Calcium wastes as an additive for a low calcium fly ash geopolymer

A geopolymer is a low-carbon cement based on the utilization of waste ash in alkali-activated conditions. Coal fly ash is widely used as a source material for geopolymer synthesis since it contains a sufficient amount of reactive alumina and silica for geopolymerization. Geopolymer products are known to have beneficial fire resistance and mechanical properties. Class F or low-calcium fly ash (LCFA) is generally used as a primary aluminosilicate source; however, heat curing is required to complete the reaction and hardening process and achieve a strong composite. Furthermore, calcium additives are often required to improve the strength of LCFA geopolymers. This paper presents the potential of reusing calcium waste for this purpose. Three calcium wastes, namely calcium carbide residue (CCR), limestone waste, and waste cement (WC) slurry in powder form were used as additives and compared with the use of ordinary Portland cement (OPC). LCFA was replaced with the calcium additives at 20%. However, 20% CCR resulted in flash setting, hence 5% CCR was used instead. A durability test using 3% HCl solution was also performed. The results showed that the reactivity of calcium additives played an important role in strength development. In the calcium–aluminosilicate–alkali system, calcium silicate hydrate (CSH) and calcium aluminosilicate hydrate (CASH) were formed. The maximum strength of 21.9 MPa was obtained from the OPC/LCFA geopolymer, and 3% HCl solution had a deleterious effect on the strength. OPC and CCR were favorable reactive sources of calcium compounds to blend with LCFA. From the thermogravimetric results, lower thermal weight changes with higher strength gains were achieved. Low CaCO(3) decomposition at 750 °C according to the TGA curves indicated the more formation of thermally stable CSH and high compressive strength of Ca/LCFA geopolymers.