Fabrication and Characterization of Cu(2+)-Driven PTFE-Reinforced Artificial Muscle Polymer Membrane for Water Purification and Energy Harvesting Applications

Ionic polymer membranes have not yet gained widespread practical application in areas such as water purification and energy harvesting due to their high cost and tendency to swell. The present study involved the fabrication of reinforced textile structures composed of polytetrafluoroethylene (PTFE)-reinforced Nafion membranes coated with non-precious metals, copper and silver, as a surface electrode by applying a chemical decomposition technique. Several mechanical, contact angle measurement and dielectric tests were conducted on membranes to evaluate their mechanical, wettability and conductivity properties. From scanning electron microscopy, it is clear that the formation of surface electrodes with uniform dispersion of metal particles. Scratch test reveals the adhesive strength between the coated metal particles and membrane. The silver-activated copper-coated membrane has a high contact angle of 121°. Thus, the fabricated membranes can have good antibacterial and adsorption properties for water treatment. The copper-coated membrane has a high Young’s modulus of 779 ± 80 MPa and a tensile strength of 29.1 ± 8 MPa, whereas the elongation at break is more for silver-activated copper-coated samples recorded as 158 ± 4%. The viscoelastic behavior of the membranes was analyzed through dynamic mechanical analysis (DMA). A sharp rise in the storage modulus (E′) value of 4.8 × 10(10) Pa at ~80 °C at a frequency of 1 Hz on metal surface electrodes signifies an improvement in the strength of the material in comparison to the initial pure membrane. The successful enhancement of conductivity on the membrane surface via chemical deposition on the silver-activated membrane is 1 × 10(−4) (S/cm) and holds great potential for facilitating voltage transmission through the tribolayer in the nanogenerators.