Laboratory Analysis of Causative Factors for the Final Incision Size due to Intraocular Lens Injector Insertion

PURPOSE: In intraocular lens (IOL) implantation, insertion of the IOL injector enlarges the clear corneal incision. A larger incision size (IS) is associated with a higher risk for surgically induced astigmatism and endophthalmitis. The goal of this study was to determine which parameters most influence the final IS. DESIGN: Experimental study. SUBJECTS: A total of 126 cadaver porcine eyes were included in this study. METHODS: We analyzed 409 clear corneal incisions made with 126 injectors from 13 injector models. We noted the vertical diameter and the tip angulation for every model. The corneal thickness of each incision location was measured using Scheimpflug tomography. The IS was measured before and after injector insertion and described as preoperative and final ISs, respectively. During surgery, the insertion depth and incision length were documented. A mixed effects model was applied to analyze the influence of the parameters on the final IS. MAIN OUTCOME MEASURES: Influence on the final IS. RESULTS: Increases in the vertical diameter of the injector tip, the preoperative IS and the insertion depth, and a reduction of incision length were all significantly associated with increased final IS (P < 0.05). The conditional Pseudo-R(2)-Measure was 0.92. The preoperative IS had the largest standardized estimated effect on the final IS, followed by the vertical diameter of the injector tip, insertion depth, and lastly, incision length. Neither corneal thickness nor the tip angle of the injector had a significant effect on the final IS (P > 0.05). CONCLUSIONS: The IOL injector’s vertical diameter should be as small as possible to ensure a minimal final IS. The injector’s insertion depth may be minimized, and the incision length should be long enough to reduce the final IS. Further studies are needed to confirm the findings in human autopsy eyes and in clinical practice. FINANCIAL DISCLOSURE(S): Proprietary or commercial disclosure may be found after the references in the Footnotes and Disclosures at the end of this article..