Preparation of Dispersed Copper(II) Oxide Nanosuspensions as Precursor for Femtosecond Reductive Laser Sintering by High-Energy Ball Milling

This contribution demonstrates and discusses the preparation of finely dispersed copper(II) oxide nanosuspensions as precursors for reductive laser sintering (RLS). Since the presence of agglomerates interferes with the various RLS sub-processes, fine dispersion is required, and oversized particles must be identified by a measurement methodology. Aside from the established method of scanning electron microscopy for imaging individual dried particles, this work applies the holistic and statistically more significant laser diffraction in combination with dynamic image analysis in wet dispersion. In addition to direct ultrasonic homogenization, high-energy ball milling is introduced for RLS, to produce stable nanosuspensions with a high fine fraction, and, above all, the absence of oversize particles. Whereas ultrasonic dispersion stagnates at particle sizes between 500 [Formula: see text] [Formula: see text] and 20 [Formula: see text] , even after 8 h, milled suspension contains a high proportion of finest particles with diameters below 100 [Formula: see text] [Formula: see text] , no agglomerates larger than 1 [Formula: see text] and a trimodal particle size distribution with the median at 50 [Formula: see text] [Formula: see text] already, after 100 [Formula: see text] of milling. The precursor layers produced by doctor blade coating are examined for their quality by laser scanning microscopy. The surface roughness of such a dry film can be reduced from 1.26 [Formula: see text] to 88 [Formula: see text] [Formula: see text] by milling. Finally, the novel precursor is used for femtosecond RLS, to produce homogeneous, high-quality copper layers with a sheet resistance of [Formula: see text] [Formula: see text] /sq and a copper mass concentration of 94.2%.