alloy during Hot Compression and Subsequent Annealing at 900 °C

TiAl alloys are high-temperature structural materials with excellent comprehensive properties, and their ideal service temperature range is about 700–950 °C. High-Nb containing the Ti-46Al-8Nb-2.5V alloy was subjected to hot compression and subsequent annealing at 900 °C. During hot compression, wor...

Descripción completa

Detalles Bibliográficos
Autores principales:	Cao, Shouzhen, Li, Zongze, Pu, Jiafei, Han, Jianchao, Dong, Qi, Zhu, Mingdong
Formato:	Online Artículo Texto
Lenguaje:	English
Publicado:	MDPI 2023
Materias:	Article
Acceso en línea:	https://www.ncbi.nlm.nih.gov/pmc/articles/PMC10533025/ https://www.ncbi.nlm.nih.gov/pubmed/37763454 http://dx.doi.org/10.3390/ma16186176

Ejemplares similares

Quasi-In-Situ Analysis of As-Rolled Microstructure of Magnesium Alloys during Annealing and Subsequent Plastic Deformation
por: Deng, Jiafei, et al.
Publicado: (2022)

Effects of Nb on the Microstructure and Compressive Properties of an As-Cast Ni(44)Ti(44)Nb(12) Eutectic Alloy
por: Liu, Shifeng, et al.
Publicado: (2019)

Effect of Cold Drawing and Annealing in Thermomechanical Treatment Route on the Microstructure and Functional Properties of Superelastic Ti-Zr-Nb Alloy
por: Kudryashova, Anastasia, et al.
Publicado: (2023)

Low Temperature Phase Transformations in Copper-Quenched Ti-44.5Al-8Nb-2.5V Alloy
por: Cao, Shouzhen, et al.
Publicado: (2017)

Effect of Nb on the Microstructure, Mechanical Properties, Corrosion Behavior, and Cytotoxicity of Ti-Nb Alloys
por: Han, Mi-Kyung, et al.
Publicado: (2015)

The Effects of Hot-Pack Coating Materials on the Pack Rolling Process and Microstructural Characteristics during Ti-46Al-8Nb Sheet Fabrication
por: Huang, Haohong, et al.
Publicado: (2020)

The Influence of Severe Plastic Deformation and Subsequent Annealing on the Microstructure and Hardness of a Cu–Cr–Zr Alloy
por: Kapoor, Garima, et al.
Publicado: (2020)

The Relationship between Microstructure and Fracture Behavior of TiAl/Ti(2)AlNb SPDB Joint with High Temperature Titanium Alloy Interlayers
por: Liao, Minxing, et al.
Publicado: (2022)

Microstructure, Tensile, and Creep Behaviors of Ti-22Al-25Nb (at.%) Orthorhombic Alloy with Equiaxed Microstructure
por: Wang, Wei, et al.
Publicado: (2018)

Compression Behavior and Textures of Ti57-Nb43 Alloy at High Temperatures
por: Szűcs, Máté, et al.
Publicado: (2023)

Evolution of Microstructures and Mechanical Properties of Nb-V Alloyed Ultra-High Strength Hot Stamping Steel in Austenitizing Process
por: Liu, Shuang, et al.
Publicado: (2022)

Microstructure, Mechanical Properties and Oxidation Resistance of Nb-Si Based Ultrahigh-Temperature Alloys Prepared by Hot Press Sintering
por: Zhang, Lijing, et al.
Publicado: (2023)

The Influence of Annealing at 500 and 900 °C on the Structure and Mechanical Properties of Al(x)CoCrFeNi Alloys
por: Tokarewicz, Marzena, et al.
Publicado: (2023)

Mechanical Properties and Microstructural Evolution of TiNi-Based Intermetallic Alloy with Nb Addition
por: Yang, Hsin-Feng, et al.
Publicado: (2022)

Microstructure and Hydrogen Permeability of Nb-Ni-Ti-Zr-Co High Entropy Alloys
por: Kashkarov, Egor, et al.
Publicado: (2022)

Microstructural, Biomechanical, and In Vitro Studies of Ti-Nb-Zr Alloys Fabricated by Powder Metallurgy
por: Karakurt, Eyyup Murat, et al.
Publicado: (2023)

Microstructural Considerations of a Multi-Pass Rolled Ti-Nb-Ta-Zr Alloy
por: Răducanu, Doina, et al.
Publicado: (2023)

Discrepancies in the Microstructures of Annealed Cu–Zr Bulk Alloy and Cu–Zr Alloy Films
por: Sun, Haoliang, et al.
Publicado: (2019)

On the Effects of Hot Forging and Hot Rolling on the Microstructural Development and Mechanical Response of a Biocompatible Ti Alloy
por: Okazaki, Yoshimitsu
Publicado: (2012)

Enhanced Mechanical and Corrosion Properties via Annealing Treatment on the Hot-Rolled Ti-Zr-Mo Alloy
por: Yue, Yun, et al.
Publicado: (2023)

Effect of Surface Integrity on Hot Fatigue Life of Ti(2)AlNb Intermetallic Alloy
por: Wang, Yanju, et al.
Publicado: (2021)

Microstructural Study of a Mg–Zn–Zr Alloy Hot Compressed at a High Strain Rate
por: You, Jing, et al.
Publicado: (2020)

Microstructure Evolution in Cu-Ni-Co-Si-Cr Alloy During Hot Compression by Ce Addition
por: Ban, Yijie, et al.
Publicado: (2020)

Microstructural and Textural Investigation of an Mg-Zn-Al-Ca Alloy after Hot Plane Strain Compression
por: Kittner, Kristina, et al.
Publicado: (2022)

Phase Equilibria in the Nb-Rich Region of Al-Nb-Sn at 900 and 1200 °C
por: Papadimitriou, Ioannis, et al.
Publicado: (2019)

Effect of High-Pressure Torsion and Annealing on the Structure, Phase Composition, and Microhardness of the Ti-18Zr-15Nb (at. %) Alloy
por: Gunderov, Dmitry, et al.
Publicado: (2023)

Hot Deformation Behavior and Microstructural Evolution of a Novel β-Solidifying Ti–43Al–3Mn–2Nb–0.1Y Alloy
por: Wu, Qianqian, et al.
Publicado: (2019)

Microstructural Characterization of Melt Extracted High-Nb-Containing TiAl-Based Fiber
por: Zhang, Shuzhi, et al.
Publicado: (2017)

Effect of Annealing Temperature on the Microstructure and Mechanical Properties of CoCrFeNiNb(0.2)Mo(0.2) High Entropy Alloy
por: Fan, Rui, et al.
Publicado: (2023)

The Effects of Mo and Nb on the Microstructures and Properties of CrFeCoNi(Nb,Mo) Alloys
por: Tsau, Chun-Huei, et al.
Publicado: (2018)

An investigation of the mechanical and microstructural evolution of a TiNbZr alloy with varied ageing time
por: Biesiekierski, Arne, et al.
Publicado: (2018)

Crystal Structure Evolution, Microstructure Formation, and Properties of Mechanically Alloyed Ultrafine-Grained Ti-Zr-Nb Alloys at 36 ≤ Ti ≤ 70 (at. %)
por: Marczewski, Mateusz, et al.
Publicado: (2020)

Microstructural Evolution and Dynamic Softening Mechanisms of Al-Zn-Mg-Cu Alloy during Hot Compressive Deformation
por: Shi, Cangji, et al.
Publicado: (2014)

Influence of Heat Treatments on Microstructure and Mechanical Properties of Ti–26Nb Alloy Elaborated In Situ by Laser Additive Manufacturing with Ti and Nb Mixed Powder
por: Wei, Jing, et al.
Publicado: (2018)

Effect of Annealing on Microstructures and Hardening of Helium-Hydrogen-Implanted Sequentially Vanadium Alloys
por: Jiang, Shaoning, et al.
Publicado: (2018)

Microstructure and Texture Evolution of the Magnesium Alloy ZMX210 during Rolling and Annealing
por: Kurz, Gerrit, et al.
Publicado: (2023)

Different Effects of Annealing on Microstructure Evolution and SERS Performance for Cu–Cr Alloy Film and Bulk Alloy
por: Huang, Xiaoxue, et al.
Publicado: (2019)

Influence of Heat Treatment on Microstructure and Properties of NiTi46 Alloy Consolidated by Spark Plasma Sintering
por: Salvetr, Pavel, et al.
Publicado: (2019)

Influence of Annealing Treatment on Microstructure and Properties of Ni-Rich NiTi Alloy Coating Prepared by Laser Cladding
por: Feng, Yuqiang, et al.
Publicado: (2022)

Microstructure and Mechanical Properties of Ultrafine-Grained Copper by Accumulative Roll Bonding and Subsequent Annealing
por: Liu, Xueran, et al.
Publicado: (2020)

Cannot write session to /tmp/vufind_sessions/sess_dsj6n5m5g2tmt1m0glbio262th